R
Custom Installation Series
T
E
C
H
N
O
L
O
G
Y
Owners Manual / Installation Instructions
CI-1.5
Speaker seismic
restraint hole
SpeedWing™ mounting arms
Baffle
Installation aid/paint mask
Grille safety clip
Grille
Box contents
1 Speaker
1 Grille
1 Paint mask
1 Hole template
1 Euroblock connector
MSE Audio Group
8650 College Boulevard
Overland Park, Kansas 66210
(866) 663-9770
Download from Www.Somanuals.com. All Manuals Search And Download.
R
Installation Instructions: Installing the CI-1.5
Using Optional Pre-Construction Bracket
T
E
C
H
N
O
L
O
G
Y
1. Nail or screw bracket to
joists.
2. Finish installing ceiling.
3. Use RotoZip or other tool 4. Unpack speaker. Leave
to cut hole.
paint mask in place until
after speaker is installed or
painting is complete.
5. Connect euroblock to
speaker wires, and connect
to speakers.
6. If required, attach
7. Insert speaker into
8. Remove paint mask
seismic restraint system to
the sheet-metal tab on the
rear panel of the speaker,
then to reinforced structure
(safety cable not included).
mounting hole. Tighten both unless painting is required.
screws on the baffle face to In that case, follow steps
actuate the mounting wings. 9-12 when painting is
DO NOT OVERTIGHTEN.
complete.
1.
2.
12. Done!
9. Adjust tap switch to
proper setting. Switch is
preset to the 8-ohm mode.
10. Attach grille safety clip
by placing the large end of
the clip over snap-fit post (1), gently press grille into place.
then sliding clip until small
11. Align tabs on snap-fit
grille with slots in baffle,
end snaps into place around
post (2).
Download from Www.Somanuals.com. All Manuals Search And Download.
|