■
USE ONLY BATTERY PACK PART NUMBER
1311148 or 130147008 WITH FLASHLIGHT MODEL
FL1200 AND PART NUMBER 1314702, 130224011
or 130224010 WITH MODEL FL1400. Any attempt to
use another battery pack will cause damage to your
flashlight and could possibly explode, cause a fire, or
personal injury.
OPERATOR'S MANUAL
CORDLESS FLASHLIGHT
■
REMOVE BATTERY PACK FROM FLASHLIGHT
BEFOREREPLACINGBULBORPERFORMINGANY
ROUTINE MAINTENANCE OR CLEANING.
MODEL NO. FL1200 (12 VOLT)
MODEL NO. FL1400 (14.4 VOLT)
Useonlywithrecommendedbatterypack
and charger (both sold separately)
■
■
DO NOT DISASSEMBLE YOUR FLASHLIGHT.
DO NOT PLACE FLASHLIGHT OR BATTERY PACK
NEAR FIRE OR HEAT. They may explode. Also, DO
NOT dispose of a worn out battery pack by incinerating.
Do not incinerate the battery, even if it is severely
damaged or completely worn out. The battery may
explode in fire.
■
■
DONOTSTOREYOURFLASHLIGHTINADAMPOR
WET LOCATION. DO NOT STORE IN LOCATIONS
WHERE THE TEMPERATURE IS LESS THAN 50°F
OR MORE THAN 100°F. Do not store in outside or in
vehicles.
DO NOT PERMIT CHILDREN TO USE FLASHLIGHT
UNSUPERVISED. It is not a toy. The temperature of
the bulb will become hot after being on for only a short
period of time. This hot temperature can cause burn
injury if touched and can create sufficient heat to melt
some fabrics.
WARNING:
If wrapped or in contact with fabric, the flashlight lens can
produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the flashlight lens to
come in contact with anything.
■
KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
■
■
AVOID DANGEROUS ENVIRONMENT.
KEEP LIGHT DRY, CLEAN, AND FREE FROM OIL
AND GREASE. Always use a clean cloth when clean-
ing. Never use brake fluids, gasoline, petroleum-based
products or any strong solvent to clean your flashlight.
WARNING:
Do not connect your flashlight to a battery until you have
read and understood all precautions and operating
instructions in the manual and printed on battery and
charger.
■
■
STAY ALERT. Watch what you are doing and use
common sense. Do not rush.
CHECK DAMAGED PARTS. Before further use of this
flashlight, a part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function. Do not use flashlight if it
does not function properly.
RULES FOR SAFE OPERATION
READ ALL INSTRUCTIONS
IMPORTANT SAFETY RULES FOR BATTERY
TOOLS
■
KNOWYOURFLASHLIGHT. Readoperator'smanual
carefully. Learn its applications and limitations as
well as the specific potential hazards related to this
flashlight.
■
USE ONLY THE CHARGER RECOMMENDED FOR
USE WITH YOUR FLASHLIGHT. Do not substitute
any other charger. Use of another charger could cause
batteries to explode causing possible serious injury.
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION
CHARGING YOUR FLASHLIGHT
The battery pack and charger are not included with this
flashlight. They are both sold separately. If you decide to
purchase a battery pack and charger, request recommended
battery pack part number 1311148 or 130147008 for Model
FL1200 and battery pack part number 1314702, 130224010
or 130224011 for Model FL1400. Request one of the follow-
ing chargers: charger part number 1411141 or 140120005
for Model FL1200. Request charger part number 1412001
for Model FL1400.
CAUTION:
When placing battery pack in your flashlight, be sure raised
ribs on battery pack aligns with groove inside flashlight
handle and latches snap in place properly. Improper
assembly of battery pack can cause damage to internal
components.
■
To remove battery pack, locate latches on end of bat-
tery pack and depress to release battery pack from
your flashlight.
TO CHARGE BATTERY PACK:
■
Charge battery pack only with the charger recom-
mended.
■
Make sure power supply is normal house voltage,
120 Volts, 60 Hz, AC only.
■
■
Connect charger to power supply.
Place battery pack in charger then press down on
battery pack to be sure contacts on battery pack en-
gage properly with charger contacts.
■
Red light should turn on.
CHARGING WITH CHARGER PART NUMBER 1412001,
1400656, 1400677 or 140120005.
■
When battery pack is fully charged, the red light will
turn off and the green light will turn on.
