VPCS1 Series Optical Disk Drive
Replacement Instructions
IMPORTANT!
These easy instructions are intended to guide you through the replacement process.
ꢀ Before you begin, place your notebook computer on a clean or covered surface to avoid
damage to the computer's case.*
ꢀ Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
ꢀ Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface
of your notebook computer.*
ꢀ The appearance of the electronic components shown in the illustrations may be different from
the components shipped. This slight difference does not affect the accuracy of these
instructions.
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.
Battery
1.
Optical Disk Drive
Hard Drive Door
2.
Hard Drive Door
Prepare the Computer
3.
CAUTION: Make
sure
the
ODD Removal
Steps 3-8)
Lift to remove
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
(
Remove the Battery Pack
Step 3. Using the enclosed magnetic
1) Slide the left battery tab to the screwdriver, remove the two (2)
Step 2.
unlock position.
screws securing the Hard Drive Door.
Step 1. Place the computer upside
down on a protected surface with the
front edge facing you.
2) With your right thumb, slide the
right battery tab to the left and hold.
3) Lift the battery with your left thumb
using the notch at the bottom.
Put aside the Hard Drive Door
Screws to re-secure the Hard
Drive Door later in the procedure.
P/N 989201343
Rev. B
1/4
Download from Www.Somanuals.com. All Manuals Search And Download.
VPCS1 Series Optical Disk Drive
Replacement Instructions
R
B
Step 14. Position the new ODD
(Label side down) and identify the
correct bracket with the correct side to
be secured. Notice the different shape
of each bracket and the alignment of
the Bracket and ODD screw holes.
Step 13. Align the tabs on the bezel
with the tab holes located on the ODD.
Carefully press the bezel into place.
Note: Identify tabs on the bezel and tab
holes located on the ODD.
.
Step 15. Using the ODD screws, install NOTE: After installation, all brackets
the ODD Brackets onto the new ODD.
should sit flush. The stamped letters
located on the brackets should all be
facing the same direction.
.ODD Installation
(Steps 16-20)
Step 16. Align the ODD properly and
fully slide into the computer.
Step 19. Re-attach the Hard Drive Door
by sliding it towards the unit.
Step 17. Ensure that the new ODD is
seated flush on the edge of the
computer.
Step 18. Reinstall the two (2) ODD Bay
screws to secure the ODD.
P/N 989201343
Rev. B
3/4
Download from Www.Somanuals.com. All Manuals Search And Download.
VPCS1 Series Optical Disk Drive
Replacement Instructions
Step 21. Reinstall the battery pack and
AC Adaptor.
Power on your computer and continue
with the recovery process by following
the instructions described on the back
of the recovery disk’s case.
.
Return the old ODD to Sony
following the included
shipping instructions.
Step 20. Re-install the two (2) Hard
Drive Door Screws to secure the Door
P/N 989201343
Rev. B
4/4
Download from Www.Somanuals.com. All Manuals Search And Download.
|