Legacy Car Audio LCD89DFX User Manual

REMOTE CONTROL BASICS BATTERY REPLACEMENT:  
1.Remove the battery holder as the direction indicated by the arrow.  
2.Replace the battery Set a new battery property with (+)side up.  
3.Insert the battery holder. Push in the holder to the original position.  
LEGACY  
NOTE ON BATTERIES:  
Old batteries must immediately be removed and disposed.  
LCD89DFX  
BATTERY INFORMATION:  
Designated Battery: CR 2025 3V  
Battery Life: 6 months with normal use (in normal room temperatur)  
INSTRUCTION MANUAL  
CAUTION:  
Improper use of batteries may cause overheating, explosion or ignition. Resulting in  
jury or fire .Battery leakage may cause damage to the unit.  
Do not disassemble or short the batteries. Do not throw the batteries into the fire.  
To avoid the risk of accident, keep the batteries out of reach of children.  
1. LOCAL/DISTANCE BUTTON  
If you findthe receiving signal is weak andthere is the  
word LOC displayed on LCD whenyou tune fordistance  
station, firstly press the button todisappear the word  
LOC on LCD, then tune againfor the distancestation.  
If you findthe interference to the receiving signal is very  
strong and there is not theword LOC displayed on LCD  
when you tunefor local station, firstly press the button to  
display the word LOC on LCD, then tune again for the local  
station.  
2. LOUDNESS BUTTON  
Press it to enhance the basssound effect immediately  
when the volumelevel is reduced to below halflevel.  
AUTO-LOADING COMPACT DISC PLAYER  
AND AM/FM-STEREO DIGITAL PLL TUNING RADIO  
ANTI-THEFT FLIP DOWN DETACHABLE FRONT PANEL  
WITH INFRA-RED REMOTE CONTROLLER  
DISC PLAY:  
LOCATION AND FUNCTION OF CONTROLS  
Cleaning discs  
Before playing, clean the disc with a clean, lint-free cloth.  
Wipe the disc in the direction of the arrow.  
NOTE:  
. Do not use so solvents such as benzine, thinners. Commercially available  
cleaners or anti static spray damage the unit.  
Insert a disc with the label surface down. Doing so may damage the unit.  
Label  
surface up  
1. V-SEL/MENU/(SEL) AND V-UP/DN, MENU-UP/DN(+/-) BUTTONS  
1).Press SEL button shortly and repeatedly to select sound mode VOLUME,  
BASS(without preset DSP), TREBLE(without preset DSP), BALANCE and  
FADER, then press + or - button to adjust level of the selected sound mode.  
NOTE:  
. Do not try to insert another disc when one has been already inserted.  
Doing so may damage the unit.  
.Handle the disc by its edge. And to keep the disc clean, do not touch  
2).Press SEL button hold for more than 1 second to turn on MENU mode,  
and the LCD will display DSP OFF/POP M/ROCK M/CLASS M/FLAT M,  
then press SEL button shortly and repeatedly to select BEEP ON/BEEP  
OFF, SEEK1/SEEK2, VOL LAST/VOL ADJ(When it is in VOL ADJUST mode,  
the next mode will be A-VOL after VOL ADJUST mode, then you can adjust  
the volume level) in the sequence and circulation. After select the desired  
MENU mode, press + or - button to select the mode of the selected MENU.  
the surface.  
2. OPEN BUTTON  
.Do not stick paper or tape on the disc.  
Press it to flip down the front panel and you can insert the disc  
into the CD compartment or press the EJ button to eject the disc  
from the disc compartment or take away the front panel.  
.Do not expose the disc to direct sunlight or heat sources such as hot air  
ducts. Or leave it in a car parked in direct sunlight where there can be a  
considerable rise in temperature.  
9
2
3. LCD (LIQUID CRYSTAL DISPLAY)  
TROUBLE SHOOTING  
To solve the common problem, read the trouble shooting list. If you still can  
not solve the problem, consult your nearest service dealer.  
4. UP AND DN BUTTONS  
1)In RADIO mode, press ^ or v button shortly and repeatedly to  
manually tune up or down for the desired radio station with step by  
step. Press ^ or v button hold for more than 0.5 seconds to  
auto-matically tune up or down for the radio station of strong signal.  
2)In CD mode, press ^ button to play next track. Press v button  
once to play the current track from the beginning of the current  
track, press v button twice continuously to play the last track.  
Press ^ or v button hold to skip forward or backward.  
Symptom  
No power  
Cause  
Solution  
The car ignition is not on.  
If the power supply is properly  
connected to the car accessory  
switch the ignition key to " ACC "  
The fuse is blown  
Replace the fuse  
Disc cannot  
be loaded  
Presence of CD disc inside  
the player  
Remove the disc in the player  
then put a new upward  
5. AUTO-STORAGE/PRESET MEMORY SCAN BUTTON  
Inserting the disc in upside  
down  
Insert the compact disc with  
the label facing upward  
Disc cannot  
be read  
In radio mode, press it to perform all stations memory for 5 seconds  
each time, while memory digital and frequency will flash on LCD. If  
the button is pressed for more than 2 seconds, it will seek station  
on current band, then write to the preset memories. When the  
auto-storage operation is completed, it will automatically perform  
for 5 seconds each time. During the memory station performing,  
press 1-6 digital buttons to select and stop scanning function.  
