Audiovox Camera Accessories XM6 User Manual

XM6  
Owner’s Manual  
Use and Care  
In normal daily use, the TERK XM6 Outdoor Home Antenna is  
a rugged, high-performance antenna that does not require any  
special attention.  
Troubleshooting  
When a problem occurs with the installation of the XM6  
antenna the receiver will display one of the following error  
messages.  
ANTENNA  
The antenna is not connected properly.  
-Check and make sure that all the connections between  
the antenna, adapter and receiver are secure.  
NO SIGNAL  
XM signal is being blocked from reaching the XM antenna.  
- Keep in mind that the antenna needs to be in the line  
of sight with the XM satellites. The antenna needs to  
be located on the outside of your house or building  
with an unobstructed view of the open sky.  
Other Symptoms  
If there are issues with your receiver, please review the  
reciever owners manual. Should any problem persist with  
your antenna after you have made the above checks, call  
Audiovox at the number listed below.  
12 Months Limited Warranty  
AUDIOVOX ELECTRONICS CORPORATION (the Company) warrants to the original retail  
purchaser of this product that should this productor any part there of, under normal use  
and conditions, be proven defective in material or workmanship within 12 months from the  
date of original purchase, such defect(s) will be repaired or replaced with new or  
reconditioned product (at the Company's option) without charge for parts and repair labor.  
To obtain repair or replacement within the terms of this Warranty, the product is to be  
delivered with proof of warranty coverage (e.g. dated bill of sale), specification of  
defect(s), transportation prepaid, to an approved warranty station or the Company at the  
address shown below.  
This Warranty does not extend to the elimination of externally generated static or noise,  
to costs incurred for installation, removal or reinstallation of the product, damage to  
speakers, accessories, or vehicle and home electrical systems, malfunction of satellite  
transmissions, repeater signal or receiver unit.  
This Warranty does not apply to any product or part thereof which, in the opinion of the  
Company, has suffered or been damaged through alteration, improper installation,  
mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial  
number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS  
WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN  
NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY  
PURCHASER FOR THE PRODUCT.  
This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED  
WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL  
BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR  
BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF  
MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 48 MONTHS FROM DATE  
OF ORIGINAL PURCHASE. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY  
CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER  
WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. No person or representative is  
authorized to assume for the Company any liability other than expressed herein in  
connection with the sale of this product.  
Some states do not allow limitations on how long an implied warranty lasts or the  
exclusion or limitation of incidental or consequential damage so the above limitations or  
exclusions may not apply to you. This Warranty gives you specific legal rights and you  
may also have other rights which vary from state to state.  
U.S.A. : AUDIOVOX ELECTRONICS CORPORATION, 150 MARCUS BLVD., HAUPPAUGE,  
NEW YORK 11788 • 1-800-645-4994 CANADA : CALL 1-800-645-4994  
FOR LOCATION OF WARRANTY STATION SERVING YOUR AREA  
128-7351  
About XM Satellite Radio  
For more information about  
XM Satellite Radio service,  
To activate your XM service  
please call 1-888-539-7474  
For Customer Service  
Visit Our Website At  
For customer service and  
technical information::1.800.290.6650  
Product Information, Photos,  
FAQ’s, Owners Manuals  
XM6  
TERK and the TERK logo are registered trademarks of AUDIOVOX Corp.  
The XM name and related logos are trademarks of XM Satellite Radio Inc.  
Outdoor XM Satellite Radio Home Antenna  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
Installation  
Now that you have determined where to place the antenna,  
you have three different mounting options. Each option is  
described below.  
We recommend mounting the antenna on a roof as high  
up as possible as shown on page 4. The antenna should  
not be blocked by an obstruction like trees or a chimney.  
Once you have determined your mounting location, place  
the mounting bracket on that location on the roof. Take  
your drill and pre-drill holes, using a 3/32 drill bit, through  
the top two holes on the mounting bracket. Screw in two  
of the #10 screws included with this package, through the  
mounting bracket into the pre-drilled holes in the roof.  
Repeat this step for the bottom two holes. At this point,  
move onto the Adjustment section of the owner’s manual  
on page 6.  
