MA0312-EA
Operation Guide PDM-10B/20B
ILLUSTRATION
GENERAL GUIDE
PDM-20B
PDM-10B
PDM-10B
5RESET button
1RESET button
Press to reset the number of steps to “0” .
Press to reset the number of steps to “0” .
Pressing this button while the display is blank turns
on the display.
6SET button
7MODE button
8Front panel
9Back panel
0Clip
Holding down this button turns off power.
2Front cover
3Back cover
4Clip
ACursor
OPENING THE PEDOMETER PANELS (PDM-20B)
Holding the front and back panels of the pedometer, release the catch on the top of the panels and then open them
as shown in the illustration.
PDM-20B
AFFIXING THE PEDOMETER TO YOUR CLOTHING
• Clip the pedometer securely to your belt or the waistband of your slacks, skirt, training pants, etc.
• Take care that you hook the clip so your belt or waistband enters the clip as far as it will go. Improper attachment
of the pedometer or wearing it an angle can cause mistakes in the number of step count.
• Take care that you do not accidentally press the RESET button while you are attaching or removing the
pedometer. Accidentally pressing the RESET button will reset the number of steps to “0”.
• Make sure that the two panels of the pedometer are securely closed while you are using it (PDM-20B).
• A sticker is affixed to the glass of the pedometer when you purchase it. Be sure to remove the sticker before
using the pedometer.
• Depending on the model of your pedometer, its configuration may differ somewhat from that shown in the
illustration.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Operation Guide PDM-10B/20B
Battery Precautions
BATTERY REPLACEMENT
Replace the battery whenever the figures on the display become dim and difficult to read.
• Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician
immediately.
• Be sure to load the battery with its positive (+) side facing upwards (so you can see it ).
• Never charge the battery that comes with the pedometer.
Replacing the Battery
(PDM-10B)
• Should the battery ever leak inside the pedometer, wipe out the fluid with a cloth, taking care not to let any get
onto your skin.
1. Remove the screws that secure the back cover in place.
2. Remove the old battery.
3. Load a new battery so its positive (+) side is facing up (so you can see it).
• Loading the battery improperly can cause it to leak and damage the interior of the pedometer.
4. Replace the back cover and secure it in place with the screws.
• Replace the battery at least once every 3 years, even if the current battery is working properly.
• The battery that comes with the pedometer loses some of its power during transport and storage.
(PDM-20B)
1. Insert a coin or similar object into the slot on the bottom of the pedometer.
2. Move the coin up and down to remove the cover from the front panel.
3. Remove the old battery.
4. Load a new battery so its positive (+) side is facing up (so you can see it ).
• Loading the battery improperly can cause it to leak and damage the interior of the pedometer.
5. Replace the cover on the front panel.
• Insert the tabs of the cover into the slots, and then press the cover until it snaps securely in place.
• Check to make sure that the front panel cover is securely and properly in place.
6. Hold down the RESET, SET, and MODE buttons at the same time for about three seconds until everything
clears from the display.
7. Release the buttons.
• This causes “88888” to appear for about two second, and then the number of step screen appears.
• At this time the number of steps, distance, and calorie screens will all be “0”.
• The stride length and weight values are also reset to their initial defaults at this time. Perform the required
procedures to re-specify your stride length and weight.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
|