Samsung TS H653N User Manual

Warning/Caution  
Introduction  
to the  
Safety Precautions  
The following are basic precautions to ensure user safety  
Connecting the Cables  
DVD Writer  
DVD Writer  
SH-S203N(TS-H653N)  
Warning: To warn the user that failure to comply with the instructions may result in  
serious injury or death.  
Caution:  
To caution the user that failure to comply with the instructions may result in  
damage to property.  
Design and specifications are subject to change without prior notice.  
and reduce the risk of property damage.  
User's Guide - ENGLISH  
Connecting the Cables  
Disc compartment  
Eject Button  
When you install the drive  
FCC Compliance  
Place the drive on a level  
surface.  
This equipment has been tested and found to comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC rules.  
These limits are designed to provide reasonable protection against harmful interference in a  
residential installation.  
Avoid low- or high-temperature  
environments.  
Avoid high-humidity environments.  
Do not place the drive in  
direct sunlight.  
Failure to do so may cause the  
device to fall onto a hard surface,  
resulting in damage or malfunction.  
Front  
This equipment generates, uses, and can radiate radio frequency energy and, if not installed  
and used in accordance with the instructions, may cause harmful interference to radio com-  
munications. However, there is no guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference to radio or television reception,  
which can be deter-mined by turning the equipment off and on, the user is encouraged to  
try to correct the interference by one or more of the following measures:  
S-ATA Data cable  
S-ATA Power cable  
• Re-orient or relocate the receiving antenna.  
LED  
Emergency eject hole  
• Increase the separation between the equipment and receiver.  
• Connect the equipment into an outlet on a circuit different from that to  
If the compartment does not open  
when you press the Eject button,  
power off the computer, insert a pin  
or unfolded paper clip in the hole  
and push firmlhy)  
which the receiver is connected.  
While operating  
• Consult the dealer or an experienced radio/TV technician for help.  
Do not move the drive while in operation and  
do not attempt to open the disc tray byforce.  
Make sure to close all working programs before  
attempting to open the tray and always use the  
open/close button.  
Do not use cracked, distorted or  
damaged discs.  
Do not drop the drive, and pro-  
tect it fromsevere shocks.  
Handle with caution to prevent  
damage from external shock.  
CAUTION  
Change or modifications not expressly approved by the manufacturer responsible for  
Connecting the power cable  
compliance could void the user ’s authority to operate the equipment.  
1
2
It can damage the drive or cause  
it to malfunction.  
The 4-pin power cable from the internal power unit of your computer must  
be connected to the power terminal the rear of the DVD Writer drive.  
LASER STANDARD  
IEC 60825-1 :1993 +A1 :1997 +A2 :2001  
WEEE  
Connecting the S-ATA cable  
Correct Disposal of This Product (Waste Electrical &Electronic Equipment)  
(Applicable in the European Union and other European countries with separate collection systems)  
S-ATA Power cable  
S-ATA Data cable  
In particular, a disc with a crack on the  
inner tracks may break while in use.  
Do not insert a pin into the emergency open-  
ing while in operation.  
This marking shown on the product or its literature,indicates that it should not be disposed with  
other household wastes at the end of its working life.To prevent possible harm to the  
environment or human health from uncontrolled waste disposal,please separate this from other  
types of wastes and recycle it responsibly to promote the sustainable reuse of material  
resources.  
S-ATA Data cable  
S-ATA Power cable  
Rear  
Other  
1. Check to see that the disc does not have a crack before use.  
If the disc has a crack (especially around the center hole),  
it is recommended that you make a copy immediately and  
use the copy instead.  
When a cracked disc is used continuously,the size of the  
crack is likely to grow and it will eventually result in irreparable  
damage to the disc.  
Household users should contact either the retailer where they purchased this product,or their  
local government office,for details of where and how they can take this item for environmentally  
safe recycling.  
Do not disassemble, attempt to repair  
or modify the device without express  
approval as directed in the manual.  
Never allow food particles or  
foreign substances to enter the  
drive casing.  
