IMI CORNELIUS INC g One Cornelius Place g Anoka, MN 55303-6234
Telephone (800) 238-3600 Facsimile (612) 422-3246
“K” STYLE LID KIT, P/N 630000085
These “K” style kits apply to the following ice makers and are for use with ED/DF 150 dispensers:
Ice Maker
Size
Wilshire WCC500/700
14 1/2”
Wide
Table 1. Loos e-Shipped Parts
Name
Item
No.
Part No.
Qty.
1
1
2
3
4
5
6
7
8
9
620030602
15303
Lid Assembly,
Bracket
1
50904
RTV, Clear, 732, 3 oz. Tube
#8 Sheet Metal Screw
1
70217
6
91957
Label, Disconnect Before Cleaning
Thumb Screw #8-32 ¢ 1/2I
Installation Instruction
1
70188
1
620911301
22127
1
Bracket, Mounting
1
620030601
Cover, RH Assembly
1
1. Set Ice maker lid on the top of the dispenser and position it flush with the back and sides of the dispenser.
2. Using the slotted holes in the lid as a template, drill four (4) .140I diameter holes at the bottom of the slots
(see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8
sheet metal screws, two on each side.
3. Seal the ice maker to the top of the dispenser as follows: (Flush with rear and left side)
A. Apply beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away any excess RTV.
4. Remove the left rear screw (only) installed in step 2. Use that screw to install the mounting bracket (item 2
and install Item 9 to rear of dispenser and ice maker. Drill 9/64I diameter holes into the ice maker cabinet
using the bracket as a template. Use extreme caution not to drill into any ice maker components (condens-
er, tubing, etc.). Secure the brackets using the screws provided.
5. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the
bin thermostat if so equipped or required.
June, 1998
Rev A
620911301
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|