Instruction
Manual
Care Center
Do not use this product until
you read and understand
these instructions.
DEDICATED TO QUALITY
English
PM-1645AA
6/00
WARNINGS
Failure to follow all warnings and instructions could result in serious injury or
death.
• Never leave child unattended. Always keep child in view.
• This product is intended for use by one child at a time.
• Bassinet, Changer and/or Playard, including side rails, MUST be fully erected prior to use.
• Keep product away from stoves, heaters, campfires, fireplaces and other hazards which can
burn or cause injury to child.
• DO NOT use accessories other than those provided by Century.
• Strings can cause strangulation. DO NOT place items with a string around a child’s neck (such
as hood strings, pacifier cords, etc.). DO NOT suspend strings over product or attach strings
to toys.
• DO NOT place product near a window where cords from blinds or drapes can strangle child.
• DO NOT use product in a motor vehicle. Serious injury or death could result from a sudden
stop or accident.
2
ASSEMBLY and USE
2 Stand Playard on legs and
wheels and unfasten Floorboard
Attachment Straps.
Floorboard
Attachment Straps
3 Separate Playard legs to
approximately 60 cm (2 feet)
apart.
4 Pull up on Top Rails until all
“click” and lock.
Playard
IMPORTANT: Floor loop
MUST remain raised at least
45.7 cm (18 inches) in order
for rails to lock.
WARNING
Top Rail
Avoid serious injury or death:
NOTE: Test by pushing
down on each top rail
to be sure they are locked.
• Use Playard for a child who is unable to
climb out of Playard and weighs less than
14 kg (30 lbs.) and is less than 89 cm
(35 inches) tall.
WARNING
• DO NOT use Playard without floorboard
being properly secured to Playard floor.
All top rails MUST be straight and locked in
position or child may become entrapped and
suffocate.
• DO NOT add padding or objects inside
Playard that will permit child to climb out.
• DO NOT move or fold Playard with child in
it.
• SUFFOCATION HAZARD: To help prevent
suffocation from entrapment, use only
floorboard provided by Century. NEVER
use additional mattress or padding.
1 Pull travel bag up and over top
of Playard.
5 Push down on center of Playard
floor until it is flat and locks into
position.
NOTE: Locking action is
automatic.
3
ASSEMBLY and USE continued
HINT: It may be necessary to
lift end of Playard to push center
down.
Bassinet
WARNING
Avoid serious injury or death:
• Use bassinet with infant who weighs less
than 8.2 kg (18 lbs.) and is less than
63.5 cm (25 inches) tall.
• DO NOT use without floorboard being
properly place in bassinet.
6 Place floorboard in Playard with
padded side facing up.
• Discontinue use of bassinet if infant can
push up on hands and knees or sit
unassisted.
• DO NOT carry bassinet with infant in it.
• DO NOT use as a car bed.
• SUFFOCATION HAZARD: To help prevent
suffocation from entrapment, use only
floorboard provided by Century. NEVER
use additional mattress or padding.
NOTE: DO NOT install floorboard if using
bassinet. Go to bassinet assembly section.
7 Secure ends of floorboard to
Playard by passing Attachment
Straps through holes in
bottom of Playard floor and
securing to underside of
Playard.
1 Lay bassinet on flat surface
and spread open.
Attachment
Strap
2 Rotate and extend four (4)
Hooks until they “click” in
place.
WARNING
To prevent child from
suffocating, attachment
straps MUST be secured
to underside of Playard.
Hook
3 If floorboard is installed in
Playard, remove floorboard.
Playard assembly is now complete and
ready to use.
4 Fold Floorboard into “W”
shape and place in center
of bassinet.
Floorboard
4
ASSEMBLY and USE continued
Pocket
5
6
7
Insert one side of floorboard
under Pocket on side of
bassinet.
To use bassinet with Playard:
1 Place bassinet in Playard so that
hooks go over long rails with
“T-Slots” facing center of
Playard.
NOTE: “T-Slots” MUST face
center of Playard when using
with changer.
“T-Slots”
Pockets
Pull Pocket down over
floorboard to hold
floorboard in place.
2 Secure bassinet to Playard:
Repeat steps 5 and 6 for
other side of floorboard.
• Pass Attachment Strap
through opening in corner
of side panel of Playard.
• Fasten strap to outside of
Playard.
Repeat for other strap.
Attachment
Strap
Push down on center of
floorboard to flatten.
Bassinet is now ready for use with Playard.
Bassinet assembly is now complete.
To use bassinet without Playard:
• Bassinet can be used with or without changer.
• Bassinet can be used with or without Playard.
WARNING
Prevent falls and suffocation:
• Use only on a surface that is flat, level and
stable.
• Keep bassinet away from surface edges.
1 Set bassinet on flat and stable surface that will keep
floorboard level so child will not roll into corner or side of
bassinet resulting in breathing difficulties.
2 Keep at least 30.5 cm (12 inches) away from surface edges
and stay within reach of child. Child’s wiggling and rocking
may cause bassinet to move and possibly fall off surfaces.
5
ASSEMBLY and USE continued
4 Push Triangular Tabs into
TriangularHoles in Playard
corners.
Changer
Triangular
Tab
Changer can only be used when bassinet is
installed in Playard.
Triangular
Hole
WARNING
Avoid serious injury or death:
• Always use restraint belt to prevent falls.
• Use with infant who weighs less than 8.2 kg
(18 lbs.) and is less than 63.5 cm (25 inches)
tall.