Compact disc is extremely  
dirty or defective  
Clean the disc or try to play a  
new one  
Temperature inside the  
car is too high  
Cool off until the ambient  
temperature returns to normal  
Volume is in minimum  
Adjust volume to a desired level  
Check wiring connection  
Wiring is not properly  
connected  
No sound  
1.The built-in microcomputer  
is not operating properly  
due to noise  
2.Front panel is not properly  
fix into its place  
6. BAND BUTTON  
Press it repeatedly to select your desired radio band during RADIO  
mode.  
1. Press the RESET button  
2. Reinstall the front panel  
The operation  
keys do not  
work  
7. CLOCK BUTTON  
The installation angle  
is more than 30 degrees  
Adjust the installation angle  
to less than 30 degrees  
Sound skips  
Press CLK button to display time on LCD, then press CLK button  
hold until time flashes on LCD, thirdly press + or - button to adjust  
HOUR or MINUTE.  
The disc is extremely  
dirty or defective  
Clean the compact disc/try to  
play a new one  
The radio does  
not work  
the radio  
8. SCAN BUTTON  
Insert the antenna cable firmly  
select a station manually  
The antenna cable is not  
connected  
the signals are too weak  
Press it to scan up by one channel step with station detection. If a  
valid signal has detected, the current frequency is blinked within 5  
seconds, then press it again to stop scan and remain the current  
frequency; otherwise, the unit continue to scan up by one channel  
step with station detection 5 seconds later.  
station  
automatic  
selection does  
not work  
3
8
9. POWER BUTTON  
SPEAKER CONNECTION  
Press any button except the EJECT and OPEN button to turn on the  
unit, press PWR button hold for more than 0.5 seconds to turn off  
the unit.(After switching on the ACC POWER first time for 3 seconds,  
can only turn on the unit)  
ANTENNA PLUG  
YELLOW  
7 A  
AUX LINE IN  
RED R  
MEMORY B+  
FUSE  
10.STEREO/MONO BUTTON  
Press it repeatedly to select STEREO or MONO sound mode.  
WHITE L  
BLACK(GND)  
RED (B+)  
0.5 A  
FUSE  
RCA LINE OUT  
GRAY  
RED R  
WHITE L  
FRONT  
BLUE AUTO ANT  
+
+
11.MUTE BUTTON  
WHITE  
FRONT  
Press the button to eliminate or resume the sound immediately.  
To resume the sound immediately, can also press MODE, BAND, +,  
-, (LOUD) and SEL button.  
RIGHT  
SP  
WHITE/BLACK  
GREEN  
GRAY/BLACK  
VIOLET  
LEFT  
SP  
+
+
REAR  
REAR  
GREEN/BLACK  
VIOLET/BLACK  
12. PRESET STATION [ 1-6 ] AND TOP/CDP, INT, RPT, RDM BUTTONS.  
A].To memorize the current frequency, press any one of the six  
preset buttons hold for more than 2 seconds.  
NOTE:  
1. In spite of having any kinds of speaker system, must use 4 ohms  
impedance of speaker to reduce the distortion during high volume level.  
2. Prohibit to make the conductors of auto antenna and ground  
touch with each other.  
B].To recall the preset memory, press one of the preset buttons  
[1-6].  
C).In CDP mode, press TOP/CDP button to pause CDP playback,  
press it again to resume CDP playback. Press it hold for more  
than about 0.5 seconds to play the first track of the disc.  
D).In CDP mode, press INT button to play the first 10 seconds part  
of each track, press it again to stop INT mode and retain playing  
the track currently selected.  
E).In CDP mode, press RPT button to play the current track  
repeatedly. Press it again to cancel this mode.  
F).In CDP mode, press RDM button to play the track in random  
order. Press it again to cancel this mode.  
USA  
EUROPE  
IMPORTANT:  
This radio is set to USA frequency by factory, if European  
frequency is required please flip the frequency step switch on  
the side of the unit.  
13. MODE BUTTON  
Press it to select RADIO or CDP mode.  
After the switchover of the frequency switch, the frequency convert  
function will not be valid until the RESET button has been pressed.  
(The RESET button is in the rear facet of the front panel)  
14. INFRA-RED REMOTE CONTROLLING SENSOR  
7
4
INSTALLATION  
CAUTION: Do not install the detachable panel before connecting the wire.  
1. The unit is designed for negative terminal of the battery which is connected to the  
vehicle metal. Please confirm it before installation.  
2. If the car interior is extremely hot, as after being parked in the sun, do not use  
the player until the car has been driven for a while to cool off the interior.  
3. Press the OPEN button to flip down the front panel (see fig.1), then take away the  
front panel (see fig.2) and put it in the protective case (see fig.3) safe keeping.  
4. Install the front panel back into its bracket and then push it back to the position for  
playing (see fig.4).  
5
6

Plantronics 50 0230B 003 User Manual
Planar Systems Car Video System PT1745RPF User Manual
Pioneer GM D7400M User Manual
Pioneer Car Stereo System DEH 6400BT User Manual
Orion Car Audio P62 User Manual
Newcon Optik Phantom 150 User Manual
Metra Electronics 99 9103 User Manual
LG Electronics LCS500UN User Manual
Kenwood KAC 9152D User Manual
Kenwood Car Stereo System KDC U7056BT User Manual