SERVER RSV-L4500
User Manual
Hard Drive Rail Installation
1.
Each Hard drive requires using 2x HDD rail on
each side.
2.
When alighting the HDD rail with Hard drive,
please make sure that both pin on each rail will
be insert into the hard drive’s screw holes.
3.
The HDD rail should look like this when place
correctly with Hard Drive.
(Note: Please do not fasten screw on HDD Rail and
Hard Drive at this stage, otherwise you will not be
able to slide the HDD rail into the module)
4.
5.
When sliding into the HDD module, please
make sure that the connector of the hard drive
is facing outside and the rails are pushed all
the way until click into the module.
You can then lock the hard drive with the screw
after the HDD rail is pushed all the way into the
module and locked.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
