|
BASIC OPERATING INSTRUCTIONS
NIGHT VISION II
NIGHT VISION II
LED Light
Functions
The Night Vision II makes use
of Light Emitting Diodes (LEDs) for its
flashlight and soft dial lighting. LEDs
last longer than conventional incandescent
bulbs, and are more durable and
energy-efficient.
Please note that the battery life of the lighting functions is
significantly reduced with greater use. To maximize battery
life, please turn lighting functions off when not in use.
Luminous hands and markers are activated by external
UV lighting.
Crown
Pusher
for Lighting
Functions
Locator
Beacon
Function
TIME AND DATE
To set time and date please refer to instructions for
Three Hand Analog Quartz.
Lighting Functions – Night Vision II
1. Dial Illumination Mode One quick push
of the pusher will activate the soft LED light
for 5 seconds. The angle of the light directs it to
reflect off the crystal for maximum visibility of
1.
the dial and hands.
2. Extended Light Mode Two quick pushes of
the pusher will activate the LED flashlight for
2 minutes. Light will automatically deactivate,
or you can turn the light off by pressing the
pusher once.
Pusher
3. Signal Mode Three quick pushes of the pusher
will cause the light to strobe for 2 minutes. To
deactivate, press pusher once.
4. Intense Signal Mode Holding the pusher for 5
seconds will activate an intensified LED strobe
that flashes continuously. Intense Signal Mode is
brighter than normal Signal Mode flashing. To
deactivate, press pusher for 5 seconds.
2.
5. Locator Mode Red LED locator beacon is
positioned at the 6 o’clock marker and
blinks once every 10 seconds. An easy way
to find your timepiece.
Pusher
6. Battery End of Life Mode Red LED locator
beacon positioned at the 6 o’clock marker will
flash 3 times every 10 seconds indicating
lighting batteries should be changed.
Your Night Vision II timepiece has a built-in feature to protect battery
consumption if the pusher used to operate the LED is accidentally pressed
(for example in luggage or coat pocket, etc.). If the pusher is pressed for
more than 30 consecutive seconds, the lighting feature will shut off
automatically.
Batteries for Light Function – Night Vision II
The lighting modules of your Night Vision II timepiece
operate off of a separate battery power source than the timepiece
movement itself (1 battery cell). Batteries for light function are:
Night Vision II – one 3 volt 2032 Lithium
Please use an authorized Victorinox Swiss Army service center in the event
either the light module or timepiece battery require replacement.
BATTERY
Worn Batteries should be replaced immediately. Substituting interchangeable
batteries is not recommended. Battery change should be performed by a
qualified technician who should also check the condition of the gaskets and
the o-ring at the same time. Battery is not covered by the warranty.
|