Bushnell Battery Charger PP1085 User Manual

SolarBook™  
Quick Start Guide  
Model # PP1085/PP1060  
04-13  
HOW THE SOLARBOOK WORKS  
The SolarBook™ uses an advanced solar panel technology that is flexible,  
water resistant and durable. An on-board dual lithium ion battery stores  
electrical energy collected by the solar panel, so it can be used to recharge  
your portable electronic devices even at night or on a cloudy day. The  
SolarBook battery can also be charged from an AC outlet, ready to provide  
immediate power on demand. After the battery power is depleted, fold out  
the solar panel and let the sun charge it during the day, so you can recharge  
your devices anytime.  
FROM CHARGER USB PORT  
OUTPUT-Used for charging your device(s)  
from the SolarBook’s internal battery (once  
charged via solar energy or wall charger)  
(standard USB plug)  
B
TO SolarBook  
INPUT PORT  
(micro USB plug)  
FROM SolarBook  
OUTPUT PORT  
(standard USB plug)  
INPUT-Used for charging the SolarBook  
internal battery from wall charger.  
LEDs indicate charge status.  
TO PORTABLE DEVICE  
A
CHARGING PORT*  
(micro USB plug)  
Power  
Button  
POWERSYNC POWER GAUGE  
(LED Battery Status Indicators)  
* Use USB charging cable included with your  
device if this connector is not compatible.  
3
CHARGING THE SOLARBOOK FROM THE WALL CHARGER  
Connect USB cable to micro-USB INPUT port (A) from the USB port on the  
supplied AC charger (pg. 2), and plug it into a wall outlet (100-240v). Press the  
Power button. All four LEDs on the Power Gauge (Fig. 1) will light up (for 10  
min.) when the SolarBook’s internal battery has been fully charged (you may  
leave it connected to the charger overnight without risk of overcharging), and  
you’re ready to connect and charge your device.  
CHARGING THE SOLARBOOK FROM THE SUN  
Flip open the two clamps at the front end of the SolarBook and open the  
lid (C). Unfold all the solar panels out to full length. Place the SolarBook in  
a location where all the solar panel surfaces will be exposed to as much  
direct sunlight as possible (D). The hang tabs on the battery cylinder of the  
SolarBook (E) can be used to stake it to the ground to keep it securely in place  
on a windy day, or hang it from a tree or your backpack with carabiners.  
Allow up to 4 hours (PP1085) or 6 hours (PP1060) to solar charge the internal  
battery from a fully discharged condition. The Power Gauge LEDs near the  
INPUT port will monitor the charge level (Fig. 1). All four LEDs on the Power  
Gauge will light up (for 10 min.) when the SolarBook’s internal battery has  
been fully charged, and you’re ready to connect and charge your device.  
CHARGING YOUR DEVICE FROM THE SOLARBOOK  
Press the power button on the INPUT end of the battery cylinder (A) to check  
the SolarBook’s charge status, then connect the supplied USB cable from the  
OUTPUT port (B) of the SolarBook to your device to recharge it. If your device  
uses a non-standard type of connector, use the cable that came with it to  
connect to the SolarBook’s OUTPUT port. Check the charge indicator on your  
device to determine when it’s ready to use.  
STORING & TRANSPORTING THE SOLARBOOK  
Fold the solar panels back up, starting at the end, with the solar side facing  
inward. Fasten the lid in place to help keep the panels protected from  
accidental damage when you are charging your device from the SolarBook’s  
battery, and anytime you transport the SolarBook to a new location. Cover  
the INPUT and OUTPUT ends of the battery cylinder with the attached caps  
when storing or transporting the SolarBook, to help keep dirt and debris out  
of the USB ports.  
4
D
C
Solar panel surface  
facing the sun  
E
F
UNDERSTANDING THE POWERSYNC POWER GAUGE  
The 4 LED charge indicators on the INPUT end of the battery cylinder (F)  
allow you to monitor the status of the SolarBook’s internal battery. While the  
battery is charging from the AC wall charger or the solar panels, the LEDs  
will light up in sequence to show the charge level as shown in Fig. 1. The LED  
indicating the current battery level will blink rapidly while charging. When  
charging is complete, all LEDs remain on for 10 min., then shut off until the  
Power button is pressed.  
Blinking  
Fig. 1  
Charging  
In from AC/  
Solar  
>25%  
>50%  
>75%  
>90%  
FULL  
While the SolarBook is charging your connected device (Power button must  
be pressed), the LEDs will monitor the SolarBook’s battery level as shown in  
Fig. 2, with a single LED blinking once every 15 sec. (indicates active charging  
but conserves battery power).  
Fig. 2  
Charging Out  
to Device  
<25%  
<50%  
<75%  
<90%  
FULL  
5
UNDERSTANDING THE POWERSYNC POWER GAUGE  
You can also check the current level of the SolarBook’s battery charge  
anytime by pressing the Power button, even when it is not connected to  
the charger or an external device. The LEDs will glow steadily to indicate the  
charge level % as shown in Fig.3., then shut off after 10 seconds.  
