Keep this manual for future reference. If you sell or give this convenience
stroller away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
CONVENIENCE STROLLER
Operating Instructions
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you
have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F,
Safety Rules:
WARNING: Failure to follow these warnings and assembly instructions could result in
serious injury or death.
WARNING: Immediately discard any plastic wrapping.
WARNING: Never allow children to fold, assemble or disassemble the stroller.
WARNING: Maximum weight capacity for the Single stroller is 40 lbs. or 18.2 kg.
WARNING: Never place child in stroller on their back with their head forward and feet rearward.
WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt.
WARNING: Never leave child unattended.
WARNING: Never use this stroller with roller skates or in-line skates.
WARNING: Never allow stroller to be used as a toy or allow children to give rides to others.
WARNING: Never use stroller if it becomes damaged.
WARNING: Always be aware of traffic around you when walking.
WARNING: Always engage brakes when you stop or when you let go of handle.
WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.
WARNING: Maximum weight for objects in bottom basket is 5 lbs. or 2.2 kg. Excessive weight may
cause a hazardous, unstable condition.
WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position
unless T-shield/waist strap placement has been re-adjusted.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 3. RearWheel
Assembly
Rear Axle
Assembly
E1
D
Turn stroller onto its front
as shown (Figure D).
Slide the rear axle
assembly onto frame
as shown (Figure E1).
Note: to remove rear axle
assembly push up the
plastic baffles while
pushing in the silver
release button pull
Rear Axle
Rear Axle
Assembly
Release
Buttons
Both Sides
off the axle assembly
(Figure E2). Place rear
brake cog on the rear
wheel – turn the cog so
the grooves line up with
the ribs on the wheel
sprocket, then push the
adapter on. Slide the
wheel with brake cog
onto the axle (Figure F1).
Place the wide end of the
retaining clip onto the
grooved end of the axle,
then press to snap into
place (Figure F2). Posi-
tion the axle cap over
retaining clip and then
press to snap into place
(Figure F3). Place the
hubcaps on the wheels –
align the hubcap tabs
with the holes in the
center of the wheel,
then press into place
(Figure F4). Repeat for
other side.
E2
F1
Rear Axle
Rear Axle
Assembly
Release
Button
F2
F3
Retainer
Clip
Retainer
Clip
Axle Cap
F4
Axle Cap
Hub Cap
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 4. Mount child
napper bar
G1
Napper Bar
Release Tab
G2
Position bar as shown
with tabs on the bottom.
(Figure G1) Push in until
tabs lock in place.To
remove napper bar,
push up on bottom tabs
and pull off napper bar
(Figure G2).
Step 5. Adjust Canopy
Push or pull canopy too the desired position.
Use Instructions
WARNING: Always remove child from stroller before folding.
H
To fold stroller:
Step 1. Retract canopy and fully recline seat before folding
(Figure H). (See “To adjust 3-position recline seat”)
Step 2. Push in side buttons and lift slightly upon side handles
as shown, stroller will automatically begin to fold (Figure I).
Step 3. Continue folding by pushing frame together until
storage latch engages (Figure J).
I
To unfold stroller:
Release storage latch located on side of stroller, continue
unfolding until side latches engage (See Figure J).
To engage rear brakes: Step lightly on the center brake
bar to engage brakes. To disengage, lift up on brake bar
(Figure K).
J
K
Linked
Rear Brake
4
Download from Www.Somanuals.com. All Manuals Search And Download.
To place child in stroller:
Always engage rear brakes so stroller is steady. Lift canopy
from both sides and rotate back. Place child in stroller with
the T-shield between the child’s legs. Fasten the waist buckle.
Adjust belt so that it fits snugly around the child’s waist
(Figure L). (Note: To release, squeeze sides of buckle)
WARNING: Avoid serious injury from falling or sliding
out. Always use seatbelt.
To adjust 3-position recline seat:
L
To fully recline seat, pull up on the recline bar as shown.
(Figure M) To position seat upright, push back of seat until
side tabs fall into side notches.
WARNING: Child may slip into leg openings and
strangle. Never use in a reclined carriage position unless
T-shield/waist strap have been readjusted to the seats
new position.
M
For Models CS150T, CS200 and CS300
Child’s Convenience Tray
The napper bar must be used when using the child’s tray.
Step 1. Snap the child’s tray onto both side latches as
shown (Figure N).
Parent’s Convenience Tray
Tray
Centering
Supports
Side
Clamp
WARNING: To avoid burns, never put hot liquids
in the parent tray. To prevent tipping over do not place
more than 3 lb. or 1.4 kg on parent tray.
N
Phillips screw driver is required for installation.
Step 1. Fold the tray several times in the hinge area to break
in the hinge (Figure O1).
Step 2. Align the holes on the tray with knob on frame and
snap tray into place over knob. Repeat for other side
(Figure O2).
O1
O2
Parent Tray
Flex
Hinge
Knob
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Care and Maintenance
Check fasteners
After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary.
Periodically check the stroller to ensure that it is in good operating condition.
To clean seat and canopy:
If light cleaning is required, use a soft cloth with warm water and mild soap then air dry. Do not put
into washing machine. Do not put in dryer. DO NOT BLEACH.
To clean frame:
Wipe using a soft cloth with warm water and mild soap. Air dry. DO NOT USE polish or abrasives.
Accessory Name
Description
Item
Number
Retail
Price
Ship &
Handling
Qty.
Total
Cost
Child Tray--Blue
Fits on all InSTEP Convenience Strollers napper bar. Offers additional convenience.
13-SA066
$10.00
$10.00
$14.99
$10.99
$3.00
$3.00
$3.00
$3.00
Parent Tray--Blue
Fits on all InSTEP Convenience Strollers handle bar. Parent console tray with two
cup/bottle holders and one storage tray.
Fits on all InSTEP Convenience Strollers. For use with the CS100, CS150T,
CS200 and CS300. Made of heavy duty clear vinyl with black trim.
Fits on all InSTEP Convenience Strollers. For use with the CS100, CS150T,CS200
and CS300. Made of polyester mesh.
13-SA068
13-SA070
13-SA072
Convenience Stroller
Weather Shield
Convenience Stroller
Bug Screen
MN Residents add 6.5% Tax
Total
All prices are US Funds, Canadian Tax/Duty not included.
Order by any of these 4 convenient ways:
* Mail this form along with check or VISA or Master Card
VISA or Master Card Only
Card #
number listed to:
InSTEP LLC
2425 Enterprise Drive
Suite 900
Expiration Date
Mendota Heights, MN 55120
* Fax this form along with your credit card information to:
(612) 881-1899
* Call our customer service department at
1-800-242-6110 or (612) 881-1984
Cardholder Signature
Ship to Name:
Address:
Depending on your location, allow 7-10 business days for shipment.
City/ST/ZIP
Phone#
To Place Order, Call 1-800-242-6110
WARNING:
If you have any questions concerning the safe use of this product,
please contact InSTEP LLC before using:
1-800-242-6110
8am-5pm CST, Monday-Friday, or MAIL to:
2425 Enterprise Drive, Suite #900
Mendota Heights, MN 55120
Tel: 1-800-242-6110
email: [email protected]
6
Download from Www.Somanuals.com. All Manuals Search And Download.
|