Fisher Price High Chair L0542 User Manual

L0542  
IMPORTANT!  
KEEP INSTRUCTIONS FOR  
FUTURE REFERENCE.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembled Parts  
2 Frames  
Pad  
Seat Back  
Seat Bottom  
2 Bases  
Footrest  
2 Seat Bottom Tubes  
Food Tray  
Hinge Rod  
Base Tray  
Teether Toy  
Note: Tighten or loosen all screws with a Phillips screw-  
driver.  
Do not over-tighten the screws.  
#8 x 1,9 cm Screws – 8  
#10 x 2,2 cm Black Screw – 7  
Shown Actual Size  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
IMPORTANT! Before assembly and each use, inspect this prod-  
uct for damaged hardware, loose joints, missing parts or sharp  
edges. DO NOT use if any parts are missing or broken. Contact  
Mattel for replacement parts and instructions if needed.  
Never substitute parts.  
Footrest  
Seat Bottom  
1
•Place the seat bottom face down on a flat surface.  
•At an angle, fit the footrest on the seat bottom, as shown.  
3
•Align the holes in the plastic rings and the seat bottom tubes.  
•Insert a #8 x 1,9 cm screw through each plastic ring and into  
the seat bottom tubes, as shown. Tighten the screws. This may  
require extra force.  
Plastic Rings  
•Push the seat bottom tubes back and forth to be sure they are  
secured to the seat bottom. If the seat bottom tubes move, you  
have probably not fastened them properly. Remove the screws  
and check to be sure the screw holes in the seat bottom tubes  
and seat bottom plastic rings are aligned. Replace and tighten  
the screws.  
Seat Bottom Tubes  
Plastic Rings  
2
•Slide a seat bottom tube through each set of plastic rings on  
the seat bottom.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Insert Screws Here  
Hinge  
Hinge Rod  
4
6
•Insert two #10 x 2,2 cm black screws through the footrest  
and into the seat bottom. Tighten the screws. This may require  
extra force.  
Turn the seat assembly face down.  
•Insert the hinge rod through the hinge on the seat back and  
seat bottom, as shown.  
•Insert a #10 x 2,2 cm black screw into the hinge rod. Tighten  
the screw.  
Seat Back Pin  
Seat Back Pin  
•Set the seat assembly aside for Assembly step 9.  
Slot  
Slot  
5
Turn the seat bottom assembly upright.  
•Fit the seat back pins into the slots in the top side of the seat  
bottom assembly.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Frame Leg  
Seat Height Adjusters  
Position 4  
Frame Decorated Side  
Press Lever  
Frame Back Legs  
8
•While pressing the levers on the seat height adjusters, lift them  
to position 4 on the frame front legs, as shown.  
Seat Assembly  
Base  
Screw Retainers  
Sockets  
7
•Pull the frame leg out on each frame to open. Make sure it  
"clicks" into place.  
Position a frame so that the decorated side is outward.  
•Fit the end of a base into the back leg of a frame.  
•Fit a screw retainer over the hole in the back leg, as shown.  
•Insert a #10 x 2,2 cm black screw through the screw retainer  
and back leg. Tighten the screw.  
Repeat this procedure to fasten the other frame back leg to the  
other side of the base.  
Hint: The #10 x 2,2 cm black screws may have been assembled to  
Seat Bottom Tubes  
9
•Fit the seat assembly between the frames.  
•Insert the seat bottom tubes into the sockets in each seat  
height adjuster.  
the screw retainers.  
Hints:  
•Be sure the seat height adjusters are in the same position  
(position 4).  
You may need to push the frames apart slightly to fit the seat  
bottom tubes into the seat height adjuster sockets.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
PUSH  
PUSH  
Screw Retainers  
Base  
Seat Bottom Tube Ends  
10  
11  
•Insert the frame front legs onto the remaining base.  
•Fit a screw retainer over a hole in the front leg.  
•Insert a #10 x 2,2 cm black screw through the screw retainer  
and front leg. Tighten the screw.  
