Seidio GPS Receiver G2350 User Guide

G2350  
Integrated GPS Car Kit for Treo 650  
1
Download from Www.Somanuals.com. All Manuals Search And Download.  
1. INTRODUCTION  
Congratulations on your purchase of one of the most  
advanced, GPS friendly devices ever created –  
Seidio’s G2350 car cradle for the Treo 650  
Smartphone. It has been developed from the ground  
up for both ease of use and maximum capability.  
From the custom fit of the cradle to your Treo 650 to  
the integrated SiRF Star III chipset, no compromises  
in features or quality have been made. We sincerely  
hope that you experience the same pleasure in using  
this device as we have had in creating it for you.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
2. DIAGRAM AND COMPONENTS  
Front of Cradle  
Back of Cradle  
Detachable Car Charger  
(See Section 5 for included mounting hardware)  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
3. INITIAL SETUP  
Hardware  
Step 1: Before you mount the cradle in your car, test to see that your Treo 650  
slides easily and snugly into the cradle.  
Caution: DO NOT force your Treo 650 into the cradle!  
Step 2: Choose a place and method to mount the cradle.  
Step 3: Insert the car charger into the 12V socket in your car and connect the  
other end to the cradle connector labeled “Power In” (See diagram for reference).  
Caution: DO NOT connect the power cable into the “DC Out”. Your  
G2350 is now ready to go!  
Step 4: By combining your cradle/Treo 650 with GPS navigation software, the  
built-in SiRF Star III GPS receiver can locate where you are and determine the  
best route to your intended destination.  
Make the following adjustments to your GPS software settings:  
COM port: COM1 or NMEA 0183  
Baud Rate: 4800  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
4. FEATURES  
4.1. 5V DC Out:  
Additional port for powering your Palm Bluetooth headset.  
Caution: DO NOT insert the power cable in DC Out. Doing so may cause damage to  
the cradle or the Treo 650!  
4.2. GPS:  
Built-in SiRF Star III GPS receiver attached via serial connector to your  
Treo 650.  
4.3. Mounting Solutions:  
Users can mount their cradles based on individual preferences with the  
included mounting products. Also included in this package is a 360  
degrees swivel adaptor to insure optimal driver/passenger viewing and  
readability.  
Note: It is normal for GSM phones to experience occasional interference. In areas with poor  
signal, interference may be higher. In areas with strong signal, interference may be lower.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
5. MOUNTING SOLUTIONS  
5.1 Installing the Air Vent Pedestal  
1) Slide the pedestal into your vehicle’s air vent and hook the locking clips  
onto the back of the vent.  
2) To secure the pedestal on the vent, squeeze the locking clips tightly  
and slide the locks toward the vent.  
3) Prop the hinged support arm against a firm base to securely angle the  
unit up. Now you are ready to slide the cradle onto the pedestal.  
5.2 Removing the Air Vent Pedestal  
1) Push the bottom of the locks and unhook the clips from the back of the  
vent.  
2) Pull back and now you should have removed the pedestal successfully.  
5.3 Using the Air Vent Pedestal + Swivel Adaptor  
1) Attach the pedestal to the back of the swivel adaptor by sliding it in.  
2) Slide your cradle onto the front of the swivel adaptor and you are ready  
for optimal viewing accessibility.  
5.4 Installing the Windshield Pedestal  
1) Match the pegs on the AMPS/Locking plate to the pedestal.  
2) Push hard on the AMPS/Locking plate until you hear a click.  
3) Slide the pedestal into the back of the swivel adaptor.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
4) Select a good spot on your windshield and press the suction cup firmly  
against it.  
5) Press down the latch to secure the suction cup. Slide your cradle on  
the swivel adaptor. Mounting Installation is now complete.  
6. SPECIFICATIONS:  
Power Input:  
12V-24V  
Input Power Cord: Detachable Car Charger, Hardwire Cable (Optional accessory)  
Output Voltage:  
5.2V ± 5%  
Output Current:  
800mAh (max)  
For more information and updates, visit our websites at www.seidioonline.com or  
www.seidio-europe.com. Our customer service representative will be more than  
happy to assist you with any questions.  
Thank you for purchasing from Seidio – we appreciate your business!  
Seidio, Inc.  
Rev. 1.1  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  

Q See DVR QS206 User Guide
Rosewill Network Card RC 301E User Guide
Rover Chipper 9859, 9862, 9848, 9858, 9885 User Guide
Runco Flat Panel Television CW 42HD User Guide
Samsung Computer Monitor UD22B User Guide
Samsung Printer 350 User Guide
Samsung Tablet GT P5210GNYXAR User Guide
Sanyo Battery Charger UF 2812 User Guide
Sears Lawn Mower 917258524 User Guide
Sennheiser Headphones HD 222 User Guide