| Designer-Style Maestro® Remotes   HD-RD, -RS   120/127 V ~, 50/60 Hz   Installation Instructions   Please Read Before Installing   Overview   The HD-RD Remote Dimmer and the HD-RS Remote   Switch are for use with HomeWorks Maestro Dimmers and   Switches.   Up to nine HD-RD Remote Dimmers may be used with a   HomeWorks Wired or RF Maestro Dimmer, and up to nine   HD-RS Remote Switches may be used with a HomeWorks   Wired or RF Maestro Switch.   Important Notes   HD-RS   HD-RD   Codes: Install in accordance with all local and national elec-   trical codes.   Danger: These controls must not be used to con-   trol equipment which is not visible from every con-   trol location. They must also not be used to con-   trol equipment which could create hazardous situ-   ations such as entrapment if operated accidentally.   Examples of such equipment which must not be operated   by these controls include (but are not limited to) motorized   gates, garage doors, industrial doors, microwave ovens,   heating pads, etc. It is the installer’s responsibility to ensure   that the equipment being controlled is visible from every   control location and that only suitable equipment is connect-   ed to these controls.   Overheat Damage: To reduce the risk of overheating and   possibly damaging other equipment, do not install   to control receptacles or motor-operated appliances.   Environment: Ambient operating temperature:   0-40°C, 32-104°F, 0-90% humidity, non-condensing. Indoor   use only.   Spacing: If mounting one control above another, leave at   least 4 1/2" (114mm) vertical space between them.   Wallplates: Lutron Claro® and Satin ColorsTM wallplates are   recommended for best color match and aesthetic appear-   ance. Do not paint controls or wallplates.   Cleaning: To clean, wipe with a clean damp cloth. DO NOT   use any chemical cleaning solutions.   Wallboxes: Lutron recommends using 3-1/2" (89mm) deep   wallboxes for easier installation. Several controls may be   installed in one multigang wallbox - see Multigang   Installations (page 2).   Remotes: Use only Lutron® HomeWorks Maestro Remote   Dimmers (HD-RD) with HRD/HWD-6D, -6ND, -10D, -10ND,   and -5NE controls. Use only Lutron HomeWorks Maestro   Remote Switches (HD-RS) with HRD/HWD-8ANS controls.   Up to 9 HD-RD or HD-RS controls may be used with a   HomeWorks Maestro Dimmer or Switch. Mechanical 3- or 4-   way switches will not work.   1 Download from Www.Somanuals.com. All Manuals Search And Download.   Wiring Diagram 1   Multi-Location Installation1   -6D, -10D with HD-RD   Remote Dimmer   Black Red   Dimmer   Remote Dimmer   Hot   Black   Red   Black   Red   Lighting   Load   120/127VAC   50/60Hz   Green   Blue   Green   Blue   Green   Blue   Neutral   Wiring Diagram 2   Multi-Location Installation with Neutral1, 2   -6ND, -10ND, -5NE with HD-RD, -8ANS with HD-RS   Dimmer/   Switch   Remote   Dimmer/Switch   Remote   Dimmer/Switch   Hot   Black   Red   Black   Red   Black   Red   Lighting   Load   120/127VAC   50/60Hz   Green   Blue   Green   Blue   Green   Blue   White   Neutral   1 2 Up to 9 HomeWorks® Maestro® Remote Dimmers/Switches may be connected to the HomeWorks Maestro Dimmer/Switch. Total Blue   wire length may be up to 250' (76m).   Remote Dimmers/Switches must be connected on the Line side of a multi-location installation when used with Neutral wire Dimmers or   Switches.   3 Download from Www.Somanuals.com. All Manuals Search And Download.   Wiring Diagram 3   Installation with Power   Booster or ELV Interface1, 2   -6ND, -10ND with HD-RD   NGRX-PB   or   ELVI-1000   Remote   Dimmer   Dimmer   Red   Black   Red   Lighting   Load   Hot/Live   Black   120/127VAC   50/60 Hz   Green   Blue   Green   Blue   White   Neutral   Wiring Diagram 4   Installation with Fluorescent   Dimming Ballast Interface1, 2   -6ND, -10ND with HD-RD   Remote   Dimmer   Dimmer   FDBI-16A-120   Lutron® Hi-lume® Fluorescent   Dimming Ballast(s)   Red   Black   Red   Hot/Live   Black   Orange   Green   Blue   Green   Blue   120/127VAC   50/60 Hz   Black   White   White   Neutral   Wiring Diagram 5   Installation with Neutral and   Hi-Power Module1, 2   -6ND, -10ND with HD-RD   -8ANS with HD-RS   HP 2•4•6TM   Hi-Power Module   N3 H3 DH3 SH3   N2 H2 DH2 SH2   N1 H1 DH1 SH1   N N H H DH   1 2 3 Lighting   Load   Remote   Dimmer/Switch   Control   Dimmer/Switch   Load   Terminals   Terminals   Black   Red Black   N1 H1 DH1 SH1   N N H H DH   1 2 3 Red   Green   Green   Blue   White   Blue   Control Circuit   Load Circuit   1 Up to 9 HomeWorks® Maestro® Remote Dimmers/Switches may be connected to the HomeWorks Maestro Dimmer/Switch. Total blue   wire length may be up to 250 ft. (76m).   2 Remote Dimmers/Switches must be connected on the Line side of a multi-location installation when used with Neutral wire Dimmers or   Switches.   4 Download from Www.Somanuals.com. All Manuals Search And Download.   Local Operation   Lamp Replacement   Pressing the Tapswitch on any Dimmer, Switch, or   Remote will alternately turn the lights ON and OFF. For   HD-RD, the ON level will be the level previously set   using the Dimming Rocker. Press and hold the top or   bottom of the Dimming Rocker to raise or lower the light   level.   