Wall Mount  
Mast Mount  
or  
Please determine where to mount the antenna. Once  
the mounting location has been determined, take a  
pencil and mark through the bracket, onto the house  
wall, the four screw locations. Then set the mounting  
bracket down and pre-drill holes in the four locations  
you just marked (drill bit size 3/32 is recommended with  
#10 screws). Position the mounting bracket over the four  
pre-drilled holes and screw in the top two #10 screws,  
that are included with this package through the mounting  
bracket into the wall of the house. Then screw in the  
bottom two. At this point, move onto the Adjustment  
section of the owner‘s manual on page 6.  
The XM6 can be mounted to most masts. We recommend  
mounting the antenna to a mast on the roof or on the mast  
of a satellite TV dish. You will need the 2 U-bolts, 2 mount  
brackets and 4 nuts for this installation. Once you have  
determined where on the mast you wish to mount the  
antenna, place the mounting bracket in that location against  
the mast. Put one of the U-bolts through the top two holes  
on the mounting bracket. Take one of the mount brackets  
and insert it through the two ends of the U-bolt on the other  
side of the mast. Make sure the inside of the curve of the  
mount bracket is towards the mast. Using one hand to hold  
the mounting bracket and U-bolt bracket take your other  
hand and place one nut on one end of the U-bolt, then turn  
the nut four or five complete rotations and then place one  
nut on the other end of the U-bolt, turn the nut four or five  
complete rotations. Make sure the mounting bracket is in  
the desired location and tighten both nuts until the mounting  
bracket is secure on the mast. Before mounting the bottom  
U-bolt, please refer to the last step on the Cable Installation  
section on page 6. Repeat these steps for the second U-bolt.  
Once complete, move to the Adjustment section of the  
owner’s manual on page 6.  
Roof Mount  
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Adjustments  
Specifications  
To make sure the antenna is level please make the  
Electrical Specifications  
Antenna  
Frequency:  
Bandwidth:  
Impedance:  
adjustments to the antenna arm and the antenna radome.  
You will have to loosen the Phillips screws to rotate and  
adjust. Once the adjustment has been made to the desired  
position, tighten the Phillips screw. Be careful not to over  
tighten. We recommend that you make the adjustments,  
if needed, to each area in the order that is shown below.  
2332.5 to 2345 MHz  
12.5 MHz  
50 ohms  
Polarization:  
LHCP (Circular)  
LNA  
Gain:  
2
30 dB, typical  
1 dB, typical  
70 mA, maximum  
Noise Figure :  
Current Drain:  
Mechanical Specifications  
Antenna Dimensions:  
Radome:  
1
3 1/4” x 3 1/4"  
8”  
Arm Length:  
Mounting bracket:  
4 3/4" x 2 7/8”  
Cable Type:  
Cable Length:  
RG-6 coaxial (sold separetly)  
Up to 100 feet  
Cable Installation  
Connectors Antenna:  
Connectors Cable:  
Adapter:  
F connector  
F connector  
F connector to SMB  
At this point you are ready to attach the RG6 coaxial cable  
(sold separately). Take either end of cable and insert it  
through the rubber boot then screw the connector onto  
the bottom of the antenna as shown below. Screw the  
connector on by hand as far as it can go. It is not necessary  
to use any special tools for this.  
Mounting Hardware  
Nuts:  
Screws and U-Bolts:  
Weight including cable:  
Stainless Steel  
Stainless Steel  
1.75 lbs  
Once the cable is secured  
onto the antenna, slide  
the rubber onto the  
antenna as shown.  
For improved wire  
Other Specifications  
Temperature:  
-40 °F to +185 °F, operating  
Quality and Performance Tests  
XM Approved:  
management, the  
Per Specification  
coaxial cable can be  
inserted into a notch  
near the bottom of  
mounting bracket.  
RX000002H-010000  
At this point, please determine the best way to route the  
rest of the cable into your home to the XM home receiver  
or XM Plug & Play system.  
If additional cable length is required an in-line amplifer  
(XMAMP18) is needed for each additional 100 feet of  
RG6 coaxial cable.  
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.  

3M Projector S40C User Manual
Abocom Switch TC05 User Manual
Agilent Technologies Yogurt Maker 4291B User Manual
Allied International Digital Camera V240 User Manual
Amana Oven RS2320006 User Manual
Amana Refrigerator Amana 19 User Manual
Ambient Devices Marine Radio WS 0202 User Manual
American Standard Outdoor Shower 6032Y1SW User Manual
Ativa Paper Shredder LD100 User Manual
ATN Binoculars NVM 14 2 User Manual