EVERFOCUS
1/3” Color Rugged Dome Camera
Operation Instructions
Model No. EHD300
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not install the camera near electric or magnetic fields.
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,
audio speakers since the magnetic fields generate from above devices will distort the video
images.
2. Never disassemble the camera nor put impurities in it.
Disassembly or impurities may result in trouble or fire.
3. Never face the camera toward the sun.
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.
4. Keep the power cord away from water and liquid.
Touching the wet power cord may result in electric shock.
5. Cleaning
Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from
the camera body. Use lens tissue or a cotton swab and ethanol to clean the sensor and the
camera lens.
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION
1. Loosen the 4 fix screws on the housing cover by using the attached wrench (Figure 1).
Please pay attention not to damage the lens.
Figure 1
2. Remove the camera.
Vari-Focal Lens
Locking Screws
Figure 2
To remove the camera, first unplug the wire connection on the back of the camera. Then
loosen the 2 locking screws on the camera base, push the camera base to the right (toward
heater direction, as shown in Figure 2), remove the camera from the mounting base.
Reinstall the camera and the cable while the base mounting is completed.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
3. Mounting the base.
Side conduit entry
Conduit plug setscrew
Back conduit entry
Mounting Setscrew
Mounting Setscrew
Mounting Setscrew
Mounting Setscrew
Figure 3
Attach the base to the wall or ceiling, fix the base by the 4 setscrews attached in the
accessory pack. Please make sure if the mounting is strengthened enough to
support it, if not, please reinforce the mounting according to the environment.
Note: The diameter of the screw hole isψ4.7mm.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Back conduit entry (PF1/2)
The camera comes with a conduit plug
pre-installed in the PF 1/2 conduit entry on
the side. The screw can be removed and
installed in the back conduit entry. Loosen
the conduit plug setscrew (as shown in
Figure 4) before removing the conduit plug.
Conduit plug
Side conduit entry (PF1/2)
Figure 4
Caution: To prevent moisture leaking into the housing, apply an appropriate
gasket or sealant around the conduit connection.
4. Wire Connection
Termination Board
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Micro Switch for Alarm trigger
Power In (+)
Power In (-)
GND
Alarm COM
Video
Alarm NO
V. Phase Adjustment VR
Alarm NC
Figure 5
Connect the power supply cable (12VDC/24VAC), video output and alarm
output to the proper connectors shown as Figure 5.
The V. Phase adjustment screw is located on the termination board. The
vertical phase may require adjustment to synchronize the vertical phase of the
camera with other camera in the system when it is to be used in the line-lock
sync mode. Make the adjustment when the vertical phase of the camera does
not match with other cameras.
5. View Angle Adjustment
The camera can be rotated 360° horizontally, 140° vertically and 60° 3’rd axis
view angles (as shown in Figure 6). Adjust the proper camera view angle as
needed. If a vari-focal lens is used, you may adjust the focus and zoom of
the lens to bring the object in focus. Be sure to loosen the locking screws on
the lens before you make adjustment.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Lens fixing Screws
140°
360°
60°
Figure 6
6
Download from Www.Somanuals.com. All Manuals Search And Download.
DIP SWITCH FUNCTION
Vari-Focal Lens
FL (Flickerless Function) ON/OFF
When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of
electronic shutter at 1/100(NTSC) or 1/120(PAL) automatically, and reduce the flicker
immediately.
The default setting is OFF.
Mirror ON/OFF
Mirror ON: Set a horizontal image inversion.
Mirror OFF: Disable the inversion.
The default setting is OFF.
AGC (Automatic Gain Control) OFF/ON
AGC ON: The sensitivity increases automatically when light is low.
AGC OFF: A-low-noise picture is obtained under a low light condition.
The default setting is ON.
D/N (Day/Night) ON/OFF
D/N ON: When light environment is under 5 Lux, the camera will switch to black and white mode.
However, when light environment is over 10 Lux, the camera will switch to color mode.
Please be informed that any D/N switch will result a delay of 4~5 seconds.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
D/N OFF: Camera stays in color mode.
Note: when AGC setting is OFF, then D/N function will be inactive.
The default setting is OFF.
IRIS Level Adjustment
Brightness Level can be adjusted from the IRIS level VR.
Turn counterclockwise to L to get darker picture.
Turn clockwise to H to get brighter picture.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
SIMPLE INSTRUCTIONS FOR THE DESICCANT PACK
Due to the camera lens blurred from the humidity inside the camera.
The desiccant pack absorbs the humidity; please refer to the easy instruction as follows:
1. Adjust all settings first and place the desiccant pack on the horizontal rod, then bend the
horizontal rod and fix it.
