setting up your wall switch
installing your wall switch
Set the House Code
dial to the same letter
that you set on your
Controller.
Turn the power off at the circuit breaker
61-3005
panel.
home automation
wall switch
Remove your wall plate and unscrew
the existing switch from its box.
Set the Unit Code
Disconnect the wiring from your
existing switch, and connect the two
wires on your new switch using the
wire nuts provided.
dial to an unused code.
Turn the ON/OFF
switch beneath the
push button to ON
(center position).
Wall Switch
Wire nuts
Replace the wall plate
on your wall box.
Push
button
ON/OFF
Wires
operating your wall switch
Turn the power back on at the circuit
breaker panel.
Screws
Push the button to turn your wall switch
on or off.
Be sure no loose wires are protruding;
use insulating tape (not provided) to
cover the wire nuts, if necessary.
Thank you for purchasing the RadioShack Home
Automation Wall Switch. Your Wall Switch is
designed to control incandescent lights only,
with rating between 40W and 500W. It replaces
your existing switch, and controls both indoor
and outdoor ceiling lights. A push button is
provided for local on/off control.
Note
When replacing a light bulb, turn
your wall switch to OFF
(left position).
Note
Screw the switch into its wall box.
Wall switches must not be used to
control appliances, low voltage lamps
Warning
WARNING: To reduce the risk of fire or shock hazard, do not expose this
product to rain or moisture.
or fluorescent lamps!
what’s included
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
2 screws
2 wire nuts
user’s guide
Please read this User’s Guide before
installing, setting up, and using your new product.
wall switch
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
This symbol is intended to alert you to the presence of
uninsulated dangerous voltage within the product’s enclosure
that might be of sufficient magnitude to constitute a risk of
electric shock. Do not open the product’s case.
This symbol is intended to inform you that important
operating and maintenance instructions are included in the
literature accompanying this product.
©2004. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com are
trademarks used by RadioShack Corporation.
61-3005
06A04
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|