5 Secure changer to Playard:
• Pass Attachment Strap
• Discontinue use of changer if infant can
push up on hands and knees or sit
unassisted.
through opening in corner
of side panel of Playard.
• Fasten strap to outside of
Playard.
• DO NOT carry changer with infant in it.
Attachment
Strap
Repeat for other strap.
1 Lay changer on flat surface.
6 Place storage pocket flap over
side of Playard.
NOTE: DO NOT place supplies
weighing more than 2.3 kg
(5 lbs.) in storage pocket.
Triangular
Tab
T-Fitting
2 Grasp middle of each long side
and gently pull apart until short
sides “click” and lock in place.
NOTE: Make sure changer sides
are fully extended and locked.
Changer is now ready for use.
3 With vinyl side facing up,
insert two (2) “T-Fittings”
T-Slot
on changer into “T-Slots”
in bassinet and push down
to secure.
T-Fitting
6
FOLDING and STORING
3 Remove floorboard from
Changer
bassinet.
1 Unfasten attachment straps.
2 Unhook “T-Fittings” from
“T-Slots” by pulling up
slightly on long side closest
to bassinet, then pull changer
away from bassinet.
4 Press release buttons on each
hook and push hook into
larger tube.
3 Grasp short sides and feel for
release buttons in center of
short sides.
5 Rotate hooks to center of
bassinet.
4 Press buttons on each side
and push closed.
6 Fold bassinet.
5 Place changer in pocket of travel bag.
Bassinet
7 Place bassinet in pocket of
travel bag.
1 Unfasten both attachment straps.
IMPORTANT: If continuing to use Playard, be sure to
properly secure floorboard in Playard.
2 Remove bassinet from Playard.
7
FOLDING and STORING continued
4 Gather Playard frame together
Floor Loop
Playard
while pulling up on Floor Loop.
1 To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set
aside.
5 Wrap floorboard around Playard
frame with padding facing in.
2 Lift Floor Handle, rotate
counterclockwise to unlock
floor and pull up,
NOTE: Floorboard Handle MUST
be aligned with wheels as shown.
Handle
approximately 45.7 cm
(18 inches).
6 Secure Attachment Straps
by threading through loops
on end of floorboard and
folding back onto itself.
Floor
Handle
NOTE: Make sure floorboard
is positioned above wheels.
Attachment
Straps
3 To fold top rails:
• Pull up on top rail slightly.
7 Position travel bag over Playard
so Handle comes through
Opening in side of bag.
Floor Loop
• Squeeze Release Button
on bottom of top rail and
push rail down. (Release
buttons are identified by
printed arrows.)
Pull travel bag over Playard.
Opening
Handle
Pull Floor Loop through opening
on top of travel bag.
Repeat for other sides.
NOTE: To prevent rubbing,
make sure travel bag is
positioned above wheels.
NOTE:
• If rails are difficult to
unlock, raise center of
floor higher and
squeeze Release
Button again.
Release
Button
• If only one side of rail
folds, squeeze Release
Button again to fully
fold.
8
MAINTENANCE
Cleaning
Playard, Bassinet, Changer, Floorboard and
Travel Bag
• Surface wash with mild detergent and water, air dry.
• Quickly clean up any spills with warm soapy water.
REPLACEMENT PARTS
Parts List (Model 10-751-XXX-01)
Price
Quantity
Total
A. Travel Bag
US$ 10.00 x _____ = $ ______
(CAN $ 15.50)
B. Padded Floorboard
US $ 25.00 x _____ = $ ______
(CAN $ 38.75)
C. Instruction Manual
FREE
x _____ =
FREE
Total Parts
$ ______
NOTE: Prices subject to change.
9
REPLACEMENT PARTS ORDER FORM
Sales Tax
• California, Illinois, Indiana,
Maryland and New York Residents
Total Parts
$
$
$
$
Add Sales & Applicable Local Taxes
• Ohio Residents Add 5.75% Sales Tax
Sales Tax
• Pennsylvania Residents Add 6% Sales
Tax except for Philadelphia and
Allegheny Counties add 7% Sales Tax
• South Carolina Residents Add 5% Sales
Tax
Shipping & Handling
Outside Continental USA
Shipping & Handling
US $ 0.01 to $ 9.99
(CAN $ 0.01 to $ 15.49
=
=
US $ 3.00
CAN $ 4.75)
Total
$
US $ 10.00 and over
(CAN $ 15.50 and over
=
=
US $ 5.00
CAN $ 7.75)
We must have this information to process your order: see label
on bottom tubing of Playard.
Outside Continental USA
Add:
US $ 10.00
(CAN $ 15.50)
Model No.:
Manufacture Date:
Please make checks payable to CENTURY PRODUCTS or charge
to VISA, MASTERCARD or DISCOVER.
Orders outside USA Must use credit card.
Cardholder’s Name:
Card Number:
NOTE: If requested color is not available, a similar color
will be substituted.
Card Exp. Date:
Check enclosed for $
SHIP TO:
Name:
Address:
City:
State:
Zip:
Telephone No.:(
)
MAIL BOTH PAGES OF ORDER TO:
CENTURY PRODUCTS
P.O. BOX 100
ELVERSON, PA 19520-9974
ATTENTION: CUSTOMER SERVICE DEPARTMENT
FAX BOTH PAGES OF ORDER TO:
(610) 286-4555
PM-1645AA
6/00
Remember
We are here to help you!
For immediate help, call our Customer
Service Department at 1-800-837-4044
from anywhere in the U.S. or Canada
or fax at 1-610-286-4555.
Visit us at our Web site:
|