®
NetVanta 3430 Router
P/N 1200820E1
Quick Start Guide
4. Once the unit is powered up, open a VT100 terminal session using the following settings:
9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the
AOS CLI.
GETTING STARTED
Two configuration methods are available for your NetVanta router:
•
•
Web-based GUI
5. Enter enable at the > prompt.
AOS Command Line Interface (CLI)
6. Enter the enable password when prompted. The default password is password.
The GUI lets you configure the main unit settings and provides online guidance and explanations
for each setting. However, using the AOS CLI may be necessary for more advanced
configurations.
The configuration parameters used in the examples outlined in this
document are for instructional purposes only. Please replace all
underlined entries (example) with your specific parameters to configure
your application.
ACCESS THE GUI
You may access the web-based GUI from any web browser on your network by following these
steps:
CONFIGURE THE UNIT’S IP ADDRESS
The following steps create an IP address and subnet mask for ETH 0/1. If you are not sure what IP
1. Connect the router to your PC using the ETH 0/1 port on the back of the unit.
2. Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’s IP address,
you will need to change the unit’s IP address using the CLI. (Refer to the next two sections for
instructions.)
address to assign, please contact your network administrator.
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for
3. Enter the unit’s IP address in your browser address line. The default IP address is 10.10.10.1.
the Ethernet port located on the rear of the unit.
4. You will then be prompted for the username and password (the default settings are admin
and password).
3. Enter ip address 10.26.12.12 255.255.255.0 to assign an IP address to the Ethernet port
using a 24-bit subnet mask.
5. The initial GUI screen appears.
4. Enter ip route 0.0.0.0 0.0.0.0 192.22.72.2 to add a default route to the route table. If
necessary, contact your network administrator to obtain the IP address (and subnet mask) for
your particular configuration.
ACCESS THE CLI
Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the
NetVanta router CONSOLE port, you need the following items:
5. Enter no shutdown to activate the interface to pass data.
6. Enter exit to exit the Ethernet interface commands and return to the Global Configuration
•
•
VT100 terminal or PC (with VT100 terminal emulation software)
mode.
Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate
interface for your terminal or PC communication port on the other end
Depending on your configuration, you may need to set a default gateway
as well using the (config)#ip default gateway command. If IP routing is
enabled on the unit, do NOT set a default gateway.
1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear
panel of the unit.
2. Connect the other end of the serial cable to the terminal or PC.
3. Provide power to the unit as appropriate. See the NetVanta 3000 Series Hardware Installation
Guide (provided on the ADTRAN OS System Documentation CD) for more details.
Quick Start Guide, 61200820E1-13A, July 2006
Technical Support 1-888-4ADTRAN (1-888-423-8726)
Download from Www.Somanuals.com. All Manuals Search And Download.
Copyright © 2006 ADTRAN, All Rights Reserved
|