Winterization (for RV or marine installs)
A) To winterize your washer-dryer
3) With ON-OFF button in the OFF
(OUT) position, pour ½ TBSP.
of powder detergent (or liquid
equiv.) into the ‘Detergent’com-
partment inside the Dispenser
Drawer (see Users Guide).
1) With machine power OFF, pour ½
quart of RV-type antifreeze into
washer drum
Front-Loading Washer-Dryer
Addendum to Users Guide
2) Close door. Advance Program Dial
to a ‘Spin’position
4) Advance Program Dial to an
3) Press ON-OFF Button (IN). Wait 1-2
Models:
EXPRESS position
WD2000S
minutes
WD2100
5) Press ON-OFF button (IN). Allow
machine to run through complete
cycle to clean out any remaining
antifreeze. FINISHED.
WDC6200CEE
4) Press ON-OFF Button (OUT). Un-
plug washer-dryer from electrical
outlet (or disconnect power)
5) Turn water supply faucets OFF.
Disconnect inlet hoses from fau-
cets. Drain remaining water from
the hoses. FINISHED.
QUESTIONS?
Westland Sales
15650 SE 102nd Ave (PO BOX 427)
Clackamas, OR 97015
Opening the Door
Optional RV Winterization - If currently
pumping antifreeze through a fresh water system
To open the door during a WASH cycle
1) Advance Program Dial to ‘RESET’.
1) With machine power OFF, turn
WASH TEMP knob to HOT
Wait 5 seconds.
Call: 1-800-356-0766
2) Advance Program Dial to REGU-
2) Advance Program Dial to ‘Drain’(8
o’clock) and allow the machine to
drain completely.
LAR in Cotton Heavy Duty
Local: 503-655-2563
Service Fax: (503) 722-9202
3) Press ON-OFF button (IN). Let
machine fill until antifreeze is in
the drum
3) Advance Program Dial to ‘RESET’
(‘Status/Door Lock’LED will blink
quickly to indicate that the cycle
has stopped, but the door is STILL
LOCKED)
4) Advance Program Dial to ‘RESET’.
Wait 5 seconds (Status/Door Lock
LED will blink)
5) Advance Program Dial to a ‘Spin’
position. Let the antifreeze drain
from the drum
4) When the ‘Status/Door Lock’ LED
blinks SLOWLY (takes 1-2 minutes),
you can open the door
6) Advance Program Dial to ‘RESET’.
Wait 5 seconds (Status/Door Lock
LED will blink)
To open the door during a DRY cycle
1) Advance Program Dial to ‘RESET’
(The ‘Status/Door Lock’ LED will
blink FAST to indicate the cycle
has stopped.
7) Press the ON-OFF button (OUT)
No Dryer Lint Filter
8) Turn WASH TEMP knob to COLD
No more messy lint filter cleanings! Lint
passes safely through a ‘self-cleaning
pump’and then out the drain or dryer
vent in your Splendide.
9) Repeat steps 2 through 7.
2) Wait for the ‘Status/Door Lock’
LED to blink SLOWLY (takes 1-2
minutes). Open the door.
FINISHED.
B) To use again, flush water pipes, then
If small items (like keys or hair clips) acci-
dentally fall into the pump, they’re safely
witheld in a coin trap that you can easily
access (see Users Guide).
1) Reconnect water inlet hoses to
corresponding HOT/COLD faucets.
Turn faucets ON. NOTE: Check wa-
ter inlet hoses and pump periodi-
cally (see Users Guide).
IMPORTANT: DO NOT
attempt to open the door
until the ‘Status/Door
WD2000S, WD2100 Models: Occasion-
ally, go outside and check the dryer vent
for proper airflow. Assure that the vent
and ducting are lint-free.
!
Lock’ LED is blinking
SLOWLY!
2) Plug washer-dryer in to appropri-
ate electrical outlet (see Users
Guide) - or reconnect power
supply
D O N O T D I S C A R D !
This information supersedes the information found in your owners manual.
Keep this page with your owners manual for future reference
Download from Www.Somanuals.com. All Manuals Search And Download.
!
!
|