LIMITED LIFETIME WARRANTY
Freestyle U.S.A. warrants, to the
original purchaser, that its watches
are free from defects in materials
and workmanship for the lifetime
of the watch (under normal use)
from date of original purchase.
The following are not covered under
warranty: battery, strap/bracelet/
band and crystal.
1. Press S3 button to select time mode.
2. Press S2 button to toggle between
HOME TIME and FOREIGN TIME
mode to set.
3. Press and hold S2 button for two
seconds until the “SET” message
appears and the second digits blink.
4. Press S1 button to reset the second
digits to 00.
5. Press S3 button, the minute digits
will blink.
6. Press S1 button to set the minute
digits. Holding down the button will
speed up the process.
alarm. Alarm indicator
will appear.
3. Press again to activate the hourly
chime. Chime indicator will
appear.
4. Press the third time to activate both
functions. Both of the indicators will
appear.
5. Press the fourth time to deactivate
both functions. Both of the
indicators will disappear.
TO SET THE TIMER
1. Press S3 button to select TIMER
mode.
FOLLOW THESE 8 TIPS TO GET THE
MOST OUT OF YOUR NEW WATCH!
2. Press S2 button to alter the timer
setting among 1, 3, 5, 10, 15, 20, 25,
30, 45 and 60 minutes.
1. Never pull out the crown or operate
the pushers/buttons under water.
TO USE THE TIMER
In TIMER mode,
CONVERT
2. Make sure your crown is returned
to the original position before you
expose your watch to water.
1. Press S1 button to start counting.
2. To stop counting, press S1 button
once. Press S1 button again to
resume from where it left off.
3. To reload the TIMER, press S1
button to stop counting and then
press S2 button.
4. After reaching zero in a countdown,
a tune will be emitted. To stop the
tune, press any button, the TIMER
will reload automatically.
Accidental breakage or damage
due to normal wear or misuse of
the product, including but not limited
to the mathematical accuracy of
the product, is not covered under
this warranty. Some states do not
allow limitations on how long an
implied warranty lasts, or the
exclusions of or limitations on
consequential damages, so the
above limitation may not apply to
you. This warranty gives you
Model FS81200
Model FS81201
WHEN AN ALARM OR HOURLY
3. If your watch is exposed to
saltwater it is very important to
wash it thoroughly under tap water
and wipe dry with a soft cloth.
Keep it clean!
CHIME GOES OFF
A tune will go off by the hour if the
hourly chime function is activated.
FEATURES
100 meters H2O
Day/date
EL backlight
Chronograph
Pre-set countdown timer
Alarm
7. Press S3 button, the hour digits will
blink.
8. Press S1 button to set the hour
digits.
•
•
•
•
•
•
•
An alarm tune will be emitted for
around 20 seconds at the designated
time when the alarm is activated. To
stop the tune, press any button.
9. Follow the same pattern to set date,
month, day (of the week), hour
format and calendar format.
10.To set the hour format, press S1
button to toggle between 12-hour
and 24-hour format. The P.M.
indicator may be displayed to
indicate the time period 12:00A.M.
– 11:59 P.M. in 12-hour format.
11.To set the calendar format, press
S1 button to toggle between M-D
(month-date) and D-M (date-month)
format.
4. Severe impacts or drops may
affect your watches water
resistance and performance.
Dual time
NOTE: You can leave the timer running
while switching over to other operating
modes.
specific legal rights, and you may
have other rights, which vary from
state to state.
5. Avoid exposing your Freestyle
watch to extreme temperatures
such as in a hot shower, Jacuzzi,
sauna or hot tub. The combination
of extreme heat and water may
cause your watch to lose some of
its water resistance.
TO USE THE STOPWATCH
1. Press S3 button to select
STOPWATCH mode.
2. The stopwatch will then be displayed
in its current state – reset, running,
or stopped.
3. To resume a counting, press S1
button to resume from where it left
off.
4. To start a new counting, reset the
stopwatch to zero first.
