Humminbird TV Mount 530516 1_D User Manual

1
530516-1_D  
Quick Disconnect Mounting Bracket  
Thank You  
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation  
by designing and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird®  
accessories offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.  
Your Humminbird® accessory is designed for trouble-free use in even the harshest marine environment.  
In the unlikely event that your Humminbird® accessory does require repairs, we offer an exclusive Service  
Policy - free of charge during the first year after purchase, and available at a reasonable rate after the  
one-year period. For complete details, see the Warranty section included in this manual.  
Contact our Customer Resource Center at 1-800-633-1468 or visit our website at www.humminbird.com.  
Installation Overview  
Following are instructions for the installation of this accessory. Before you start installation, we encourage  
you to read these instructions carefully in order to get the full benefit from your Humminbird® accessory.  
If you find that any items are missing from your installation kit, call our Customer Resource Center at  
1-800-633-1468 or visit our website at www.humminbird.com.  
To install your Quick Disconnect mounting system, you will need a drill, your control head, the mounting  
bracket, the connector holder, the power cable, the mounting hardware, a 9/64" drill bit, a 1" hole saw, a  
Phillips and a flat-head screw driver, an adjustable wrench, a level, and marine-grade silicone sealant.  
Installation  
Perform the procedures in the following sections to install the Wide Quick Disconnect mounting system on  
your boat.  
360 Degree Swivel  
1.  
Determine Where to Mount  
Begin the installation by determining where to mount the control head. Consider the following to determine  
the best location:  
• To check the location planned for the control head, test run the cables for power, transducer and  
Temp/Speed accessory (if applicable).  
• There are two ways to route the cables to the unit: through a hole in the mounting surface underneath  
the mounting bracket, or from a hole outside the mounting bracket. Routing the cables under the  
mounting bracket provides maximum weather protection; this may not be feasible, however, if the area  
under the control head is inaccessible. In this case, route the cables through a hole at another location  
and cover with the supplied hole cover.  
90 Degree Tilt  
• The mounting surface should be stable enough to protect the control head from excessive wave shock  
and vibration, and should provide visibility while in operation.  
• The mounting area should allow sufficient room for the unit to pivot and swivel freely, and for easy  
removal and installation (see illustrations).  
© 2008 Humminbird®, Eufaula AL, USA.  
All rights reserved.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3
530516-1_D  
Quick Disconnect Mounting Bracket  
Cable Connector Holder  
Transducer  
4.  
Connecting the Cable  
Accessory  
Communications  
Power  
1. Insert the cable connector into the appropriate slots of the connector holder. The cable connectors are  
labeled, and there are corresponding labels on the connector holder on the rear of the fishfinder. The  
slots are keyed to prevent reversed installation, so be careful not to force the connector into the holder.  
2. Carefully pull the excess cable from beneath the mounting surface so the connector holder aligns with  
the mounting holes on the front of the mounting bracket.  
3. Snap the support plate to the rear of the connector holder as illustrated.  
4. Insert the connector holder into place and use the two #6-32 x 3/4” screws to fasten it to the mounting  
bracket.  
Snap the Support Plate onto  
the Connector Holder  
Attach the Connector Holder  
to the Mounting Bracket  
Connector Holder  
Cable Connector  
Support  
Plate  
5. Install the control head by sliding it onto the mounting bracket until it is fully seated. To remove the unit,  
simply depress the latch on the rear of the unit and lift.  
6. If the cables pass outside the mounting bracket, reinstall the hole cover over the thru-hole and fasten  
in place using the two #8 x 7/8” wood screws.  
Your fishfinder is now ready for operation.  
Firmly Press  
Latch to  
Remove Unit  
© 2008 Humminbird®, Eufaula AL, USA.  
All rights reserved.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
4
530516-1_D  
Quick Disconnect Mounting Bracket  
1-Year Limited Warranty  
Contact Humminbird®  
We warrant the original retail purchaser that products made by  
Humminbird® have been manufactured free from defects in materials  
and workmanship. This warranty is effective for one year from the date  
of original retail purchase. Humminbird® products found to be defective  
and covered by this warranty will be replaced or repaired free of charge  
at Humminbird® option and returned to the customer freight prepaid.  
