Step 2:
Step 3:
Step 1:
Connect one end of the blue
Ethernet cable to your modem,
and the other end to the Internet port
on your router.
Plug in, then turn on your modem.
Unplug the power
to turn off your modem.
Installation Guide
Wait approximately 2 minutes
until your modem turns on.
N300 Wireless Gigabit Router
JNR3000
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
Package Contents:
DSL
or Cable
(not included)
Internet
Ethernet cable
N300 Wireless
Gigabit Router
Modem
N300 Wireless Gigabit Router
Step 6:
Step 5:
Step 4:
Connect the router
to your computer.
Connect the power adapter to the
router, then plug it into an outlet.
Wait until the wireless LED turns
solid green.
Open a browser.
If the Web page does not display,
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
close and re-open the browser
and enter http://routerlogin.net
in the address bar, or check the
“Troubleshooting” section in
the User Guide.
Power adapter
Ethernet cable
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
Download from Www.Somanuals.com. All Manuals Search And Download.
|