CONTROL BUTTONS
S1 - Start/stop button
S2 - Lap/reset button
S3 - Mode button
Under this warranty FREESTYLE
will make any necessary repairs, if
applicable, at no cost to you the
consumer. Any repair needed that
is not under warranty will be at the
cost of you the consumer. Proof
of purchase and / or original receipt
it needed to validate your warranty.
TO USE THE BACKLIGHT
Press S4 button to turn on the backlight
for around three seconds.
S4 - Light button
6. Avoid exposing your watch to
chemicals, soaps or solvents as
they deteriorate the water resist
seals in your watch.
12.After finish making all the settings,
press S2 button to confirm.
S4
S3
S1
S2
Press S1 button to stop counting,
then press S2 button to reset
counter to zero.
Your warranty is voided by any
servicing out by a non-authorized
agent. Any other form of guarantee
to you by the retailer is his / her
responsibility. This warranty applies
to watches purchased in the United
States. For watches purchased
outside the United States, please
contact you authorized
NOTE: The chosen hour and calendar
formats will apply to both HOME TIME
mode and FOREIGN TIME mode.
7. Never try to remove the caseback,
leave this to a certified watch repair
technician or Freestyle service
center. This will help in preventing
water leakage from improper
battery replacement.
For the measurement of elapsed time:
In STOPWATCH mode,
1. Press S1 button to start counting.
2. To stop counting, press S1 button
once. Press S1 button again to
resume from where it left off.
3. To reset to zero, press S1 button to
stop counting, then press S2 button
to reset the counter to zero.
NOTE: In FOREIGN TIME settings, only
minutes, hours, date, month and day
are open to setting.
DISPLAY MODES
The watch has four display modes:
HOME TIME (TIME), HOME TIME
ALARM (ALM1), STOPWATCH (STW)
and COUNTDOWN TIMER (TMR).
8. It is advisable to have your watch
pressure tested annually and to
re-furbish your watch every 2-3
years to extend the life of the watch.
TO SET THE ALARM TIME
1. Press S3 button to select alarm
mode.
FREESTYLE dealer for warranty
information.
To change from one display mode to
another, press S3 button once. The
mode description will appear for 2
seconds before the selected mode is
activated.
2. Press S2 button to toggle between
HOME TIME ALARM and FOREIGN
TIME ALARM mode to set.
3. Press and hold S2 button for two
seconds until the “SET” message
appears and the minute digits blink.
4. Press S1 button to set the minute
digits. Holding down the button will
speed up the process.
5. Press S3 button, the hour digits will
blink.
6. Press S1 button to set the hour
digits.
For the measurement of split time:
In STOPWATCH mode,
1. Press S1 button to start counting.
2. While the stopwatch is running,
press S2 button once to register a
lap. The stopwatch is still running
in the background.
To display the currently accumulated
time, press S2 button again.
3. Repeat the last step until all the
laps have been registered.
4. To stop counting, press S1 button
once. Press S1 button again to
resume from where it left off.
5. To reset to zero, press S1 button to
stop counting, then press S2 button
to reset the counter to zero.
HOME AND FOREIGN DISPLAY
To display FOREIGN TIME, press S2
button when HOME TIME is displayed.
The mode description (TM-2) will
appear shortly before FOREIGN TIME
is displayed. To change back to HOME
TIME, press S2 button.
7. After finish making all the settings,
press S2 button to confirm.
To display the daily FOREIGN TIME
ALARM, press S2 button when HOME
TIME ALARM is displayed. The mode
description (ALM2) will appear shortly
before FOREIGN TIME ALARM is
displayed. To change back to HOME
TIME ALARM, press S2 button.
TO TURN ON/OFF THE ALARM
AND HOURLY CHIME
In alarm mode,
1. Press S2 button to toggle between
HOME TIME ALARM and FOREIGN
TIME ALARM mode to set.
NOTE: You can leave the stopwatch
running while switching over to other
operating modes.
TO SET THE TIME AND
CALENDAR
2. Press S1 button once to activate the
Download from Www.Somanuals.com. All Manuals Search And Download.
|