TABLETOP SOLUTIONS
PNP515
PNP517
MANUAL PART NUMBER: 400-0464-003
PNP515, PNP517,
PNP527, PNP527C, PNP537,
CUSTOMIZABLE POP 'N PLUG®
WITH CUSTOM TABLETOP SURFACE
USER'S GUIDE
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
PRECAUTIONS / SAFETY WARNINGS
1
·
To turn off the main power, disconnect the
power cord which powers the AC socket on the
PNP515/517 pop-up panel. The power outlet
used should be installed as near to the
equipment as possible and should be easily
accessible.
Please read this manual carefully before using your
PNP515/517 Interconnect Box. Keep this manual
handy for future reference. These safety
instructions are to ensure the long life of your
PNP515/517 and to prevent fire and shock
hazards. Please read them carefully and heed all
warnings.
·
·
ALTINEX recommends using wall outlets with a
Ground Fault Circuit Interrupter (GFCI) for
maximum protection.
1.1 GENERAL
Install all cables according to the instructions. Do
not force or pull out any cable or power cord that
is attached to the PNP515/517.
·
Unauthorized personnel shall not open the unit
since there are high-voltage components inside.
·
Qualified ALTINEX service personnel, or their
authorized representatives, must perform all
service.
1.3 CLEANING
·
Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.4 FCC NOTICE
·
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
·
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
1.2 INSTALLATION PRECAUTIONS
·
For best results, place the PNP515/517 in a dry
area away from dust and moisture.
·
To prevent fire or shock, do not expose this unit
to water or moisture. Do not place the
PNP515/517 in direct sunlight, near heaters or
heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can
harm internal components.
equipment is operated in
a
commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his expense.
·
·
Handle the PNP515/517 carefully. Dropping or
jarring can damage the unit.
Never place fingers inside the openings of the
unit. This action could cause serious injury due
to sharp edges inside the PNP515/517.
·
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.
·
Do not place heavy objects on top of the
PNP515/517. Do not use excessive force to
push down on the top of the unit.
400-0464-003
2
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
ABOUT YOUR PNP515/517
2
TECHNICAL SPECIFICATIONS
3
Specifications are subject to change.
PNP515/517
Pop ‘N Plug with Custom Tabletop Surface
FEATURES/
PNP515/517
DESCRIPTION
·
·
·
·
·
·
·
Customizable to almost any table top
Several standard international configurations
Smooth new look on all sides
Cutout always matches table surface
Simple, slide-in installation
Inputs (female) /
Outputs (male)
PNP517
AC Power
Video
NEMA 5-15 (8)
15-pin HD (4)
3.5mm (4)
RJ-45 (4)
Opens/closes by pressing on top
Gas spring lift mechanism
Computer Audio
Network
This Pop ‘N Plug uses a custom tabletop cutout
surface, and hardware is attached underneath the
cutout. When closed, the PNP515/517 lays flat and
matches the grain on your table.
Modem
RJ-11 (4)
C-Video
RCA (2)
Compatibility
PNP515
The PNP515/517 design allows the connector
panels to be easily installed. Just remove the top
and slide the connector panels into place. In the
open position, the PNP515/517 is functional yet
maintains a smooth, clean appearance. A simple
press on the lid closes the unit flush with the
tabletop.
DS901-122 for UK,
Accepts DS901
STANDARD
sectional plates. *
DS901-123 for Australia,
DS901-124 for Germany,
DS901-128 blank,
DS901-130 for US
DS901-125 for UK,
DS901-126 for Australia,
DS901-127 for Germany,
DS901-131 for US
Accepts DS901
CONFIGURABLE
sectional plates. *
The PNP515 can be purchased with preconfigured
options available that include two standard
sectional plates.* Each plate includes one or more
of the following: AC power, computer video, stereo
audio, modem, or network connections. The AC
power receptacles on the face plates are available
with US or international connections.
Table 1. PNP515 General
MECHANICAL
Min. Table Thickness
Max. Table Thickness
Max. weight of custom top
Width
PNP515/517
0.750 in (19 mm)
1.125 in (29 mm)
22 oz (0.624 kg)
5.65 in (144 mm)
5.45 in (138 mm)
5.10 in (130 mm)
8.75 in (222 mm)
8.50 in (216 mm)
6.125 in (156 mm)
Matte Black
All connectors on the face plates are female
receptacles. Each signal connector is connected
via a 6-foot cable to its corresponding male plug at
the opposite end. The AC power cables are 9-foot
cords terminated with standard NEMA plugs for the
US version, or with the applicable plug for
international versions.
Depth
Height, opened
Height
Width
Depth
Finish
(below tabletop)
(below tabletop)
(below tabletop)
* See DIAGRAM 6 and DIAGRAM 7 for the
available standard plates on both US and
international units.
