INSTRUCTIONS FOR 2785M SPEED RING
For use with the Canon EZ and EX Series and Nikon SB Series flash units.
This Speed Ring is used to mount two of the Canon EZ or EX or Nikon SB flash heads
for use in a single Lightbank. Note: You will also need a multi-flash cord to connect the flash
units together and an off-camera TTL cord to connect the flashes to your camera (purchase from
your flash dealer).
Instructions:
1. Rotate the heads of both flash units to a forward facing position.
2. Mount one flash unit on a cold shoe with the lens of the flash facing into the Speed Ring.
If your multi-flash cord has a hot shoe connector, use it in place of the cold shoe.
3. Using the Enclosed thumbscrew, attach the off-camera TTL cord to the other side of the
mounting bracket.
4. Mount the second flash unit to the shoe of the TTL cord again with the flash facing into
the Speed Ring.
5. Connect the two flash units together with the multi-flash cord.
6. Using the attached stand adapter, mount the completed assembly on a light stand.
7. Attach the Lightbank to the side of the Speed Ring opposite the flash units.
8. Connect the loose end of the TTL cord to the camera sync.
Parts List:
1
1
1
1
1
1
1
1
20601000
27852000
26105100
38651000
27854000
38506000
27853000
38505000
7.5” (19cm) Diameter Speed Ring
Mounting Bracket
¼-20 x ½ Thumbscrew
Dual Axis Stand Adapter
Rubber Pad
Star Washer
Cold Shoe (Kaiser 1211)
¼-20 x 5/8 Hex Bolt
CHIMERA® 1812 VALTEC LANE BOULDER, COLORADO 80301 USA
TOLL FREE 888-444-1812
PHONE 303-444-8000
FAX 303-444-8303
EMAIL: [email protected]
WEB SITE: www.chimeralighting.com
Download from Www.Somanuals.com. All Manuals Search And Download.
|