Self Help Guide
®
IMPORTANT!
Pro 2 KVM Firmware Update Instructions
This Guide refers to the
following Products:
Please read the following carefully;
Synopsis:
This guide will assist you in updating the firmware
of your Belkin OmniView Pro 2 KVM Switch.
Please be advised that firmware updates tend to
be to resolve specific issues and if there is any
doubt if the firmware will resolve your issue you
should check with Technical Support.
F1DA104T
PS/2 & USB
Requirements:
F1DA108T
PS/2 & USB
To perform the Firmware Upgrade successfully
you will need the following equipment;
• Pro 2 KVM
• 12 V DC 1A KVM Power Supply (supplied)
• RJ45-DB25 Flash Update Cable (supplied)
• PC with Windows 2000 or XP and Parallel Port
• Firmware Update File
F1DA116T
PS/2 & USB
• NTPDA Update
You will also need to ensure that any Firewall or
Anti-Virus Software is disabled on the Computer
you will be using to upgrade the Firmware from.
TSG-UK-2-001
Downlo|ad from Www.Somanuals.com. All Manuals Search And Download.
www.belkin.com
|
Page1of4
Self Help Guide
®
Step 3
Plug the supplied Firmware Update Cable in to the (DB25) Parallel Port of a stand-alone
Text
Computer (i.e. one that is not currently connected to and controlled by the KVM) and
connect the other end of the Cable into the (RJ45) Firmware Upgrade Port of the KVM.
Step 4
Now that everything is setup the KVM can be flash upgraded. Double click the Icon of
the Firmware Update File that you downloaded.
Once open, click on the
button in the KVM Firmware Update Window.
Should you receive the following Error Message then it means that the data cannot be
sent to the KVM in order to Flash Update it.
To resolve this click ‘OK’ and ‘OK’ again. Unplug Power from the KVM, then unplug the
Flash Update Cable. Wait 10 seconds. Now plug the Flash Update Cable in first,
followed by the Power Cable. Repeat Step 4.
TSG-UK-2-001
Downlo|ad from Www.Somanuals.com. All Manuals Search And Download.
www.belkin.com
|
Page3of4
Self Help Guide
®
Step 5
Providing the Flash Upgrade is being performed successfully, you should see a
Text
Window with a Progress Bar similar to that shown below.
Step 6
Once the Firmware Upgrade has been successfully completed an extra Window will
appear with a message to this effect. Simply close this Window.
Next, unplug both the Flash Update Cable from both KVM and the Computer, followed
by the power cable to the KVM.
The Dip Switches should then be returned to their original setting – all Dip Switches
set (up) to the ‘Off’ position.
The KVM can now be powered back on by connecting the Power cable back to the
Power Jack.
The Unit should beep once to indicate power has been added. Once successfully
powered any Computers can be re-connected to the KVM.
N.B.
Should the unit emit a persistent beep after the Flash Update process then it is
indicating that the Firmware has been in some way corrupted. The unit should be re-
flashed using an original Firmware on the same Dip-Switch setting as was last used.
TSG-UK-2-001
Downlo|ad from Www.Somanuals.com. All Manuals Search And Download.
www.belkin.com
|
Page4of4
|