2. Install the outer cover and tighten the screws.
Installation steps for the camera:
Step 1
Horizontal rod
Desiccant pack
Step 2
Bend the horizontal rod and fix the desiccant pack
Step 3
Install the outer cover and tighten the screws
9
Download from Www.Somanuals.com. All Manuals Search And Download.
SPECIFICATIONS
Pickup Device
Video Format
1/3'' SONY Super HAD CCD
NTSC or PAL
NTSC: 525 TV lines, 60 fields/sec.
PAL: 625 TV lines, 50 fields/sec.
768 x 494(NTSC) ; 752 x 582(PAL)
520TVL
Scanning System
Picture Elements
Horizontal Resolution
Sensitivity
0.4Lux/F=1.2
S/N Ratio
Over 48dB (AGC off)
1/50(1/60)~1/100,000
Vari-focal lens, Auto Iris
f=2.9~10mm
Electronic Shutter
Lens Type
f=3.7~12mm
f=9~22mm
Auto Gain Control
Flickerless
ON/OFF Switch
ON/OFF Switch
H-Mirror
ON/OFF Switch
Day/Night Mode
Auto White Balance
Gamma Correction
ON/OFF Switch
Yes
0.45
2 video outputs
Video Output
BNC 1.0Vp-p, 75ohm
Additional testing video output 1.0Vp-p, 75ohm
Sync. Mode
Internal sync
Weatherproof
Vandal Resistant
Power Source
IP66
Yes
12VDC/24VAC
24VAC: 4W max.
Power Consumption
Dimensions
12VDC: 2W max.
130mm(W) x 98.8mm(H) x 130mm(D);
5.1"(W) x 3.87"(H) x 5.1"(D)
0.8kg ; 1.8lbs
Weight
Operating Temperature
Certifications
-10°C~50°C ; 14°F~122°F (20%~80% Humidity)
FCC/CE
10
Download from Www.Somanuals.com. All Manuals Search And Download.
CONTENT LIST
Standard Accessories
1. Camera Unit
2. Operation Instruction (this document)
3. Accessory Pack
4. Waterproof Connector
5. Power & Video Cable
Optional Accessory
1. Wall Mount Bracket (BA-EHD)
11
Download from Www.Somanuals.com. All Manuals Search And Download.
EverFocus Electronics Corp.
Headquarter Office
Beijing office
12F, No.79 Sec.1 Shin-Tai Wu Road,
Hsi-Chi, Taipei, Taiwan
Tel: +886-2-26982334
Room 609,Technology Trade Building.
Shangdi Information Industry Base,
Haidian District,Beijing China
Tel: +86-10-62971096
Fax: +886-2-26982380
Fax: +86-10-62971423
European Office
Japan Office
Albert-Einstein-Strasse 1,
D-46446 Emmerich, Germany
Tel: +49-2822-9394-0
5F Kinshicho City Building，2-13-4 Koto-bashi，
Sumida-Ku，Tokyo，130-0022，Japan
Tel: +81-3-5625-8188
Fax: +49-2822-939495
Fax: +81-3-5625-8189
USA California Office
USA New York Office
415 Oser Ave Unit S
1801 Highland Ave. Unit A
Duarte, CA 91010 ,U.S.A
Tel: +1-626-844-8888
Hauppauge, NY 11788
Sales: +1-631-436-5070
Fax: +1-631-436-5027
Fax: +1-626-844-8838
India Office
Suite 803, 8th Floor,
Housefin Bhavan,
C-21 Bandra Kurla Complex,
Bandra (East), Mumbai 400 051
Tel: +91 22 6128-8700
Your EverFocus product is designed and
manufactured with high quality materials and
components which can be recycled and
reused.
Ihr EverFocus Produkt wurde entwickelt und
hergestellt mit qualitativ hochwertigen
Materialien und Komponenten, die recycelt
und wieder verwendet werden können.
Dieses Symbol bedeutet, dass elektrische und
elektronische Geräte am Ende ihrer
Nutzungsdauer vom Hausmüll getrennt
entsorgt werden sollen.
This symbol means that electrical and
electronic equipment, at their end-of-life,
should be disposed of separately from your
household waste.
Please, dispose of this equipment at your
local community waste collection/recycling
centre.
Bitte entsorgen Sie dieses Gerät bei Ihrer
örtlichen kommunalen Sammelstelle oder im
Recycling Centre.
In the European Union there are separate
collection systems for used electrical and
electronic product.
Helfen Sie uns bitte, die Umwelt zu erhalten, in
der wir leben!
Please, help us to conserve the environment
we live in!
P/N: 4605XH0300002AR_Ver.B
Download from Www.Somanuals.com. All Manuals Search And Download.
|