XTherm™- Type WHP
Job:
Engineer:
Contractor:
Prepared By:
Model:
Water Heaters
Models 1005-2005
Date:
Indoor/Outdoor:
97% Thermal Efficiency at Full Rate; Up to 99% at Part Load
100% Factory Fire Tested
Maximum Outlet Water Temperature: 160°F
Minimum Acceptable Inlet Water Temperature: 50°F
Full Safety Diagnostics with History
Footprint: Less Than 10.8 ft2
Limited Twenty-Five-Year Thermal Shock Warranty
Limited Ten-Year Primary Heat Exchanger Warranty
Limited Five-Year Secondary Heat Exchanger Warranty
Full Electronic Modulation, Constant Ratio 4:1 Turndown
Digital Controller with LCD Display
Status Display Lights
Heat Exchanger
Control (cont.)
Multi-Boiler Digital Temp Controllers
ƒ Bronze Headers
ƒ ASME HLW Stamped; 160 PSIG
MAWP
ƒ Diagnostics Panel with LCD Display,
2 lines, 20 characters
ƒ Digital Temperature Control
ƒ Water Temperature Sensors (3)
ƒ Cold Water Protection
B-36 TempTracker Mod+,
2-4 Water Heaters
B-37 TempTracker Mod+,
5-10 Water Heaters
B-38 TempTracker Mod+,
11-16 Water Heaters
ƒ National Board Listed
ƒ Cupro Nickel Fin Tubing
ƒ ASME Powder-Coated Tube Sheet
ƒ Silicone High Temp O-Rings
ƒ ASME Pressure Relief Valve
125 PSIG – Standard (Loose)
ƒ 150 PSI Air Vent, Auto
ƒ T&P Gauge (Loose)
ƒ Stainless Steel Secondary Heat
Exchanger
ƒ Stainless Steel Evaporator Plate
ƒ Boiler Pump: Bronze,
120V, 1∅, 60Hz
Burner
ƒ Ultra-Low NOx: Less than 20 PPM
(Natural Gas Only)
Options
F-10 Low Water Cut-Off, Remote
Probe
Gas Train
ƒ Fuel
I-5
High Limit, Manual Reset,
Adj., 100-200°F
Low Gas Pressure Switch,
Manual Reset
High Gas Pressure Switch,
Manual Reset
Natural Gas
Propane
ƒ Zero Governor Regulator
ƒ Dual-Seat Combination Valve
ƒ Electronic Firing Mode (WHP)
S-1
S-2
HP,
Z-12 Condensate Neutralizer Kit
Construction
ƒ Indoor/Outdoor Construction
ƒ Front Controls Enclosed
ƒ PolyTuf Powder Coat Finish
ƒ Rear Connections (Water, Gas, Vent,
Electrical, Comb. Air, Cond. Drain)
ƒ Combustion Air Filter
Control
Regulatory Agency Requirements
ƒ 120V, 60Hz, 1Ø, Power Supply
ƒ 120/24V 60Hz Transformer
ƒ Ignition Module
3-Try – Standard
Single-Try – Option C-6
ƒ Hot Surface Ignition (HSI)
ƒ Remote Flame Sensor
ƒ High Limit Control, Auto Reset
ƒ On/Off Power Switch
ƒ Flow Switch
ƒ Blocked Vent Pressure Switch
ƒ Combustion Air Proving Switch
ƒ Freeze Protection
ƒ Design Certified ANSI Z21.10.3/CSA 4.3
Venting
ƒ Vent Termination
Outdoor or Indoor, Vertical –
Option D-11
Indoor, Horizontal – Option D-15
ƒ Extractor - Optional
By others
ƒ Pump Switch
ƒ Pump Time Delay
ƒ Blocked Condensate Switch
Not required
Catalog No.: 6000.37
Effective: 9-15-08
Replaces: NEW
|