STEP3 Point the remote control toward
the TV and enter the three-digit
code from the code table. If
there is more than one code
number assigned to your TV
brand, try one code number at a
time until the TV turns off right
after you entered the number.
*Tip: Red light will blink twice
Instructions
Operating Manual
for 2 in 1 Cable TV
Remote Control
This remote control is preprogrammed
to operate CABLE Box.
The [
] button sends out the TV
and CABLE power commands if you
Please program it for your TV by
following the instructions shown below.
press the [
] button.
To return to the original function, press
the [CH-] button in the STEP2 .
Batteries
UR-J550TVE
B. Recalling the TV Three-digit code :
The remote control uses AAA batteries.
Please be sure to match the batteries
Searching Method
STEP1 Press [TV POWER] and [MUTE]
buttons simultaneously until the
red light is on.
Press [CH +] button and hold until the
TV turns off. As soon as the TV turns
off, release [CH+] button.
+
-
with the ( ) and ( ) markings inside the
battery compartment during installation.
STEP2 Press [VOLUME-] button.
*Tip : You can confirm the power off and
The red light will blink a number of
times indicating the number of each
digit of the code. Each digit is
separated by one second interval of
red light being off.
on by pressing [MUTE] button.
STEP4 Press [TV POWER] button to
store the three-digit code.
Install two AAA alkaline
batteries as shown here
*Tip: Red light will blink twice.
*Tip: One blink, three blinks and 10
blinks, indicates the code
number 130.
Three-digit code :
Set-up for your VOLUME control
The remote control is preprogrammed to Helpful hints
Press arrow gently &
pull down to remove cover
control VOLUME and MUTE functions
Set-up for your Cable Box
through your TV. To switch VOLUME and
MUTE functions to your Cable Box:
The remote control is preprogrammed
to control your cable box. If it does
not work properly, please set-up the
right code by using the three-digit
code or searching method.
STEP1 Press [
] and [MUTE]
Programming your remote control
Setup for your cable box
buttons simultaneously until
red light is on.
No setup is required. The remote control is
preprogrammed to operate your cable box.
If you have a TV with a remote
control, we recommend that you plug
its power cord directly into a wall
outlet if available (your cable installer
may select an alternate setup)
STEP2 Press [VOLUME +] button.
STEP3 Press [
] button.
Setup for your TV
To return to the TV’s VOLUME, press
[TV POWER] button.
Find your TV brand and its three-digit
code on the back of this manual. If the
TV brand is not listed, please use the
Searching Method in STEP3 .
*Tip: Red light will blink twice.
Operation
If red light does not blink when
you press keys the operation is
intermittent:
Set-up for advanced functions
STEP1 Turn on your TV manually.
A. To turn on your TV and Cable at the
same time with
button:
*Tip : If you have RCA TV, don’t turn
Make sure the batteries are inserted
correctly.
Replace old batteries with two new
AAA batteries. Please do not mix old
batteries with new ones.
on the TV.
STEP1 Press [
] and [0] buttons
simultaneously until the red
light is on.
Universal Remote Control, Inc.
STEP2 Press [TV POWER] and [MUTE]
buttons simultaneously until the
red light is on.
OEE-0017D Rev 03(05/14/02)
STEP2 Press [CH +] button.
Download from Www.Somanuals.com. All Manuals Search And Download.
|