Humminbird® sole responsibility under this warranty is limited to the  
repair or replacement of a product that has been deemed defective by  
Humminbird®. Humminbird® is not responsible for charges connected  
with the removal of such product or reinstallation of replaced or  
repaired parts.  
Contact the Humminbird® Customer Resource Center  
in any of the following ways:  
By Telephone  
(Monday - Friday 8:00 a.m. to 4:30 p.m. Central Standard Time):  
1-800-633-1468  
By e-mail  
(typically we respond to your e-mail within three business days):  
This warranty does not apply to a product that has been:  
• Improperly installed;  
For direct shipping, our address is:  
Humminbird  
• Used in an installation other than that recommended in the  
product installation and operation instructions;  
Service Department  
678 Humminbird Lane  
Eufaula, AL 36027 USA  
• Damaged or has failed because of an accident or abnormal  
operation;  
• Repaired or modified by entities other than Humminbird®.  
ENVIRONMENTAL COMPLIANCE STATEMENT: It is the intention of  
Humminbird® to be a responsible corporate citizen, operating in compliance  
with known and applicable environmental regulations, and a good neighbor in  
the communities where we make or sell our products.  
Please retain your original receipt as a proof of the purchase date. This  
will be required for in-warranty service.  
WEEE DIRECTIVE: EU Directive 2002/96/EC “Waste of Electrical and  
Electronic Equipment Directive (WEEE)” impacts most distributors, sellers, and  
manufacturers of consumer electronics in the European Union. The WEEE  
Directive requires the producer of consumer electronics to take responsibility for  
the management of waste from their products to achieve environmentally  
responsible disposal during the product life cycle.  
THIS WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES,  
OBLIGATIONS OR LIABILITIES ON THE PART OF HUMMINBIRD® AND  
WILL BE THE CUSTOMER'S EXCLUSIVE REMEDY, EXCEPT FOR ANY  
APPLICABLE IMPLIED WARRANTIES UNDER STATE LAW WHICH ARE  
HEREBY LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF  
ORIGINAL PURCHASE. IN NO EVENT WILL HUMMINBIRD® BE LIABLE  
FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF  
ANY EXPRESS OR IMPLIED WARRANTY RELATING TO THE PRODUCTS.  
WEEE compliance may not be required in your location for electrical &  
electronic equipment (EEE), nor may it be required for EEE designed and  
intended as fixed or temporary installation in transportation vehicles such as  
automobiles, aircraft, and boats. In some European Union member states, these  
vehicles are considered outside of the scope of the Directive, and EEE for those  
applications can be considered excluded from the WEEE Directive requirement.  
Some states do not allow limitations on an implied warranty, or the  
exclusion of incidental or consequential damages, so the above  
exclusions may not apply to you. You may also have other rights, which  
vary from state to state.  
This symbol (WEEE wheelie bin) on product indicates the product must  
not be disposed of with other household refuse. It must be disposed of  
and collected for recycling and recovery of waste EEE. Humminbird®  
will mark all EEE products in accordance with the WEEE Directive. It is  
our goal to comply in the collection, treatment, recovery, and environmentally  
sound disposal of those products; however, these requirement do vary within  
European Union member states. For more information about where you should  
dispose of your waste equipment for recycling and recovery and/or your  
European Union member state requirements, please contact your dealer or  
distributor from which your product was purchased.  
DOMESTIC (USA) CUSTOMERS:  
PLEASE DO NOT RETURN THIS PRODUCT TO STORE FOR SERVICE  
For all technical issues please call 1-800-633-1468  
Or visit www.humminbird.com, click SUPPORT  
Please reference product serial number and  
model number when contacting Humminbird®.  
© 2008 Humminbird®, Eufaula AL, USA.  
All rights reserved.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Graco Stroller ISPA317AA User Manual
Grizzly Lathe G5960 User Manual
Hamilton Beach Food Processor 70590CR User Manual
Hamilton Beach Toaster 840124100 User Manual
Hario Glass Inflatable Bouncy Toy EVKB 80U User Manual
Honeywell Door 5828 User Manual
Hotpoint Microwave Oven SE48101PX User Manual
HP Hewlett Packard Printer 2500CHP User Manual
Husqvarna Tiller 650RTTA User Manual
IBM Laptop X121E User Manual