Dual XD5110 User Manual

XD5110  
INSTALLATION/OWNERS MANUAL  
AM/FM/CD Receiver  
XD5110 INSTALLATION  
Installation  
TYPICAL MOUNTING METHOD  
3
XD5110 INSTALLATION  
Wiring  
Diagram  
Antenna  
Connector  
RCA Cable  
(sold separately)  
GRAY Rear Preamp Output  
Connect to amplifier RCA Input  
BLUE Remote Turn-On  
Connect to amplifier or power  
antenna. Insulate wire if not used.  
AMP  
BLACK Ground  
Connect to vehicle  
chassis ground.  
1 AMP  
AGC Fuse  
RED Accessory  
Connect to existing ignition  
circuit or switched 12 volt source.  
5 AMP  
AGC Fuse  
FUSES  
When replacing fuses,  
make sure new fuse is the  
correct type and amperage.  
Using an incorrect fuse  
could damage the radio.  
The XD5110 uses one 1  
amp AGC fuse (Ignition)  
and one 5 amp AGC fuse  
(Battery) located in-line.  
YELLOW Memory  
Connect to battery  
circuit or constant 12 volt source.  
Right Front  
Right Rear  
Violet/Black (-)  
Violet (+)  
Gray/Black (-)  
Gray (+)  
Left Front  
White/Black (-)  
White (+)  
Left Rear  
Green/Black (-)  
Green (+)  
* CAUTION - Do not attach any speaker leads to ground as severe damage will occur.  
4
XD5110 OPERATION  
Control Locations  
1
2
3
4
12  
10  
9
8
7
6
5
13  
11  
1
2
3
4
5
6
7
8
Power  
Play/Pause  
9
Volume  
Bass Boost/CD Random  
Mono/Stereo/CD Intro  
Reset  
10  
11  
12  
13  
Track Up/Down  
Eject  
Band  
Audio  
Display  
Tuning  
Local/Distance/CD Repeat  
5
XD5110 OPERATION  
General Operation  
Power On/Off  
Press PWR to turn the unit on. Inserting a CD will turn  
the unit on automatically. Press PWR to turn the unit off.  
CD Mode  
Insert a CD or press  
playback.  
/
II to begin or resume  
l
Tuner Mode  
Bass Boost  
Press PWR or BAND to begin or resume tuner  
operation.  
Press BASS to activate and deactivate bass boost  
curve. Activating this feature will enhance the bass  
frequencies when listening to music at low volumes.  
Volume  
Display  
Adjust volume using VOL or VOL(0-63).  
Press DISP to display the clock. The radio frequency  
(tuner mode) or CD track/elapsed time (CD player  
mode) show by default.  
Set the Clock  
Press and hold DISP until the clock begins to flash,  
then release. Press TRACK << to adjust the hours and  
TRACK >> to adjust the minutes. Press DISP  
momentarily to save the selected time.  
6
XD5110 OPERATION  
General Operation  
Reset  
Audio  
Press and hold for more than 2 seconds to RESET the  
unit upon initial installation or if abnormal opeartion  
occurs.  
Press AUD to select between Volume (default), Bass,  
Treble, Balance & Fader.  
Bass  
Treble  
Press AUD until BAS appears  
Press VOLUME or to adjust  
(7 maximum / -7 minimum)  
Press AUD until TRE appears  
Press VOLUME or to adjust  
(7 maximum / -7 minimum)  
Balance  
Fader  
Press AUD until BAL appears  
Press VOLUME (LEFT) or (RIGHT) to adjust  
(BA.L 10/BA.R 10) BAL 0 represents equal balance.  
Press AUD until FAD appears  
Press VOLUME (FRONT) or (REAR) to adjust  
(FA.F 10/FA.R 10) FAD 0 represents equal fader.  
7
XD5110 OPERATION  
Tuner Operation  
Tuning  
Turn TUNE knob to select desired station.  
FM Mono/Stereo  
Press MONO during FM tuner operation to select mono  
or stereo (default) reception of the broadcast signal.  
Local/Distance  
Band  
Press LOC to activate local tuning for strong station  
reception only. Press LOC again to cancel and resume  
Distance tuning (default).  
Press BAND to select between FM and AM bands.  
8
XD5110 OPERATION  
CD Player Operation  
With the label facing up, insert a standard CD into the  
CD slot. The CD will automatically begin playback.  
Insert CD  
Eject CD  
Press the EJECT button to stop and eject the CD. The  
unit will change to tuner mode. If the disc is not  
removed within 10 seconds, the unit will reload the  
disc.  
Press TRACK >> to skip to the beginning of the next  
track. Press TRACK << to return to the beginning of  
the current track. Pressing TRACK << again skips to  
the beginning of the previous track.  
Track Select  
Press and hold TRACK << or TRACK >> to fast  
Fast Forward  
and Reverse  
forward or reverse a track.  
Press  
Press  
/
/
II to temporarily stop CD playback.  
Pause  
l
l
II again to resume playback.  
Press INT to play the first 10 seconds of each track.  
Press INT to cancel.  
Intro  
Press RPT to continuously repeat selected track.  
Press RPT to cancel.  
Repeat  
Random  
Press RDM for more than 2 seconds to play all tracks  
in random order. Press RDM again for more than 2  
seconds to cancel.  