Repeat this procedure to secure the other end of the base with  
•Push each seat height adjuster to be sure they are completely on  
the seat bottom tubes.  
Insert a #8 x 1,9 cm screw through each seat height adjuster and  
the ends of the seat bottom tube. Tighten the screws. This may  
require extra force.  
the remaining screw retainer and #10 x 2,2 cm black screw.  
Hint: The #10 x 2,2 cm black screws may have been assembled  
to the screw retainers.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Shoulder Straps  
Seat Bottom Tube Ends  
Crotch Strap  
14  
Remove both shoulder straps from the seat back.  
Remove the crotch strap from the seat back.  
Seat Height Adjusters  
12  
•Push each seat height adjuster to be sure they are completely on  
the seat bottom tubes.  
Insert a #8 x 1,9 cm screw through each seat height adjuster and  
the ends of the seat bottom tube. Tighten the screws. This may  
require extra force.  
PRESS  
PRESS  
13  
15  
•Squeeze the restraint release tabs together.  
Remove the ends of the restraint system from the peg.  
•Fit the pocket on the top of the pad onto the seat back.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Shoulder  
Straps Up  
Clips  
Lowest Slot  
Crotch  
Strap Down  
16  
•Fit the clips on the front edge of the pad onto the seat bottom.  
•Hook the elastic loops on each side of the pad onto the tabs in  
the seat back.  
17  
Hint: Do not unbuckle the restraint system. It is easier to attach or  
re-attach it to the product if it is buckled.  
•Grasp the restraint system so that the shoulder straps are up  
and the crotch strap is down.  
•Insert the end of the crotch strap through the lowest slot in the  
pad and the seat back.  
From behind the product, attach the end of the crotch strap to  
the peg.  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Shoulder  
Straps  
18  
Smaller Baby  
•Insert the ends of the shoulder straps through the lower slots in  
the pad.  
From behind the product, attach the ends of the shoulder straps  
to the peg.  
19  
Larger Baby  
From the front of the product, insert the ends of the  
shoulder straps through the upper slots in the pad and  
seat back.  
From behind the product, attach the ends of the shoulder  
straps to the peg.  
10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Secure Child  
Adjuster  
WARNING  
Prevent serious injury or death from  
falls or sliding out: The child should at all  
times wear a safety harness correctly fitted  
and adjusted. The tray is not designed to  
hold the child in the chair.  
Free End  
Anchored End  
Waist/Shoulder Belt  
Waist/Shoulder Belt  
TIGHTEN  
2
To tighten the waist straps: Feed the anchored end of the  
waist strap up through the buckle to form a loop A. Pull the  
free end of the waist strap B.  
To tighten the shoulder straps: Hold the adjuster and pull the  
shoulder strap down C.  
Adjuster  
Free End  
Crotch Belt  
1
Anchored End  
•Place your child in the seat. Position the crotch belt between  
your child’s legs.  
Fasten both waist/shoulder belts to each side of the crotch belt.  
Make sure you hear a "click" on both sides.  
LOOSEN  
3
•Check to be sure the restraint system is securely attached by  
pulling it away from your child. The restraint system should  
remain attached.  
To loosen the waist straps: ABCNote:  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Secure Child  
Shoulder Straps  
Shoulder Straps  
PRESS  
PRESS  
PRESS  
PRESS  
5
4
You can remove the shoulder straps and use only the  
waist restraint.  
To change strap slots:  
From behind the product, squeeze the restraint release tabs  
and remove the shoulder straps.  
From behind the product, squeeze the restraint release tabs and  
remove the shoulder straps.  
From the front of the high chair, pull the shoulder portions  
of the restraint system out and then fit them back through  
the desired shoulder strap slots in the seat pad and in the  
seat back.  
From behind the product, attach the ends of the shoulder  
straps to the peg.  
From the front of the product, pull to remove the shoulder straps  
from the seat back/pad.  
