®
appendix C
Router Table Handles
®
Download from Www.Somanuals.com. All Manuals Search And Download.
Determine height for pattern bit.
Thickness of tail board
Trim stock or spacer
At least 1/16" of bearing
must extend above base
of router table.
Pattern bit depth
1/2" for guide forks
Base of router
table
Routing Pins and Tails
Grasp the router table handles on the side opposite the board that you wish to
route, and slide the KATIE JIG™ System toward the bit. Carefully route the
areas between each of the guide/ tuning forks.
CAUTION: DO NOT lift the KATIE JIG™ System while the router is running!
Slide fixture toward bit
Page C-2
Copyright © 1997-2000 Hampton House, Inc.
Download from Www.Somanuals.com. All Manuals Search And Download.
|