Some CD-Rs and CD-RWs may be incompatible with  
this unit, depending on media type and recording  
method.  
CD-R/CD-RW  
Compatibility  
9
XD5110 WARRANTY  
Limited One-Year Warranty  
This warranty gives you specific legal rights. You  
may also have other rights which vary from  
state to state.  
installation/removal costs, damage resulting  
from accident, misuse, abuse, neglect, product  
modification, improper installation, incorrect  
line voltage, unauthorized repair or failure to  
follow instructions supplied with the product, or  
damage occurring during return shipment of the  
product.  
Namsung America Inc. warrants this product to  
the original purchaser to be free from defects in  
material and workmanship, under normal  
conditions, for a period of one year from the  
date of the original purchase.  
What to do? If the product requires warranty  
service, you must prepay the initial shipping  
charges. DUAL will pay the return shipping  
charges if the product is returned to an address  
within the USA.  
Namsung America agrees, at our option, during  
the warranty period, to repair any defect in  
material or workmanship or to furnish an equal  
new or renewed product in exchange without  
charges, subject to verification of the defect or  
malfunction and proof of the date of purchase.  
Namsung America Inc.  
Attn: Returns Center  
21318 64th Ave. South  
Kent, WA 98032 U.S.A.  
Toll Free: 1-866-626-7863  
During the One-Year Warranty Period: For One  
Year from the date of purchase, your product  
will be replaced with a new, renewed or  
comparable product (whichever is deemed  
necessary) if it becomes defective or  
inoperative. This is done without charge to you.  
Replacement products are warranted for the  
balance of the original warranty period.  
Exclusion of Certain Damages: This warranty is  
exclusive and in lieu of any and all other  
warranties, expressed or implied, including  
without limitation the implied warranties of  
merchantability and fitness for a particular  
purpose and any obligation, liability, right, claim  
or remedy in contract or tort, whether or not  
arising from the company’s negligence, actual  
or imputed. No person or representative is  
authorized to assume for the company any  
other liability in connection with the sale of this  
product. In no event shall the company be liable  
for indirect, incidental or consequential  
damages.  
Who is covered? This warranty is extended to  
the original retail purchaser for products  
purchased and used in the U.S.A., in the 48  
contiguous states ONLY.  
What is covered? This warranty covers all  
defects in material and workmanship in this  
product. The following are not covered:  
10  
XD5110 OPERATION  
Specifications  
CD Player  
FM Tuner  
Signal-to-noise: >86dB  
Frequency response: 20Hz-20kHz  
Channel separation @ 1kHz: >65dB  
D/A converter: 1 Bit  
Tuning range: 87.5MHz-107.9MHz  
Usable sensitivity: 12dBf  
50dB quieting sensitivity: 16dBf  
Stereo separation @ 1kHz: 40dB  
Frequency response: 30Hz-13kHz  
AM Tuner  
General  
Tuning range: 530kHz-1720kHz  
AM sensitivity: 30uV  
Frequency response: 80Hz-2kHz  
Total power output: 100 Watts Peak  
Power output: 25Wx4 @ 4 ohms, 14.4 VDC  
Operating voltage: 11-16 VDC, negative ground  
Speaker output impedance: 4~8 ohms  
Fuses: 1 amp fast blow AGC, 5 amp fast blow AGC  
Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm)  
Design and specifications subject to change without notice  
11  
XD5110 OPERATION  
Troubleshooting  
Problem  
Cause  
Action  
Yellow or red wire not connected or Check connections for proper  
Unit will not  
turn on  
incorrect voltage  
voltage (11~16VDC)  
(no power)  
Black wire not connected  
Fuse blown  
Check connection to ground  
Replace fuse  
Speaker wires not connected  
Check connections at speakers  
Unit has power  
(but no sound)  
One or more speaker wires touching Insulate all bare speaker wires  
each other or touching chassis  
ground  
from each other and chassis  
ground  
Yellow or red wire touching chassis Check for pinched wire  
ground  
Unit blows  
fuses  
Speaker wires touching chassis  
ground  
Check for pinched wire  
Incorrect fuse rating  
Use fuse with correct rating  
Unit is not mounted correctly or  
backstrap is not secure  
Check mounting sleeve and  
backstrap support  
Excessive  
skipping  
Physical defect in media  
(CD, CD-R or CD-RW)  
Check media for scratches  
Load/Eject operation error  
Press eject or RESET  
Err appears on  
display  
Namsung America Inc.  
21318 64th Ave. South  
Kent, WA 98032  
Toll Free: 1-866-626-7863  
©2004 Namsung America, Inc.  
EVOK0104-V02  

Alpine CDE 123 User Manual
ASA Electronics MSR4050G User Manual
Blaupunkt HANNOVER CR 67 User Manual
Braun MULTIQUICK 5 MR 530 SAUCE User Manual
Casio Scientific Calculator fx 85ES User Manual
Directed Electronics 250 User Manual
FujiFilm 16130716 User Manual
HP (Hewlett Packard) HP Monitor LE1901w User Manual
Infinity Systems Inc Car Speaker 40 2CS User Manual
JL Audio Stealthbox MX 650 User Manual