T52WA
15’’ Wide-Screen LCD Monitor
User Manual
3. Adjusting your monitor
Functions of the buttons and indicator
Item
Function
Enter OSD menu, select item, enter submenu, and confirm recall.
1. Positive adjustment, change within several selections.
Enter
X
2. Hot key of "Brightness".
1. Minus adjustment, change within several selections.
W
2. Hot key of "Contrast".
Leave menu, cancel recall. (Settings will be saved automatically after
adjustments are made.)
Exit
Hot key of auto adjustment (for geometric settings only).
Auto
OSD icon list
Icon
Function
Description
Auto Adjust
* Optimize the picture performance automatically
Luminance
Geometry
Color
* Select "Brightness" and "Contrast" adjustment submenu
* Select "H. Position", "V. Position", "Pixel Clock" and "Phase"
adjustment submenu
* Select color temperature or to set up user mode
* Adjust the position and time of OSD menu on the screen
* Select your own preference of language of OSD menu
* Reset monitor parameters back to factory preset value
* Select "Miscellaneous" adjustment submenu
* Adjust the luminance of the screen
OSD
Language
Recall
Miscellaneous
Brightness
Contrast
H. Position
* Adjust the contrast level of the screen
* Shift the screen left or right
Adjusting your monitor
5
V. Position
Pixel Clock
Phase
* Shift the screen up or down
* Adjust the monitor internal sampling clock rate
* Adjust the monitor internal signal phase
OSD H. Position * Shift the OSD left or right
OSD V. Position
OSD Time
Sharpness
DDC/CI
* Shift the OSD up or down
* Set OSD display duration time
* Adjust the sharp level of the screen
* Switch "DDC/CI" On or Off
* Show the display information
Information
6
Adjusting your monitor
4. Troubleshooting
Symptom
Remedy
*Blank Screen*
Power indicator is off
• Make sure the power cable is connected properly (see
• Make sure that the monitor was turned on using the
power switch (see To connect the monitor to your PC
Power indicator lights orange
Power indicator lights green
• Perhaps a power saving mode is active? Press any key
on your keyboard or move the mouse.
• A screen saver may have activated automatically after a
certain period of inactivity. Press any key on your key-
board or move the mouse.
"No Signal Detected!" message
• Is the signal cable connected to the monitor and the
• Is the PC turned on (see your PC's documentation)?
*Display Problems*
Image is displaced to the left/right
or to the top/bottom
• If the image appears normal but off-center, you can
adjust it using the OSD functions. For further informa-
Image is blurred
• Check brightness and contrast settings (see "Lumi-
• Check the sharpness setting (see "Sharpness" in the
OSD icon list section).
Color problems
• If the colors are off (e.g., white is not really displayed as
white etc.), you should adjust the color temperature
Troubleshooting
7
5. Specifications
15’’ Wide-Screen LCD monitor
Item
T52WA
Display Size
Pixel Pitch
332.16 (H) x 186.84 (V) mm
0.2595 (H) x 0.2595 (V) mm
Panel
Monitor
Display Colors
16.7M colors
Horizontal: 31 - 64 KHz
Input Signal
Frequency
Vertical: 59 - 75 Hz
D-sub 15 pin
-5° - 20°
Connector
Tilt
Analog
Tilt Angle
Dimensions
Net
370.3(W) x 330.4(H) x 137.1(D) mm
(W x H x D)
Weight
Net
< 4 kg
AC
AC 100-240V, 50 Hz / 60 Hz
Active: < 21W / Standby: < 2W
Power
Consumption
8
Specifications
|