INSTALLATION INSTRUCTIONS
Before Using Your Freezer
Activate the super freeze function for 6 hours
before loading your food
Remove the exterior and interior packing.
Check to be sure you have all of the
following parts:
TABLE OF CONTENTS
Electrical Connection
For your safety please read the following
information
1 Storage Basket
1 Instruction Manual
2
3
INSTALLATION INSTRUCTIONS
Before connecting the freezer to the power
source, let it stand upright for approximately
2 hours. This will reduce the possibility of a
malfunction in the cooling system from
handling during transportation.
Clean the interior surface with lukewarm
water using a soft cloth.
OPERATING YOUR FREEZER
RCAA 100 P
RCNAA 250 P
RCNAA 300 P
CARE AND MAINTENANCE
PROBLEMS WITH YOUR FREEZER
5
6
7
9
1
TROUBLESHOOTING GUIDE
ASSISTANCE
3
2
Installing Your Freezer
This appliance is designed to be free
standing only, and should not be recessed or
built-in.
4
Place your freezer on a floor that is strong
enough to support the freezer when it is fully
loaded.
Allow 15 cm of space between the back and
sides of the freezer, which allows the proper
air circulation.
6
5
Locate the freezer away from direct sunlight
and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase
electrical consumption. Extreme cold
ambient temperatures may also cause the
freezer not to perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly
installed-grounded wall outlet. Do not under
any circumstances cut or remove the third
(ground) prong from the power cord. Any
questions concerning power and/or
grounding should be directed toward a
certified electrician or an authorized service
center.
1.door seal
2.hanging basket
3.hinge
4.cabinet assembly foamed
5.outer tube
6.control panel
1
2
Download from Www.Somanuals.com. All Manuals Search And Download.
CARE AND MAINTENANCE
PROBLEMS WITH YOUR FREEZER
Declaration of conformity
Cleaning Your Freezer
Moving Your Freezer
For household refrigerating appliances, in
normal temperature conditions, please
arrange the thermostat at the middle setting.
This appliance is designed to store food
and is manufactured in conformity with
European Directive 90/128/EEC,
Upon installation of your new appliance, it is
recommended that it be cleaned thoroughly.
Turn the temperature control to "OFF",
unplug the freezer, remove the food and
storage basket.
Remove all the food.
Securely tape down all loose items inside
your freezer.
02/72/EEC and Regulation(EC)No.1935/2004
Remove the rollers to prevent damage.
Tape the doors shut.
Before loading the appliance with packages
of fresh foods, make sure they are cooled to
ambient temperature.
Wash the inside with a damp warm cloth
containing a water and baking soda solution.
The solution should be about 2 tablespoons
of baking soda to a quart of water.
Wash the storage basket with a mild
detergent solution.
Be sure to keep the door gasket (seal) clean
to keep the unit running efficiently.
The outside of the freezer should be cleaned
with mild detergent and warm water.
Dry the interior and exterior with a soft cloth.
The condenser coils should be vacuumed
when they are dusty or dirty.
It is recommended that the unit be cleaned
each time it is defrosted to help keep the unit
odor free and running efficiently.
Be sure the freezer stays in the upright
position during transportation.
Ice and frost layer increase energy
consumption, so do clean the appliance as
soon as the layer is 3-5 mm thick.
Energy Saving Tips
This appliance is designed,manufactured,
and retailed in compliance with:
- the safety objectives of the Low Voltage
Directive 2006/95/CE(that substitutes
Directive 72/73/CEE and successive
amendments);
- the protection requirements of the’EMC’
Directive 89/336/EEC amended by Directive
93/68/EEC
The electrical safety of the appliance can
only be guaranteed if the product is connected
to an approved earth connection.
The freezer should be located in the coolest
area of the room, away from heat producing
appliances or heating ducts, and out of the
direct sunlight.
If it is the outer condenser, the rear wall
should be always clean, free of dust or any
impurities.
Let hot foods cool to room temperature
before placing in the freezer. Overloading
the freezer forces the compressor to run
longer. Foods that freeze too slowly may
lose quality, or spoil.
Be sure to wrap foods properly, and wipe
containers dry before placing them in the
freezer. This cuts down on frost build-up
inside the freezer.
Always consider instructions stated in
sections Positioning and Energy Saving Tips,
otherwise the energy consumption is
substantially higher.
Vacation Time
Remove all the food.
Freezer storage bin should not be lined with
aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation,
making the freezer less efficient.
Organize and label food to reduce door
openings and extended searches. Remove
as many items as needed at one time, and
close the door as soon as possible.
You can solve many common freezer
problems easily, saving you the cost of a
possible service call. Try the suggestions
below to see if you can solve the problem
before calling the servicer .
Unplug the freezer.
Clean the freezer.
