Grizzly Router C1407 User Manual

INSTRUCTIONS FOR  
MODELS C1407, C1408, C1409, C1410 AND C1411  
3" PANEL ROUTER BITS WITH UNDERCUTTER  
•Failure to follow theSE guide-  
lines will result in serious  
personal injury.  
•ALWAYS  
WEAR  
ANSI  
These router bits have sharp  
edges. Use care while removing  
the waxy protective coating. Never  
turn on the router with the protec-  
tive coating still on the bit.  
APPROVED EYE AND EAR  
PROTECTION WHEN USING  
THIS router bit.  
•These router bits should only  
be used on a router table,  
never in a handheld router.  
•Never feed lumber with the  
rotation of the bit.  
•Follow the safety guidelines  
set forth by the manufacturer  
of the router.  
These panel bits can be used with 58" - 34" stock. The undercutter enables the  
1
cutting of the panel section of the door in one single pass. The cutter is designed to produce a 4" thick  
tongue which can float in a 516" wide by 38" deep groove in the door frame. This provides an approximate  
1" to 118" reveal for the door panel edge. If the door frame is being made with a standard stile and rail bit,  
many of these are designed with a 14" wide groove.  
• Unplug  
router  
before  
installing or adjusting cutter.  
• Keep all guards and anti-kick-  
back devices in place.  
Router Table  
• Double check bit to insure screw  
is tight and bit is tightly  
secured in spindle.  
• Always inspect lumber and other  
wood materials for cracks,  
knots, or other imperfections  
that could cause lumber to kick  
or shatter while milling.  
The panel can be produced so that it finishes flush with the stile and rail  
assembly or so that the panel is “raised”. This is accomplished by raising or  
lowering the bit so that the tongue of the finished panel moves up or down. In the illustration above, note  
that the face of the panel is in the down position. If the bit is moved down, the panel will mount proud of  
the stile and rail. If moved up, the panel will finish closer to flush. Use scrap lumber to make a cuts until  
you have produced your desired height.  
Shown below are other profiles that can be produced using router bits from Grizzly Industrial, Inc.  
© MAY 2003 Grizzly Industrial, Inc.  
526203622  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Greenheck Fan Smoke Alarm FSD 211 User Manual
Grundig CRT Television LXW 68 9620 User Manual
Harman Stove Company Range SF 150 SF 250 User Manual
Heath Zenith Indoor Furnishings 598 1306 02 User Manual
Honeywell Portable Generator 6065 User Manual
Hotpoint Cooktop BE11 User Manual
HP Hewlett Packard Digital Camera M307xi User Manual
HP Hewlett Packard Personal Computer 6005 User Manual
HP Hewlett Packard Personal Computer DX2200 User Manual
Hunter Fan Outdoor Ceiling Fan 44270 User Manual