For routine lamp replacement, remove power from the   fixture(s) by sliding the Front-Accessible Service Switch   (FASS) to the OFF position (left). After replacing lamps,   slide the FASS back to the ON position (right) to restore   power.   Danger - For any procedure other than routine   lamp replacement, power must be disconnected   at the main electrical panel.   Double-tapping the Tapswitch on the HD-RD will turn the   lights ON to full. Pressing and holding the Tapswitch for   1/2 second (while ON) activates a 10-second long fade-   to-off.   Remote Dimmer Operation   Tapswitch   Tap on/off   Dimming Rocker   Press to Brighten   Press to Dim   FASSTM   Front   OFF   ON   Accessible   Service   Switch   Remote Switch Operation   Tapswitch   Tap on/off   FASS   Front   OFF   ON   Accessible   Service   Switch   5 Download from Www.Somanuals.com. All Manuals Search And Download.   Troubleshooting Guide   Symptom   Cause and Action   No lights at all   Power not present   • Circuit breaker OFF or tripped. Perform Short Circuit Check (see page 2).   • FASSTM in the OFF position. Move FASS to the ON position by sliding it to the right. Check both the   dimmer/switch and all of the remote dimmers/switches.   Wiring   • Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.   • Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.   Lamps burned out   • Replace lamps.   Dioded lamps   • If dioded lamps are being used, replace with non-dioded lamps.   Wiring   Lights turn ON when tap-   switch is pressed, then turn   OFF   • Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.   Tapswitch stuck   • Tapswitch stuck at another location. Check to see that tapswitches are not sticking for all control loca-   tions in the circuit.   Light turns ON and OFF con-   tinuously   Load is less than minimum load requirement   • Make sure the load connected to the dimmer or switch meets the appropriate minimum load require-   ment for that control. See Load Specifications in the Installation Instructions for the dimmer or switch.   Lights don’t switch when tap-   switch is pressed   Wiring   • Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.   • Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.   Lights don’t switch ON/OFF   when HD-RD or HD-RS tap-   switch is pressed   Wiring   • Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.   • Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.   Lights don’t switch ON/OFF   from Keypad   Improper programming   • Check programming in HomeWorks® Utility.   Wiring   • Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.   • Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.   6 Download from Www.Somanuals.com. All Manuals Search And Download.   Notes:   7 Download from Www.Somanuals.com. All Manuals Search And Download.   LIMITED WARRANTY   Lutron will, at its option, repair or replace any unit that is defective in materials or manufac-   ture within two years after purchase. For warranty service, return unit to place of purchase or   mail to Lutron at 7200 Suter Rd., Coopersburg, PA 18036-1299, postage pre-paid. Telephone   the Lutron Technical Support Center toll free at 800-523-9466. After the two year period, a   pro-rated warranty applies to this product until eight years after the purchase. For more infor-   mation regarding this warranty contact your Lutron representative.   THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND THE   IMPLIED WARRANTY OF MERCHANTABILITY IS LIMITED TO TWO YEARS FROM PUR-   CHASE. THIS WARRANTY DOES NOT COVER THE COST OF INSTALLATION,   REMOVAL OR REINSTALLATION, OR DAMAGE RESULTING FROM MISUSE, ABUSE,   OR IMPROPER OR INCORRECT REPAIR, OR DAMAGE FROM IMPROPER WIRING OR   INSTALLATION. THIS WARRANTY DOES NOT COVER INCIDENTAL OR CONSEQUEN-   TIAL DAMAGES. LUTRON’S LIABILITY ON ANY CLAIM FOR DAMAGES ARISING OUT   OF OR IN CONNECTION WITH THE MANUFACTURE, SALE, INSTALLATION, DELIVERY,   OR USE OF THE UNIT SHALL NEVER EXCEED THE PURCHASE PRICE OF THE UNIT.   This warranty gives you specific legal rights, and you may also have other rights which vary   from state to state. Some states do not allow limitations on how long an implied warranty lasts,   so the above limitation may not apply to you. Some states do not allow the exclusion or limi-   tation of incidental or consequential damages, so the above limitation or exclusion may not   apply to you.   Technical and Sales Assistance   If you need assistance, call the toll-free Lutron   Technical Support Center. Please provide exact   model number when calling.   (800) 523-9466 (U.S.A., Canada and the Caribbean)   Other countries call:   Tel: (610) 282-3800   This product may be covered by one or more of the following U.S. patents: 5,248,919;   5,399,940; 5,637,930; D353,798 and corresponding foreign patents. U.S. and foreign patents   pending. Lutron, Claro, Maestro, Hi-lume and HomeWorks are registered trademarks and   Satin Colors, HP 2•4•6, FASS and the HomeWorks Logo are trademarks of Lutron Electronics   Co., Inc.   Fax: (610) 282-3090   © 2003 Lutron Electronics Co., Inc.   Lutron Electronics Co., Inc.   7200 Suter Road   Coopersburg, PA 18036-1299   Made and printed in the U.S.A. 02/03 P/N 043-134 Rev. A 93-2605-02   Download from Www.Somanuals.com. All Manuals Search And Download.   |