Leave the door open slightly to avoid
possible formation of condensation, mold, or
odors.
Use extreme caution in the case of children.
The unit should not be accessible to child's
play.
Short vacations: Leave the freezer operating
during vacations of less than three weeks.
Long vacations: If the appliance will not be
used for several months, remove all food and
unplug the power cord. Clean and dry the
interior thoroughly. To prevent odor and mold
growth, leave the door open slightly: blocking
it open if necessary or have the door
removed.
Try not to open the door too often, especially
when the weather is wet and hot. Once you
open the door, mind to close it as soon as
possible.
Every now and then check if the appliance is
sufficiently ventilated (adequate air
circulation behind the appliance).
5
6
Download from Www.Somanuals.com. All Manuals Search And Download.
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE
PROBLEM
Freezer does not operate
POSSIBLE CAUSE
PROBLEM
Moisture forms on inside freezer walls
POSSIBLE CAUSE
Weather is hot and humid, which increases internal
rate of frost build-up. This is normal.
Door is slightly open.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The freezer temperature control is set at "0/OFF”
Door is kept open too long, or is opened too frequently.
Open the door less often.
The room temperature is hotter than normal.
A large amount of food has been added to the freezer.
The door is open too often.
Compressor turns on and off frequently
The door is not sealed properly
The door is not closed completely.
Door is slightly open, causing cold air from inside the
freezer to meet warm moist air from outside
Moisture forms on outside of freezer
The door will not close properly
The temperature control is not set correctly.
The door gasket does not seal properly.
The freezer does not have the correct clearances.
The freezer has recently been disconnected for a
period of time. Four hours are required for the freezer
to cool down completely
The freezer is not level.
The gasket is dirty.
The storage basket is out of position
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
- WARNING Do not use electrical appliances
inside the food storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer
(IEC 60335-2-24:2010)
Temperature control is set too warm. Turn the control
to a cooler setting and allow several hours for the
temperature to stabilize.
Temperature inside the freezer is too warm
Door is kept open too long or is opened too frequently.
Warm air enters the freezer every time the door is
opened. Open the door less often.
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance. (A2:06)
Appliances which use flammable insulation blowing
gases, instructions shall include information
regarding disposal of the appliance
(IEC 60335-2-24:2010)
The door is not closed completely.
The door gasket does not seal properly.
A large amount of warm or hot food might have been
stored recently. Wait until the freezer has had a
chance to reach its selected temperature.
The freezer has recently been disconnected for a
period of time. Four hours are required for the freezer
to cool down completely.
For compression-type appliances which use
flammable refrigerants, instructions shall include
information pertaining to the installation, handling,
servicing (IEC 60335-2-24:2010)
Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
This appliance is intended to be used in household
and similar applications (list)
- WARNING Do not use mechanical devices or
other means to accelerate the defrosting process,
other than those recommended by the
Temperature inside the freezer is too cold
Temperature control is set too cold. Turn the control to
a warmer setting and allow several hours for the
temperature to stabilize
manufacturer (IEC 60335-2-24:2010)
Popping or cracking sound when compressor comes
on
Metal parts undergo expansion and contraction, as in
hot water pipes. This is normal. Sound will level off or
disappear as freezer continues to run
- WARNING Do not damage the refrigerant circuit
(IEC 60335-2-24:2010)
Refrigerant (used to cool freezer) is circulating
throughout the system. This is normal
Bubbling or gurgling sound, like water boiling
Vibrations
Check to assure that the freezer is level.
Floor is uneven or weak. Freezer rocks on the floor
when it is moved slightly. Be sure floor can adequately
support freezer. Level the freezer by putting wood or
metal shims under part of the freezer.
The freezer is touching the wall. Re-level the freezer
and move it from the wall.
See “Installation Instructions”
DANGER or WARNING:
1. Risk of child entrapment. Before you throw away your old refrigerator or freezer:
-
-
Take off doors.
Leave the shelves in place so that children may not easily climb inside.”
2. Do not use extension cords.
7
8
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSISTANCE
ASSISTANCE
Indesit
Company
V
Mod.
RCAA 100 P
00789850000
S/N
-
50H1.10A
Total
vol.
Gross
Brut
Freez.
Capac
101 L
Class
Classe
Net
5kg/24h
ST/N
Utile
Refr.
kg.
Freez
0.032 kg.
Made In China
Indesit
Company
V
Mod.
RCNAA 250 P
00792880000
S/N
220-240V~
50Hz .60A
Total
vol.
Gross
Brut
Freez.
Capac
251 L
Class
Classe
Net
12kg/24h
ST/N
Utile
Refr.
kg.
Freez
Made In China
0.048 kg.
9
10
Download from Www.Somanuals.com. All Manuals Search And Download.
|