To protect against the risk of  
fire, do ot spill such liquids as  
alcohol and benzene on the  
drive.  
Business users should contact their supplier and check the terms and conditions of the purchase  
contract.This product should not be mixed with other commercial wastes for disposal.  
Samsung Eco-mark  
The Samsung’s own Eco mark helps consumers to easily understand that  
Samsung develops eco-friendly products. This mark represents Samsung’s  
continuous effort to develop eco-friendly products.  
To reduce the risk of damage,  
electric shock, and fire.  
Accessories  
2. Do not use low quality discs (i.e., illegal products, scratched or  
damaged discs).  
User Guide, Screw 4ea  
• RoHS  
(Restriction of the use of certain hazardous substances in electrical and electronic equipment)  
The RoHS, the environment regulation announced by European Union, restricts the use  
of lead, mercury, cadmium, hexavalent chromium, PBB, and PBDE in products put on  
the market in The European Union after July 1, 2006.  
The type of accessories varies depending on a product model.  
and some accessories described herein are subject to change without notice.  
Any change or modification not expressly approved by designated qualified personnel could  
void your authority to operate this device.  
Important to read and understand  
at all times  
Do not disassemble  
BG68-01445A REV.00  
3
4
1
2
Solving Technical Problems  
Using the Drive/Storing and Cleaning  
Your Discs  
Technical Specifications  
Installing the Drive  
SH-S203N(TS-H653N)  
Category  
The friction noise generated during SPIN-UP and STOP is caused by the  
Automatic Ball Balancing System(ABS) and is not a malfunction.  
When using one S-ATA cable  
DVD Writer  
System Requirements  
S-ATA supported PC  
(The compatible motherboard list can be found from the website)  
256Mbytes or above  
Windows 2000/XP/Vista  
Using the DVD Writer  
DVD : DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM, DVD-Video,  
DVD+R(DUAL) , DVD-R(DUAL), LightScribe DVD R, DVD-RAM  
See if the PC on.  
Push the power button and boot the computer.  
The tray won't open.  
Drive  
C D : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G) CD-MIDI, CD-TEXT,  
CD-ROM XA, Mixed Mode CD ‚ CD-I, CD-I Bridge (Photo-CD, Video-  
CD), Multisession CD(Photo-CD, CD-EXTRA, Portforio),  
LightScribe CD-R  
Usable Discs  
1
Make sure the power cable within the PC is connected properly.  
If the tray still won't open with the power on, turn the power off  
and insert a pin(paper clip) into the emergency hole to open.  
DISC  
After booting the computer, open the disc  
Installing the DVD Writer  
2
partment by pressing the Eject button.  
Make sure the disc has been inserted properly.  
The tray won't close.  
Disc Diameter  
Interface Port  
Burst Transfer Rate  
CD-ROM  
4.72 Inch or 3.15 Inch (120mm or 80mm)  
S-ATA  
How to install the DVD Writer on your PC. First, remove the cover; con-  
nect the cable to the DVD Writer and then to the PC.  
Insert the disc (CD) with the label on the disc  
See if the jumper(s) is properly connected to the Master/Slave  
Selection port.  
See if the drive is properly connected to the PC.  
See if the floppy disc remains in the PC.  
The PC is not working properly.  
Interface  
Support  
3
S-ATA 1.5Gbps  
110ms (Random)  
130ms (Random)  
facing upwards and close the disc compartment  
Access time  
(Random)  
by pressing the Eject button. The indicator light  
comes on.  
Play the disc (CD).  
If necessary, attach a horizontal bracket  
MainBoard  
Hard Drive  
1
DVD-ROM  
to both sides of the drive.  
See if the drive is connected properly to the PC.  
See if the device drive program has been installed properly.  
The drive is not working properly.  
The entire label area  
Titles and contents  
Titles only  
Setting  
You can purchase these accessories separately  
from your computer dealer.  
