SGM304, SGM365, SGM466
30”, 36”, 46” Wide,
Preference™ Gas Cooktops
PLANNING
GUIDE
Revised
07/18/08
1/2
4" (102mm)
Chassis height
21"
(533mm)
All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted.
30"
(762mm)
1/4" (6mm) Min.
to combustibles
below chassis
Vertical
combustible
surface
Rear
wall
7 1/2" (191mm) Min.
to combustible
side wall above
the cooktop
3 1/8"
(79mm)
2 1/4"
(57mm) Min.
27 1/2"
(699mm)
(both sides)
4" (102mm)
21"
(533mm)
Chassis height
19 7/8" (505mm)
25" (635mm)
Minimum
36"
(914mm)
Cutout Dimensions for
Model SGM304
2"
(51mm) Min.
1/4" (6mm) Min.
to combustibles
below chassis
Vertical
combustible
surface
7 1/2" (191mm) Min.
to combustible
side wall above
the cooktop
Rear
wall
3 1/8"
(79mm)
(both sides)
33 3/4"
(857mm)
2 1/4"
(57mm) Min.
19 7/8"
(505mm)
25" (635mm)
Minimum
Cutout Dimensions for
Model SGM365
2"
(51mm) Min.
4" (102mm)
21"
(533mm)
46"
(1168mm)
Rear
wall
1/4" (6mm) Min.
to combustibles
below chassis
7 1/2" (191mm) Min.
to combustible
side wall above
the cooktop
Vertical
combustible
surface
(both sides)
3 1/8"
44 1/2"
(79mm)
(1130mm)
2 1/4"
(57mm) Min.
WARNING
19 7/8" (505mm)
25" (635mm)
Minimum
1. Observe all governing codes and ordinances
during planning and installation. Contact
your local building department for further
information.
Cutout Dimensions for
Model SGM466
2"
(51mm) Min.
2.
This appliance must be installed in accordance
with the accompanying installation
instructions.
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
4.9
|