®
30" Freestanding Electric Range
PRODUCT MODEL NUMBERS
OVERALL DIMENSIONS
FEP310K
FEP320K
FEP330K
FES330K
Electrical: This range can be direct wired to a
four-wire or three-wire, 8 gauge copper or 6
gauge aluminum wire wiring system or a range
power supply cord can be used. A four-wire or
three-wire, single-phase, 120/240-volt, 60 Hz,
AC-only, electrical supply is required on a 40 amp
circuit, (or, if specified on the model/serial rating
plate, a four-wire or three-wire, single-phase
120/208-volt, 60 Hz, AC-only electrical supply is
available, a 40 amp circuit), fused on both sides
of the line. A time-delay fuse or circuit breaker is
recommended. The model/serial rating plate is
located on the oven frame behind the storage
drawer panel.
27-1/8" (68.9 cm)
depth with handle
46-7/8"
(119.1 cm)
overall
height
36"
(91.4 cm)
cooktop
height
24-13/16"
(63 cm)
29-7/8" (75.9 cm) width
CABINET OPENING DIMENSIONS
Cabinet opening dimensions shown
are for:
13" (33 cm) max.
25" (63.5 cm) countertop depth,
24" (61 cm) base cabinet depth,
36" (91.4 cm) countertop height
upper cabinet depth
30" (76.2 cm) min.
cabinet opening width
For minimum
clearance to the
top of the cooktop,
see NOTE.**
30-1/8" (76.5 cm)
opening width
18" (45.7 cm) min.
clearance upper side
cabinet to countertop
Do not pinch
the power
4" (10.2 cm) min. clearance
from both sides of range to
side wall or other combustible
material above the countertop
Wall receptacle —
8" (20.3 cm) to 22"
supply cord
between the
(55.9 cm) from either
cabinet, 5-1/2"
5-1/2"
(14.0 cm)
max.
range and the
wall.
(14.0 cm) max. from
floor. Position
receptacle as shown.
Do not seal the
range to the
side cabinets.
*
NOTE: 24" (61 cm) min. when bottom of wood
or metal cabinet is protected by not less than 1/4"
(6.4 mm) flame retardant millboard covered with
not less than No. 28 MSG sheet steel, 0.015" (0.4
mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) min. clearance between the top of the
cooking platform and the bottom of an unprotected
wood or metal cabinet.
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 9759923
05-20-04
Download from Www.Somanuals.com. All Manuals Search And Download.
|