Blinking  
Fig. 3  
Checking  
Charge Level  
<25%  
>25%  
>50%  
>75%  
FULL  
TECHNICAL SPECIFICATIONS  
Model  
Weight  
Size  
PP1085 (SolarBook 850)  
PP1060 (SolarBook 600)  
24 oz / 680 g  
23 oz / 652 g  
9.25 x 8.3 in. (53.25 in. fully extended) 9.25 x 8.3 in. (47.25 in. fully extended)  
Charge Time (Wall  
Charger)  
approx. 6-8 hrs.  
approx. 6-8 hrs.  
Charge Time (via solar  
panel)  
approx. 4-6 hrs. (variable due to  
weather conditions, position, etc.)  
approx. 4-10 hrs. (variable due to  
weather conditions, position, etc.)  
Power Output  
5 volts, 1 amp (1000 mA)  
Dual Lith Ion  
5 volts, 1 amp (1000 mA)  
Dual Lith Ion  
Internal Battery Type  
USB Inputs / Outputs  
Operating Temp. Range  
Storage Temp. Range  
1 / 2*  
1 / 2*  
-4 ~ 112o F (-20~44o C)  
-4 ~ 140o F (-20~60o C)  
-4 ~ 112o F (-20~44o C)  
-4 ~ 140o F (-20~60o C)  
Recommended  
Cell Phones (inc Smartphones)/2x,  
MP3 Players/3x, Digital Cameras/5x,  
Tablet/0.5x. Note: Tablets and other  
Cell Phones (inc Smartphones)/2x,  
MP3 Players/3x, Digital Cameras/5x,  
Tablet/0.5x. Note: Tablets and other  
Devices/# of Charges**  
(from fully charged  
internal battery)  
devices have higher power requirements devices have higher power requirements  
and may not attain a full charge from  
the SolarBook battery.  
and may not attain a full charge from the  
SolarBook battery.  
* Two devices may be charged simultaneously. They will not charge any slower than if only one device was connected, however the SolarBook’s  
internal battery charge will be depleted more rapidly.  
** Rechargeable batteries in electronic devices charge at different rates, depending on many factors including temperature, age and circuit  
design. Bushnell provides examples of charges per device, based on typical product use and are not intended to be specific to any single device.  
ATTENTION!  
ThePP1085/PP1060 is protected from static shock.  
If the unit does not turn on after depressing power button, please hold down power button for 2 seconds or until light activates.  
Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.  
6
ONE YEAR LIMITED WARRANTY  
Your Bushnell® POWERSYNC product is warranted to be free of defects in materials and workmanship for one year after the date of purchase.  
In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product  
postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by  
someone other than a Bushnell Authorized Service Department.  
Any return made under this warranty must be accompanied by the items listed below:  
1.  
2.  
3.  
4.  
5.  
A check/money order in the amount of $10.00 to cover the cost of postage and handling  
Name and address for product return  
An explanation of the defect  
Proof of Date Purchased  
Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid  
to the address listed below:  
IN U.S.A. Send To:  
Bushnell Outdoor Products  
Attn.: Repairs  
IN CANADA Send To:  
Bushnell Outdoor Products  
Attn.: Repairs  
9200 Cody  
Overland Park, Kansas 66214  
25A East Pearce Street, Unit 1  
Richmond Hill, Ontario L4B 2M9  
For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In  
Europe you may also contact Bushnell at:  
Bushnell Germany GmbH  
European Service Centre  
Mathias-Brüggen-Str. 80  
D-50827 Köln  
GERMANY  
Tél: +49 221 995568-0  
Fax: +49 221 995568-20  
This warranty gives you specific legal rights.  
You may have other rights which vary from country to country.  
©2013 Bushnell Outdoor Products  
FCC Compliance Statement  
This device complies with Part 15 of the FCC interference limits for Class B digital devices FOR HOME OR OFFICE USE. These limits are  
designed to provide reasonable protection against harmful interference in a residential installation, and are more stringent thanoutdoor”  
requirements.  
Operation of this device is subject to the following conditions; (1) This device may not cause harmful interference, and (2) this device must  
accept any interference received, including interference that may cause undesired operation.  
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,  
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the  
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
The device does not contain any user-serviceable parts. Repairs should only be made by an Authorized Bushnell repair center. Unauthorized  
repairs or modifications could result in permanent damage to the equipment, and will void your warranty and your authority to operate  
this device under Part 15 regulations.  
The shielded interface cable which is provided must be used with the equipment in order to comply with the limits for a digital device  
pursuant to Subpart B of Part 15 of FCC Rules.  
Customer Service: (800) 423-3537  
©2013 Bushnell Outdoor Products  

AKG Acoustics Battery Charger CU4000 User Manual
Carrier 48SS018 User Manual
Chauvet Automobile Accessories 1100 User Manual
Cino FUZZYSCAN F760 User Manual
Datalogic Scanning GRYPHON GM4100 User Manual
FARGO electronic STYLUS NX625 User Manual
Fisher Price K5502 User Manual
Havis Shields Universal License Plate Bracket C TIR3 UNV User Manual
Heat Controller Inc Air Conditioner DMC09SB 0 User Manual
HP Hewlett Packard HP Business Desktop Pro 6300 6300 User Manual