T° Operating
T° Maximum
Humidity
10°C-35°C
40°C
90% non-condensing
Table 2. PNP515/517 Mechanical
400-0464-003
3
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
ELECTRICAL
PNP515/517
Power Rating
(pass through AC power)
120VAC, 60Hz, 5A
Table 3. PNP515/517 Electrical
PRODUCT DESCRIPTION
4
Table Surface
RJ-45 (2)
RJ-11 (2)
Yellow RCA (1)
3.5 mm Stereo (2)
15-PIN HD (2)
AC Power (4)
Table Surface
Table Surface
NOTE:
One side of the PNP517 connector installation is shown in the above diagram. The
PNP517 has another of the same sectional plates facing the opposite side of the
table. Various combinations of connectors, along with the applicable cable types,
may be selected for customization at the time of purchase.
options and instructions.
400-0464-003
4
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
APPLICATION DIAGRAMS
DIAGRAM 1: TYPICAL SETUP
5
PNP517*
Notebook Computer
Floor box
Notebook Computer
* The PNP517 is shown as in the above diagram. The PNP517 is a standard configuration that includes the
PNP515 and two DS901-301 standard face plates.
400-0464-003
5
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
DIAGRAM 2: CUTOUT DIMENSIONS
5.650"
[144 mm]
5.450"
[138 mm]
5.850"
[149 mm]
5.650"
[144 mm]
DIAGRAM 3: CLOSED DIMENSIONS
3
9 ''
4
[248 mm]
3
8 ''
4
[222 mm]
400-0464-003
6
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
DIAGRAM 4: FRONT VIEW DIMENSIONS
TABLE THICKNESS
MIN. 3/4'' [19 mm]
MAX. 1 1/8'' [29 mm]
5 1/10''
[130 mm]
6 1/10''
[155 mm]
FRONT
VIEW
1
6 ''
8
[156 mm]
400-0464-003
7
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
DIAGRAM 5: SIDE VIEW DIMENSIONS
SIDE
VIEW
7
14 ''
8
[378 mm]
3
9 ''
4
[248 mm]
1
8 ''
2
[216 mm]
400-0464-003
8
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
DIAGRAM 6: STANDARD PLATES US & UK
DS901-130
DS901-131
Standard on PNP517 for United States.
PNP517C with configurable snap-ins.
DS901-122
DS901-125
Standard on PNP527 for United Kingdom.
PNP527C with configurable snap-ins.
400-0464-003
9
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
DIAGRAM 7: STANDARD PLATES AU & GR
DS901-123
DS901-122
Standard on PNP537 for Australia.
PNP537C with configurable snap-ins.
DS901-124
DS901-127
Standard on PNP547 for Germany.
PNP547C with configurable snap-ins.
400-0464-003
10
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLETOP SOLUTIONS
7.2 POWER/SIGNAL CONNECTIONS
INSTALLING YOUR PNP515
Step 1. Refer to the ALTINEX
6
Connect external devices to the appropriate
connector on the PNP. Remember, the devices
plugged into the AC power connectors should not
draw more than 5A AC.
website,
www.altinex.com, to download the latest
templates and instructions for tabletop
cutting requirements and installation
instructions.
TROUBLESHOOTING GUIDE
8
In order to do this, locate the PNP515 on
the website and go to its detail page. The
links to the templates, user’s guide, and
more are on the left-hand side of the
screen.
The PNP unit supplied was carefully tested and no
problems were detected. However, we would like to
offer the following suggestions:
·
Please make sure that the highest quality
network cables are used.
Step 2. Print all information applicable to the
installation of the PNP515, including the
templates and any detailed installation
instructions.
·
Make sure that no cable or power cord is
damaged or pinched. If there has been damage
to the unit, do not use the PNP. Please contact
ALTINEX at (714) 990-2300 to have the unit
repaired.
Step 3. Cut an opening into the table’s surface.
This operation should be performed by
experienced professionals in order to
insure accuracy and to be aesthetically
pleasing.
ALTINEX POLICIES
9
9.1 LIMITED WARRANTY/RETURN POLICIES
Please see the ALTINEX website at
www.altinex.com for details on warranty and
return policies.
NOTE: Always confirm dimensions before
cutting to insure that specifications have
not changed.
9.2 CONTACT INFORMATION
ALTINEX, Inc.
Step 4. Install the PNP515 into the table per the
installation instructions provided on the
website.
592 Apollo Street
Step 5. Connect all cables to their appropriate
sources and/or destinations. The PNP is
now ready for operation.
Brea, CA 92821 USA
TEL: 714 990-2300
TOLL FREE: 1-800-ALTINEX
WEB: www.altinex.com
E-MAIL: [email protected]
OPERATION
7
7.1 OPENING AND CLOSING THE PNP515
The PNP will open easily when the top is pressed
down and then released.
When the PNP is not in use, simply press the top
down until it is level with the surface of the table
and then release. The unit will remain hidden until
needed again.
400-0464-003
11
Download from Www.Somanuals.com. All Manuals Search And Download.
|