Soundstream Technologies G7170 User Manual

Keep in a safe and dry place for future reference.  
Model Number of your woofer  
Serial Number  
Place of purchase  
Notes  
PICASSO COMPONENT SYSTEM  
OWNERS MANUAL/INSTALL GUIDE  
Soundstream Technologies  
1550 S. Maple Ave.  
Montebello, CA 90640 USA  
PH: 323.724.4600 FX: 323.722.8125  
Specifications  
Mid-bass Installation  
Determine the mounting location. Factory speaker locations are  
Impedance  
4 ohms  
50Hz - 20KHz  
89dB  
recommended for ease of installation. When installing in the factory  
speaker locations, make sure that there is enough depth to  
accommodate the replacement speaker.  
Freq.Response  
Sensitivity  
If an alternate locations is used, measurements should be carefully  
taken before any cutting is done to insure that there is enough depth  
and to make sure that the speaker will not interfere with any moving  
parts in the vehicle (i.e. window gears/braces, hood/trunk cables, etc.).  
Once the mounting location is decided upon, the grill-mounting ring  
can be used as a template to mark the hole and screw locations. If the  
panel that the speaker is to be mounted to can be removed, then it is  
recommended that the panel be removed before cutting the speaker  
hole. Once the hole is cut to fit the speaker, replace the panel. If there  
is any metal obstruction the installation of the speaker, with top panel in  
place, mark the metal that needs to be removed and then remove it  
with tin snips or a saw.  
Power Watts (Rms/Peak)  
50Watts/100Watts  
Dimensions  
The wiring that is used should be at least 18 gauge to avoid possible  
signal loss. High quality crimp style connectors should be used to  
connect the wires to the speaker. Soldering wires directly to the speaker  
will void the warranty. If new wiring is necessary, make sure the route  
the wires under factory moldings to make the installation as neat as  
possible. In addition, make sure that the new wiring is clear of any screw  
or clip holes so that it will not be pinched or shorted to metal after  
factory panels and screws are replaced.  
Crossover Installation  
1. The crossover should be mounted in a dry, moisture free location. Never  
install the crossover in the door where it can be damaged by water and  
moisture. The crossover can be installed in the door panel as long as there  
is an undamaged vapor barrier.  
2. There are three sets of connections on the crossover. The Input terminals  
should be connected to the source of the signal (radio or amplifier). The  
woofer terminals should be connected to the midbass driver. The tweeter  
terminals should be connected to the tweeter. The tweeter volume can be  
set at -3dB, 0dB and +3dB. Ensure that the negative polarity wire of the  
tweeter is the one used for setting the tweeter volume level. Make sure  
that the polarity on all connections is correct.  
R3  
C3  
R4  
R2  
C1  
R1  
C2  
L2  
L1  
+IN PUT- WF+ WF- TW+ -3dB 0dB +3dB  

Vox VC 12 User Manual
Velodyne Acoustics FSR 15 User Manual
Tannoy Tanoy TS Sub User Manual
Star Manufacturing Peristaltic Heated Condiment Dispenser HPDE2H User Manual
Speco Technologies VM1701B User Manual
Sony XS A1025 User Manual
Sony HDW 750PC User Manual
Samsung VP D300 User Manual
Samsung HMX Q10BP User Manual
Samsung GR DF420 User Manual