21” Arm Pad for Walker Platform Attachment  
					Assembly, Installation and Operating Instructions  
					Model Nos. 1073913  
					SAVE THESE INSTRUCTIONS  
					NOTE: Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact  
					carrier/dealer for further instruction.  
					Arm pads installed on the Walker Platform Attachment model 6027 may not be suitable  
					for all arm sizes. Invacare recommends replacing the existing 17” semi‐adjustable arm  
					pad with the 21” fully adjustable arm pad.  
					Safety Summary  
					To ensure the safe and proper installation of the walker platform attachment, these  
					instructions MUST be followed:  
					ꢀ WARNING  
					DO NOT install this equipment without first reading and understanding this instruction  
					sheet. If you are unable to understand the warnings, cautions and instructions, contact a  
					healthcare professional, dealer or technical personnel if applicable, before attempting  
					to install this equipment - otherwise, injury or damage may occur.  
					Ensure that ALL attaching hardware is secure.  
					Invacare products are specifically designed and manufactured for use in conjunction  
					with Invacare accessories. Accessories designed by other manufacturers have not  
					been tested by Invacare and are not recommended for use with Invacare products.  
					ꢀ INSTALLATION WARNING  
					After ANY adjustments, repair or service and BEFORE use, make sure that all  
					attaching component parts are secure.  
					Installing the Arm Pad and Strap  
					NOTE: For this procedure, refer to FIGURE 1.  
					1. Remove arm pad and cover.  
					NOTE: Note the orientation of the existing arm  
					Slots  
					strap for installation of the new arm strap.  
					Fastening  
					Strap  
					2. Pull on ring and remove fastening strap  
					Arm  
					Support  
					through the slots in the arm support.  
					3. Thread the end without the ring of the  
					new arm strap through slots in the arm  
					support.  
					Ring  
					NOTE: Make sure the hook end is facing down  
					or the arm strap will not secure properly.  
					4. Slide the arm pad and cover over the arm  
					support.  
					NOTE: Arm pad removed for clarity.  
					FIGURE 1 Installing the Arm Pad and Strap  
					For more information regarding Invacare products, parts, and services,  
					
					Part No 1143248  
					1
					
					Download from Www.Somanuals.com. All Manuals Search And Download.