•Push to remove the shoulder straps from the waist restraint  
buckle slots.  
•Store the shoulder straps in a safe in a safe place for future use.  
12  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Using the Trays  
WARNING  
Prevent serious injury or death from  
falls or sliding out: The child should at all  
times wear a safety harness correctly fitted  
and adjusted. The tray is not designed to  
hold the child in the chair.  
PUSH  
Base Tray  
7
•While pushing the release bar on the front of the base tray,  
adjust the base tray forward or backward.  
Armrest  
PUSH  
6
8
•Fit the base tray onto the seat armrests. Push down until the  
base tray "snaps" into place.  
Hint: Before use, thorougly wash all parts (the trays) that may  
•While pushing the release bar on the front of the base tray, pull  
the tray base towards you and remove.  
contact food. The base tray is not dishwasher safe.  
13  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Using the Trays  
Using the Teether Toy  
Teether Toy  
Food Tray  
Base Tray  
Tab  
9
Slot  
•Fit the food tray into the base tray, as shown.  
Hint: Before use, thorougly wash all parts (the trays) that may  
contact food. The food tray is not microwave safe.  
Tab  
10  
•Insert and “snap” the teether toy tab into either slot in the tray.  
Hint: To remove the teether toy, press the tab and lift the toy.  
14  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Adjusting the Seat  
Hint: Adjust the seat height to any of seven positions!  
WARNING  
Prevent serious injury or death from  
falls or sliding out. It is recommended  
that only children capable of sitting upright  
unassisted use the high chair in the  
upright position.  
Seat Height Adjuster  
Hint: Adjust the seat angle to any of three positions: Upright,  
Semi-Recline or Recline.  
Press Lever  
Upright  
Semi-Recline  
12  
Recline  
To adjust the seat height:  
•Press the levers on both seat height adjusters and lift or lower  
the seat to the desired height.  
•Make sure both sides of the seat are adjusted to the same  
height. Push the seat bottom to be sure the seat is locked  
in place.  
SQUEEZE  
11  
To adjust the seat angle:  
•Squeeze the seat back handle and push the seat back forward  
or, pull it backwards to the desired position.  
•Push the seat back to be sure it is latched in position.  
15  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Storage  
Care  
•The pad, frame and base tray may be wiped clean using a mild  
cleaning solution and a damp cloth.  
•The restraint system may be wiped clean or is machine  
washable. Machine wash in cold water on the gentle cycle. Do  
not use bleach. Line dry.  
•The food tray, teether toy and restraint system are also top rack  
dishwasher safe (or use bottom rack - without using the  
drying cycle).  
Pull Frame  
Release Latch  
To remove the pad:  
Remove the elastic loops from the pegs on the back of the seat.  
From behind the product, squeeze the restraint release tabs and  
remove the restraint system from the peg.  
From the front of the product, pull to remove the restraint system.  
•Unfasten the pad hooks from the front edge of the seat. Lift the  
top of the pad off of the seat back.  
To replace the pad: refer to Assembly steps 13-19.  
IMPORTANT! Never use this product without the restraint  
system. Replace the waist/shoulder belts and crotch belt.  
13  
With the legs all the way open, lower the seat to position 7 the  
lowest position).  
•Pull the frame release latches forward and push the rear legs  
toward the front legs.  
L0542e-0726  
PRINTED IN MEXICO  
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.  
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Clarion CD Player DXZ366MP User Manual
CompuSTAR Universal Remote 2WFMR User Manual
Cub Cadet Lawn Mower 19HP Enforcer 44 21HP Enforcer 48 23HP Enforcer 54 User Manual
Cuisinart Coffeemaker DCC 1100 Series User Manual
Danby Freezer DCF700W1 User Manual
Desa Water Heater GVC35NA User Manual
Dixon Lawn Mower 1855 0599 User Manual
D Link Network Router WBR 2310 User Manual
Dynex Switch DX HUB23 User Manual
Extron electronic Projector SS 200 User Manual