C2R-GM29
GM Radio Replacement
Interface for GMLAN Vehicles
Without OnStar®
Class 2
J1850
1 1 1 0 1 0 0 0 0 1 1 0 1 1 0 1 1 1 0 0 1 1 0 0
Class 2
1 0 0 0 1 1 1 0 1 1 1 1 0 0 1 0 0 1 1 0 1 1 0 0
This Interface is Intended for use in Vehicles without OnStar® or when OnStar® is not
serviced or is unwanted. For OnStar® Retention use the OS-3 or OS-3BOSE.
The C2R-GM29 allows aftermarket radio installation without retention of the factory radio. The interface replicates all factory warning chimes,
audible turn signal indicators and provides a data bus generated 12 volt accessory output that acts just as GM’s R.A.P. (Retained Accessory
Power) system did prior to radio removal. R.A.P. keeps the radio powered after the key is off, until the driver door is opened or a 10 minute
timer ends, whichever comes first. The C2R-GM29 also provides a SWC (Steering Wheel Control) output wire at the interface. By using this
interface, the Parking Assist System will receive a “healthy” system status and the Rear Seat Audio controls will also be available for use (if
equipped).
Installation:
If the Bose® Audio system is being used, connect the C2R-GM29’s RCA inputs to the aftermarket radios pre-amp output. The audio level will vary depending on
the new radios pre-amp output voltage (2-4 volts is recommended). If the Bose® Audio system is not used or present, cut the RCA inputs off and connect the new
radios speaker outputs to the remaining wire. If the vehicle and the interface both chime, move the chime switch to the off position. The other wire connections
are as follows:
• Yellow - 12 Volt Constant Voltage
Fig. 1
• Black - Ground
High Current 12v
(using a SPDT relay)
(Fused)
• Red - 12 Volt R.A.P Voltage (1 AMP max)
• Blue/White - Antenna turn on, Amplifier turn on, and RSE turn on (if equipped)
• Orange - Dimmer/Illumination
• Lt. Green - SWC Output Wire
85
87
86
12v Acc.
From
Interface
Ground
87a
30
Diode 1N4005
or equivelant
Using the SWC Output wire - Connect the SWC (green) output wire to a P.A.C. SWI interface.
Use the green SWI interface wire and program the SWI interface for version 2. Follow ONLY the
interface programming instructions included with the SWI interface. Do not cut the Brown loop.
New High
Current Output
**If more than 1 AMP is needed from the Red +12v Accessory wire refer to Fig 1.
A
B
C
D
E
F
G
H
1
2
3
4
1
2
3
4
Illumination (Orange)
Battery (Yellow)
Only for
GMLAN
29 bit
Ground (Black)
Amp Turn On / Antenna (Blue)
+12 Acc.1 AMP max (Red)
Vehicles.
Pacific Accessory Corporation
GMLAN Warning Chime and Radio
Replacement Interface
SWC Output (Lt. Green)
*Use Version #2*
Chime On / Off
A
B
C
D
E
F
G
H
Turns the
Rear Seat
Audio on
and off
Using the RSA Controls
The headphone jacks will play the rear zone source
selected by the head unit (refer to the new radios instruc-
tion manual for details on this feature if equipped).
These Buttons will
perform the
same function as the
Steering Wheel
Buttons do (when
a SWC interface
is used)
On
Notes: When the Rear Seat Audio jacks are activated in
any vehicle OTHER than the Cadillac Escalade or GMC
Yukon Denali the rear speakers will mute.
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-GM29 parts be held liable for consequential damages sus-
tained in connection with the C2R-GM29. The manufacture and it’s distributors will not, nor will they authorize any representative or any other individual
to assume obligation or liability in relation to the C2R-GM29 other than its replacement.
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
07-30-07
|