Model A98KCS User Guide
Horn Mount for SM98 or WM98 Microphone
3. Insert the SM98 or WM98 microphone in the shock mount
holder by slipping the cable through the slot and sliding the
connector back through the opening until the protruding black
cable lock button is in the open slot and the back of the micro-
phone itself stops flush with the front of the holder. Only the sil-
ver metal segment of the connector is held by the holder. See
Figure 3.
GENERAL
The Model A98KCS Horn Mount is a versatile device that securely
attaches Shure SM98 or WM98 microphones to a horn, wind, or
reed instrument in the exact position desired while protecting the
instrument and its finish. The cushioned grip is manually tightened
and securely clamps the rim of the horn. Non-marking neoprene
rubber on the grip prevents marring the bell or its rim.
A short gooseneck (165 mm [6-1/2 in.]) attached to the clamp ter-
minates in a shock-mount adapter for the SM98 or WM98 micro-
phone. The gooseneck length can be adjusted to facilitate locating
the microphone in precisely the desired position in the bell of a
horn. A side screw locks the gooseneck in the chosen position.
MOUNTING
1. Attach the cushioned grip to the desired location on the bell of
the instrument and tighten the knurled top thumbscrew to hold
the clamp in place. See Figure 1.
INSERT SM98 IN HOLDER
FIGURE 3
4. Slip the cable through the slot in the cable guide (see Figure 4)
and route the cable away from the horn to prevent transmission
KNURLED
TOP SCREW
of noise and vibration through the cable
.
ATTACH CLAMP TO HORN
FIGURE 1
RETAIN CABLE IN GUIDE
2. Loosen the knurled side screw on the A98KCS and adjust the
length of the gooseneck intheclamp. Tightenthescrew.
SeeFigure 2.
FIGURE 4
5. Select the desired location of the microphone by bending the
gooseneck as required. If necessary re-adjust the gooseneck
length as described in step 2.
6. To prevent wind noise, use the windscreen supplied with the
microphone.
SIDE SCREW
USE SIDE SCREW TO ADJUST LENGTH OF GOOSENECK
FIGURE 2
NOTE: A supplied optional 1/16-inch setscrew and hex wrench can
be used to replace the side screw when repeated adjustments of
the gooseneck length are not required.
United States, Canada, Latin America, Caribbean:
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
Phone: 847-600-2000 U.S. Fax: 847-600-1212 Intl Fax: 847-600-6446
Europe, Middle East, Africa:
Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414
Asia, Pacific:
Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055
©2005, Shure Incorporated
27B2580 (Rev. 5)
Printed in U.S.A.
Download from Www.Somanuals.com. All Manuals Search And Download.
|