GE 25866 User Manual

FCC RF Radiation Exposure Statement  
Model 25866  
This equipment complies with FCC RF radiation exposure limits set forth for an  
uncontrolled environment. This equipment should be installed and operated with  
a minimum distance of 20 centimeters between the radiator and your body. This  
transmitter must not be co-located or operated in conjunction with any other antenna  
or transmitter.”  
Two-Line  
Cordless Handset  
Quick Set-Up Guide  
For body worn operation, this phone has been tested and meets the FCC RF exposure  
guidelines when used with the belt clip supplied with this product. Use of other  
accessories may not ensure compliance with FCC RF exposure guidelines.  
CAUTION:  
RISKOFELECTRICSHOCK  
DONOTOPEN  
THE EXCLAMATION  
POINT WITHIN THE  
TRIANGLE IS A  
THE LIGHTNING  
CAUTION: TO REDUCE THE  
FLASH AND ARROW RISK OF ELECTRIC SHOCK, DO  
WARNING:TO  
HEAD WITHIN THE NOT REMOVE COVER (OR  
WARNING SIGN  
ALERTING YOU OF  
IMPORTANT  
BACK). NO USER  
PREVENT FIRE OR  
ELECTRICAL SHOCK  
HAZARD, DO NOT  
EXPOSETHIS  
TRIANGLE IS A  
WARNING SIGN  
ALERTING YOU OF  
“DANGEROUS  
VOLTAGE” INSIDE  
THE PRODUCT.  
SERVICEABLE PARTS INSIDE.  
REFER SERVICING TO  
QUALIFIED SERVICE  
PERSONNEL.  
INSTRUCTIONS  
ACCOMPANYING  
THE PRODUCT.  
PRODUCT TO RAIN  
OR MOISTURE.  
SEE MARKING ON BOTTOM / BACK OF PRODUCT  
Introduction  
CAUTION: When using telephone equipment, there are basic  
safety instructions that should always be followed. Refer to the  
IMPORTANT SAFETY INSTRUCTIONS provided with this product  
and save them for future reference.  
IMPORTANT: Because cordless phones operate on electricity, you  
should have at least one phone in your home that isn’t cordless, in  
case the power in your home goes out.  
Parts Checklist  
Make sure your package includes the items shown here.  
Handset  
battery pack  
Charge  
Cradle  
Battery  
compartment  
cover  
for use with Model 25865  
Belt  
clip  
Handset  
Interference Information  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following  
two conditions: (1) This device may not cause harmful interference; and (2) This device  
must accept any interference received, including interference that may cause undesired  
operation.  
Installing the Handset Battery  
NOTE: You must connect the handset battery before use.  
CAUTION: To reduce the risk of fire or personal injury, use only  
the Thomson Inc. appoved Nickel-Cadmium (Ni-Cd) battery  
model 5-2548, which is compatible with this unit.  
This equipment has been tested and found to comply with the limits for a Class B  
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses, and can radiate radio frequency energy and, if not  
installed and used in accordance with the instructions, may cause harmful interference to  
radio communications. However, there is no guarantee that interference will not occur in a  
particular installation.  
1. Locate battery and battery door which are packaged together inside a plastic  
bag and are separate from the handset.  
2. Locate the battery compartment on the back of the handset.  
3. Plug the battery pack cord into the jack inside the compartment.  
NOTE: To ensure proper battery installation, the connector is keyed  
and can be inserted only one way.  
Privacy of Communications may not be ensured when using this product.  
If this equipment does cause harmful interference to radio or television reception, which  
can be determined by turning the equipment off and on, the user is encouraged to try to  
correct the interference by one or more of the following measures:  
4. Insert the battery pack.  
5. Close the battery compartment by pushing the door up until it snaps into place.  
• Reorient or relocate the receiving antenna (that is, the antenna for radio or television  
that is “receiving” the interference).  
• Reorient or relocate and increase the separation between the telecommunications  
equipment and receiving antenna.  
Extra Charging Cradle  
1. Plug the AC power converter of the extra charging cradle into the electrical  
outlet.  
• Connect the telecommunications equipment into an outlet on a circuit different from  
that to which the receiving antenna is connected.  
2. Place the handset in the extra charging cradle. The charge indicator turns on,  
verifying the battery is charging.  
If these measures do not eliminate the interference, please consult your dealer or an  
experienced radio/television technician for additional suggestions. Also, the Federal  
Communications Commission has prepared a helpful booklet, “How To Identify and Resolve  
Radio/TV Interference Problems.” This booklet is available from the U.S. Government  
Printing Office, Washington, D.C. 20402. Please specify stock number 004-000-00345-4  
when ordering copies.  
3. Allow the phone to charge for 16 hours prior to first use.  
Registration  
YOU MUST REGISTER THE HANDSET TO THE MAIN BASE BEFORE USE!  
After the optional handset has charged for 16 hours on the extra charger, PLEASE  
REGISTER shows in the display.  
1. Make sure your phone is OFF (not in talk mode).  
Notice: The changes or modifications not expressly approved by the party responsible for  
compliance could void the user's authority to operate the equipment.  
2. Press the MENU soft key on the handset to go to the main menu.  
3. Use the 5 or 6 buttons to scroll to REGISTRATION.  
4. Press the SELECT soft key to confirm. PRESS AND HOLD PAGE BUTTON UNTIL  
BEEP shows in the display.  
Hearing Aid Compatibility (HAC)  
This telephone system meets FCC standards for Hearing Aid Compatibility.  
Thomson Inc.  
5. Press and hold the page button on base unit until you hear a long tone at the  
handset. HANDSET X REGISTERED shows in the handset display, where X is the  
handset number. You will hear a confirmation tone.  
If handset displays PLEASE REGISTER, press the OK soft key on the handset and  
repeat step 5 above.  
10330 North Meridian Street  
Model 25866  
00007947 (Rev. 1 Dom E)  
06-31  
Printed in China  
Indianapolis, IN 46290  
© 2006 Thomson Inc.  
Trademark(s) ® Registered  
Marca(s) Registrada(s)  

HP Hewlett Packard HP Ultra Slim LED LCD Monitor W2052A User Manual
Hotpoint G320GIX User Manual
Frigidaire FGEC3665KB User Manual
Fisher Paykel CP 484GG User Manual
Fisher Paykel Cooktop CG604DX User Manual
Elo TouchSystems Elo Entuitive 3000 Series 1529L User Manual
Daewoo DTQ 20V1FCN User Manual
Cypress STK11C88 User Manual
Black Box EXN37216 User Manual
Acer X233HZ User Manual