(including graphics)  
Disc  
Labeling  
Time  
4
Best  
Less than 4min  
Less than 3 min  
Less than 2 min  
Less than 9 min  
Less than 7 min  
Less than 4 min  
Less than 36 min  
Less than 28 min  
Less than 20 min  
See if the device drive program has been installed properly.  
Can be an OS problem. Try reinstalling the Windows OS program.  
The Window OS can't detect the  
drive.  
Normal  
(Screws for use: M3 X 6 X 4)  
Playing CD-DA/Audio CDs  
Draft  
When you have one ODD and the other ODD products.  
Run the CD player program supplied with the sound card or play the  
Windows Media Player.  
Media type  
DVD+R  
Write  
Read  
See if the system detects the drive.  
Make sure you use the types of discs that are supported  
by the drive.  
The system won't read the disc.  
CAV 20X  
Z-CLV 8X  
Z-CLV 16X  
Z-CLV 12X  
CAV 20X  
Z-CLV 6X  
-
CAV 16X  
CAV 12X  
CAV 12X  
CAV 12X  
CAV 16X  
CAV 12X  
CAV 16X  
CAV 8X  
Playing Video CDs  
Master Drive  
Slave Drive  
DVD+RW  
DVD+R DUAL  
DVD-R DUAL  
DVD-R  
Follow the instructions provided with the disc.  
A video card or MPEG software and a sound card need to be installed to view video CDs.  
See if the on/off light turns into green.  
Make sure you inserted the disc with the label facing up.  
Make sure you are using the right program for disc play-  
back.  
Remove the plate from a free expansion slot and install the  
DVD Writer , as shown in the illustration.  
If the drive is vertically installed, you cannot use an 8 cm Mini Disc  
because the disc is movable.  
2
See if the disc is clean.  
DVD-RW  
See if any congealing has occurred.  
Make sure the region code of the drive matches the disc  
number.  
Data Transfer  
Speed(MAX)  
If you have no free expansion slot, install the drive in place of the  
diskette drive.  
Storing Your Discs  
DVD-ROM(Single)  
DVD-ROM(Dual)  
CD-ROM  
Make sure to use the standardized screws supplied (M3X6).  
-
Do not place a disc in direct sunlight.  
Store a disc vertically in a well-ventilated and  
stable location.  
Do not write or attach a label on a disc.  
Do not drop a disc or place heavy objects on it.  
MainBoard  
- To use screws other than M3X6 may result in malfunction.  
-
CAV 48X  
CAV 40X  
CAV 40X  
CAV 40X  
CAV 40X  
CAV 12X  
Hard Drive  
CD-R  
CAV 48X  
Z-CLV 32X  
CLV 10X  
CLV 4X  
CAV 12X  
US-RW  
HS-RW  
CD-RW  
Cleaning Your Discs  
DVD-RAM  
DVD  
2MB  
Buffer Memory  
Drive Installation  
Plate  
Writer  
Horizontal  
Bracket  
Do not touch the surface  
of a disc; hold it by the  
edges.  
To clean a disc, polish lightly  
from the inside of the disc to the  
outside with a soft cotton cloth.  
Horizontal / Vertical  
Temperature  
Humidity  
41°F ~ 122°F (5°C ~ 45°C)  
5 ~ 80% (RH)  
Operating  
Environment  
Size(Width x Height x Length)  
Weight  
5.34 X 1.65 X 6.69 Inch (148.2 X 42 X 170mm)  
750 g  
The disc may not function properly if there are fingerprints, foreign substances or  
dust on the disc surface.  
7
8
9
6
5

Toshiba Computer Drive SD R6012 User Manual
Sony Mobile Xperia ZL C6502 Smartphone 1273 5759 User Manual
Sony Ericsson CDX CA690X User Manual
Siemens HIPATH 3000 User Manual
Seagate EE252 SERIES ST960818SM User Manual
Seagate BARRACUDA ST340815AS User Manual
Samsung SGH zx20 User Manual
Samsung GH68 04889A User Manual
Radio Shack 63 1088 User Manual
Palm XPLORE G18 User Manual