Channel Vision Stereo System AB 114 User Manual

2
s i e d r 1 e 2 v / 0  
O I N S I V E L A N N C 2 H 0 0 2 ©  
M T  
Pre-Installation:  
Speaker Connections:  
A-BUS by CHANNEL VISION:  
The output terminals of the AB-114 accepts both 16/2  
and 16/4 speaker wires.  
Before connecting the AB-114, confirm the following:  
System Overview  
Featuring A-BUS technology, Channel Vision’s new-  
est multi-room audio distribution system offers simple  
CAT-5 (8 conductor) wiring, IR routing, and remote  
The power supply is not connected to the AB-114.  
The status power supply is not connected.  
The lengths of the CAT-5 wires connecting the AB-  
114 and AB-404 modules do not exceed 1000 ft.  
(For longer runs over 1000 ft., use multiple AB-404  
modules in a cascaded system.  
Status:  
t e o  
A - B U S R e m A B T 2 4 5 4 , a n d  
control capability. The A-BUS system consists of four  
modular components:  
The AB-202 is factory shipped with the status port auto-  
matically set to power down the AB-114 when using an  
auto sensed source. This will preserve the life of the  
AB-114 volume control as well as conserve energy. A  
12-volt power supply (e.g. model 5018) can be plugged  
into the status port of the AB-202 only if the source is  
not auto sensed. The AB-202 does not need to be  
A B 1 - 4 2 , 0 2 , A A B B - 1 - 3 0 1 , A B - 4 0 4  
t s n : o n p e m o C m s t e S S y B - U A  
AB-114 Amplified Keypad  
- Provides audio amplification to in-room speakers  
- Features IR receiver for control of external equip-  
ment, backlit keypad and visual LED indicators for  
IR, status, and volume level confirmation, volume  
potentiometers for setting maximum volume level  
and adjusting left/right balance  
Once all connections have been checked, the power  
supplies may now be connected to the modules.  
CAT-5 Connectivity:  
b y  
Use a CAT-5 minimum to connect the AB-202 Single  
Source Distribution Module’s RJ-45 outputs to the  
RJ-45 wallplate (optional). You may also connect the  
AB-202 directly to the AB-404 Distribution Module.  
The AB-404 then snaps-in conveniently into any  
Channel Vision Central structured wiring panels of  
your choice (C-0112, C-0119, C-0138, or C-0150).  
Operation:  
The AB-114 can be powered on/off and volume can be  
controlled using the buttons on the unit.  
- Single gang box Decora® faceplate installation  
- Operable via remote control or local push button  
- Input Impedance:  
- Power Requirements: +24VDC, 750mA  
- Status Input Reqs: +12VDC, 20mA  
- CAT-5 Connection: 110 punchdown  
- In-Wall Dimensions: 1.75”W x 2.875”H x 1.75”D  
- Weight:  
28k Ohm minimum line input  
If IR emitters have been installed as a part of your A-BUS  
system, you may operate sources with their own remote  
control (or a universal remote) by aiming it at the IR  
window on the AB-114.  
Punch down the CAT-5 pairs into the AB-404’s 110  
connector inputs using a 110 punch down tool (e.g.  
model J-110-Tool). Using the same tool, punch down  
the four 110 connector outputs to the 110 connectors  
on the back of each AB-114 being installed. The  
connectors are color-coded for your convenience.  
(See diagram on the other side.)  
6 ounces  
Limited Warranty  
AB-202 Single Source Distribution Module  
- Provides single CAT-5 output audio distribution  
- Features four IR emitter outputs and routing for  
control of external equipment  
- Status Input Reqs:  
- Case Size:  
The AB-114’s LED display will flash red to indicate it  
has received infrared signals from the remote control.  
Channel Vision Technology will repair or replace any defect in  
material or workmanship which occur during normal use of this  
product with new or rebuilt parts, free of charge in the USA, for two  
years from the date of original purchase. This is a no hassle warranty  
with no mail in warranty card needed. This warranty does not cover  
damages in shipment, failures caused by other products not supplied by  
Channel Vision Technology, or failures due to accident, misuse, abuse,  
or alteration of the equipment. This warranty is extend only to the  
original purchaser, and a purchase receipt, invoice, or other proof of  
original purchase date will be required before warranty repairs are  
provided. Mail in service can be obtained during the warranty period  
by calling (800) 840-0288 toll free. A Return Authorization number  
must be obtained in advance and be marked on the outside of the  
shipping carton. This warranty gives you specific legal rights, and you  
may have other rights (which vary from state to state). If a problem  
with this product develops during, or after, the warranty period, please  
contact Channel Vision, your dealer, or any factory-authorized service  
center.  
Local Source:  
If you need to connect a local audio source to the A-BUS  
system, use the AB-301 to connect the source to the  
closest AB-114 installed.  
+12VDC  
5.2”W x 2.4”H x 1.18”D  
Note: The AB-404 is expandable by connecting its  
110 connector output to another AB-404 module (see  
diagram). However, each module must be powered  
individually. The AB-404 can be placed at any  
AB-301 Local Input Module (Optional)  
- Provides input of an audio source local to the zone  
AB-404 Panel Distribution Module  
Mounting:  
- Distributes power, status, and IR to up to four zones  
- Features an output connector for system expansion &  
simple 110 punch down connection for easy install  
- Power Requirements: +24VDC, 2Amin – 3.2A max  
Check all wire connections and test the system perform-  
ance before installing the AB-114 into a standard UL/  
CSA approved electrical J-Box.  
Volume Trim Potentiometer:  
Two trim potentiometers (“trim pots”) are located on  
the back of the AB-114. Using a small Phillips-head  
screwdriver, these trim pots may be manipulated to set  
the maximum volume level desired and to adjust the  
left /right balance.  
Other components:  
Remote:  
An A-BUS remote may be used to adjust volume and  
switch sources by aiming it at an AB-114 keypad.  
ABT2454 24VDC Power Supply  
- Provides power (3.2A) for the A-BUS system  
-Features mini-din plug for easy connection  
- UL, CE, and TUV approved  
234 Fischer Ave., Costa Mesa, CA 92626  
(800) 840-0288 (714) 424-6500 (714) 424-6510 fax  
WARNING: Before any installation, please read the instructions that accompany each component in your system.  
If you are unsure about any of the procedures, please consult a professional installer.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Black Decker Convection Oven CTO9000 User Manual
Black Decker Lawn Mower 90541667 User Manual
Bosch Appliances Water Heater GWH 1000 User Manual
Boss Audio Systems Car Video System BV7335B User Manual
Bostitch Saw BTE300K User Manual
Boston Acoustics Speaker System Horizon i DS2 User Manual
Bowers Wilkins Speaker ASW2000 User Manual
Cambridge Audio MP3 Player 640Hazur User Manual
Chauvet Scanner Q Roll 150 User Manual
Chevrolet Automobile 2010 Impala User Manual