Quick Installation Guide
Version 1.0
P0715
7" Compact Intel Low Voltage
PIII / Celeron Panel PC
Download from Www.Somanuals.com. All Manuals Search And Download.
Warning
Panel PC and their components contain very delicate Integrated Circuits
(IC). To protect the Panel PC and its components against damage from
static electricity, you should always follow the following precautions
when handling it :
1. Disconnect your Panel PC from the power source when you want to work on
the inside
2. Hold the board by the edges and try not to touch the IC chips, leads or
circuitry
3. Use a grounded wrist strap when handling computer components.
4. Place components on a grounded antistatic pad or on the bag that came with
the Single Board Computer, whenever components are separated from the
system
5. It possibly needs BIOS support in the case of using special backplane,
otherwise, it might be not able to function completely.
6. Please make sure the power connector is tightly plugged into the power
socket before power on.
3
3
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Getting Started
This section will help you have your P0715 up and running
smoothly.
PACKING LIST
P0715
9 x Screws
1 x Arm Holder Bracket
2 x Wall Mount Bracket
1 x Adaptor
2 x Power Cord (American & French Cordset)
1 x Driver CD
Before up and running, please make sure the package contains
all of above accessories.
If any of the above items is damaged or missing, contact your
vendor immediately.
4
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Specification
Model Name
System
Panel PC P0715
Intel Low Voltage Celeron 400~733MHz CPU
FSB100/133MHz
CPU
Cache
2nd Level 256K
Memory
1 x 144Pin SO-DIMM up to 512MB SDRAM
SMI722 G8 Lynx 3D+ engine 8MB Video RAM on chip
Intel 815E + Intel CH2
VRAM
Chipset
ATA / IDE
Ultra DMA 33, support 2 IDE device
Realtek ALC202A AC97 Codec, support Line-out
127-level Reset
Audio
Watchdog Timer
System Fan
Serial Port
USB Port
1 x 4cm x 4cm / 8 CFM
2 x RS-232 ports (COM1/2)
2 x USB 1.1 compliant
1 x PS2 K/B and 1 x Mouse
1 x speak out
KB / MS
I/O
Speaker
LAN
RJ45
Size / Type
Max. Resolution
Pixel Pitch
Touch Screen
Viewing Angle
Luminance (cd/m2)
Back Light MTBF
HDD / Type
Flash Disk
Output rating
Input voltage
Operating Temp.
Storage Humidity
Vibration
7" TFT Color LCD
800 x 480, SVGA
0.3075mm x 0.3075mm
7" 4Wire Resistive (USB Interface)
160° (V), 160° (H)
LCD Display
300
50,000 hours
1 x built-in 2.5" vibration Resistant HDD bay
1 x Type II Compact Flash Disk Socket (Internal)
63W
Storage
Power Supply
DC 12V Input
0°C ~ 50°C
5% ~ 95%, non condensing
17~500 Hz, 1G PTP
Mechanical &
Environmental
Shock
10G/peak (11m sec)
Construction
Weight
Heavy-duty steel & Aluminum (Front bezel)
1.9kg (4.18 lb)
Dimension (L x H x D) 227 x 158 x 76mm
5
5
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting
Arm Mounting
Hook Mounting
6
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Dimension
Unit: mm
7
7
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
OSD of Front Panel
8
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Location of I/O Ports
Before starting to install software on your new Panel PC please spend some
time to find out the exact location of connectors and HDD (if pre-installed). The
front panel does not contain any indicators, switches, connectors or drive
access. All these are to be found on the left and right side and on the rear of the
system.
Default I/O
9
P0715 Quick Installation
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Connecting Peripherals
The user can use the I/O interfaces located at the backside of the chassis to
connect external peripheral devices, such as a mouse, a keyboard, a monitor,
serial devices or parallel printer etc. Before connection, make sure that the
computer and the peripheral devices are turned off.
Connecting an external CRT
P0715 has a 15-pin analog RGB interface connec-
tor located at the rear side of the chassis. As to
resolution, P0715 otputs 800 x 480 instead of 800
x 600, it won't display completely at first when
you connect the monitor.
External Serial Ports (COM1/2)
The P0715 logic board supports four onboard serial ports, all COM ports
supports RS-232.
The external COM1, COM2 are all D-SUB 9-pin
connectors. To connect any serial device, follow
the following instructions:
1. Turn off the Panel PC system and the serial
devices.
2. Attach the interface cable of the serial device to the 9-pin D-SUB serial
connector. Be sure to fasten the retaining screws.
3. Turn on the computer and the attached serial devices.
4. Refer to the serial device's manual for instruction to configure the operation
environment to recognize the new attached devices.
5. If the serial device needs specified IRQ or address, you may need to run the
CMOS setup to change the hardware device setup.
Speaker Jack
P0715 has one speaker jack.
10
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
LAN Port
P0715 provides one Intel 82562ET 100/10 Base-T
Ethernet (RJ-45) interface.
For network connection, follow the instructions
below;
1. Turn off the Panel PC system and the Ethernet hubs.
2. Plug in one end of cable of a 100/10 Base-T hub to the system's RJ-45 jack.
USB Ports
P0715 provides four external USB ports to connect
to external USB devices. USB ports and devices
are hotplug capable. Therefore any USB device can
be connected at all time without the need to power
down your system. Note that for many of these
devices you will first have to install proper device drivers before they can be
recognized by the system
PS/2 Keyboard/Mouse
P0715 provides two standard PS/2 keyboard/
mouse connectors located at the rear panel. If the
user would like to use AT keyboard, then an
adapter to connect the PS/2 KB to AT KB is
needed.
DC Power Input and Power Switch
One end of the power cable is fitted with a
standard power connector that connects to 4-pin
DC-In Jack.
To connect the system to power, follow the
following instructions :
1
2
3
4
Make the system power switched off.
Plug the circular connector firmly into the circular socket on the rear panel.
Connect the standard male plug to an electrical outlet.
For operation, power up the system.
11
11
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Hardware Installation
HDD installation
1. On the back of P0715, locate the screws that secure the
rear case.
Use screw driver to remove the screws. Keep the screws
safely for later use.
Pull the baffle slightly upward the main unit until it is disen-
gaged from main unit.
2. Put the HDD into the drive bay and screw it on.
12
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
44 pin IDE Cable
2.5" HDD
Pin 1
Pin 1
Note: Beware of the directions when wiring HDD and IDE cable.
13
13
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
Panel PC Installation
1. In 2.4B or above Driver, choose Drivers & Utili-
ties.
14
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
1.1 Select Panel Computing.
15
15
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
1.2 Select P0715.
16
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
1.3 Install All Drivers.
17
17
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
2. Install Touch Screen Driver.
18
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
4. Select Promote Touch Driver to install.
19
19
P0715 Quick Installation
Download from Www.Somanuals.com. All Manuals Search And Download.
|