LATCH
■
After normal usage, 1 hour of charging time is required
to be fully charged. A minimum charge time of 1-1/2
hours is required to recharge a completely discharged
battery pack.
BATTERY
PACK
CHARGING WITH CHARGER PART NUMBER 1411141.
■
After normal usage, 3 hours of charging time is re-
quired to be fully charged. A minimum charge time of 6
hours is required to recharge a completely discharged
battery pack.
DEPRESS LATCHES TO
RELEASE BATTERY PACK
TO INSTALL/REMOVE BATTERY PACK
See Figure 1.
Fig. 1
■
■
Begin with a fully charged battery pack.
Orient battery pack so that raised rib on battery pack
aligns with groove inside flashlight. Battery pack is
designed to fit only one way in flashlight handle.
■
Insert battery pack, making sure latches on each side
of battery pack snap in place and battery pack is se-
cure in flashlight before use.
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION
SWITCH
See Figure 2.
To turn your flashlight on and off, depress switch trigger.
180° ROTATING HEAD
See Figure 2.
Your flashlight has the feature of rotating the head 180°
back and forth.
BULB REPLACEMENT
See Figure 3.
SWITCH
TRIGGER
When purchasing replacement bulb, request recommended
part number 973638-001 for Model FL1200 and part number
981258-003 for Model FL1400.
180° ROTATING HEAD
TO REPLACE BULB:
■ Remove battery pack from flashlight.
■ Remove lens cover by turning cover in counterclockwise
direction, then remove cover.
■ Remove old bulb from spring.
■ Position new bulb in spring.
■ Replace lens cover.
Fig. 2
■ Replace battery pack.
Note: For your convenience, your flashlight has a spare
bulb storage area. It is located behind the lens cover.
See Figure 3.
BULB STORAGE
AREA
BULB
LENS COVER
Fig. 3
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
MAINTENANCE
DO NOT abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part may create a hazard or cause
product damage.
WARNING:
Do not attempt to modify this tool or create accessories
notrecommendedforusewiththistool.Anysuchalteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
BATTERIES
DISPOSAL OF THE EXHAUSTED BATTERY
Your flashlight's battery pack is equipped with nickel-
cadmium rechargeable batteries. Length of service from
each charging will depend on the type of work you are
doing.
To preserve natural resources, please
recycle or dispose of properly.
This product uses nickel-cadmium
batteries. Local, state or federal laws may
prohibit disposal of nickel-cadmium
batteries in ordinary trash.
The batteries in this tool have been designed to provide
maximum trouble free life. However, like all batteries, they
will eventually wear out. DO NOT disassemble battery
pack and attempt to replace the batteries. Handling of
these batteries, especially when wearing rings and jewelry,
could result in a serious burn.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
For more information on battery recycling call 1-800-
8BATTERY.
To obtain the longest possible battery life, we suggest the
following:
■
Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery life.
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Nickel-cadmium batteries must be
recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children.
Failure to comply with these warnings could result in
fire and/or serious injury.
■
■
Never store batteries in a discharged condition.
Recharge them immediately after they are discharged.
All batteries gradually lose their charge. The higher
the temperature the quicker they lose their charge. If
you store your tool for long periods of time without
using it, recharge the batteries every month or two.
This practice will prolong battery life.
WARNING:
Do not attempt to disassemble the battery pack. Fire or
injury may result.
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATOR'S MANUAL
CORDLESS FLASHLIGHT
MODEL NO. FL1200 (12 Volt)
MODEL NO. FL1400 (14.4 Volt)
• SERVICE
Now that you have purchased your tool, should a need ever exist for repair parts or service,
simply contact your nearest Ryobi Authorized Service Center. Be sure to provide all
pertinent facts when you call or visit. Please call 1-800-525-2579 for your nearest Ryobi
complete list of Authorized Service Centers.
• MODEL NO. AND SERIAL NO.
The model number of this tool will be found on a plate attached to the motor housing.
Please record the model number and serial number in the space provided below.
• HOW TO ORDER REPAIR PARTS
WHEN ORDERING REPAIR PARTS,
ALWAYS GIVE THE FOLLOWING INFORMATION:
• MODEL NUMBERS FL1200 / FL1400
• SERIAL NUMBER
RYOBI TECHNOLOGIES, INC.
1428 Pearman Dairy Road, Anderson, SC 29625
Post Office Box 1207, Anderson, SC 29622-1207
Phone 1-800-525-2579
972000-696
9-03
Download from Www.Somanuals.com. All Manuals Search And Download.
|