Radio Shack Stud Sensor 49 1001 User Guide

initializing your sensor  
registering your sensor  
49-1001  
1. Use a screwdriver to loosen the screw and  
remove the front of the sensor.  
1. Press and hold down TEST on the sensor for  
3-4 seconds, and then release it. The green  
LED blinks twice.  
Wireless Security  
Door/Window Sensor  
This wireless door/window sensor only works  
with your Wireless Security Kit (49-1000). Your  
Wireless Security Kit includes two sensors.  
Purchase up to 28 additional (30 total) sensors  
to expand and protect all 30 system zones.  
You can add additional door/window sensors  
and additional motion detectors, as long as the  
additional units do not exceed 30 (number of  
zones in your system). Refer to your 49-1000  
user guide for more information on adding  
motion detectors and door/window sensors to  
your wireless system.  
Note: If you need to register the sensor a  
second time, remove the batteries, and then  
hold down TEST for 3-4 seconds to pick up a  
random code.  
DELAY MIN/MAX  
2. Replace the cover.  
TEST  
3. Place the magnet next to the sensor, with  
their arrows aligned.  
2. Insert two AAA batteries (not supplied).  
3. After you replace the batteries, place the  
magnet next to the sensor then move it  
away. If the system does not chime, you  
must register the sensor again. To register  
the sensor, follow steps 1 thru 6 on page 1.  
The sensor jack allows you to hardwire an  
extra magnetic switch for additional door/  
window protection.The sensor must be within  
100 feet of the console to operate properly.  
If the sensor stops working properly, or PROBLEM  
appears on your console’s display, replace the  
sensor’s batteries.  
• Dispose of old batteries promptly and properly.  
Do not burn or bury them.  
sensor  
4. Press menu start or on your system  
console. ENTER PIN (Personal Identification  
Number) appears on the display.  
• Use only fresh batteries of the required size and  
recommended type.  
5. Use the console keypad to enter your four-  
digit PIN. * appears on the display as you  
press each digit. After you enter your PIN,  
1. INSTALL appears.  
• Do not mix old and new batteries, different  
types of batteries, or batteries of different  
capacities.  
wall anchors (2)  
screws (2)  
6. Press ok and 1. INSTALL / ZONE appears.  
what’s included  
7. Move the magnet away from the sensor. The  
console chimes and ZONE 1 SET appears on  
the display to confirm registration.  
sensor  
magnet  
wall anchors (2)  
magnet  
screws (2)  
8. Press clear to navigate backwards through  
the console menu options. Press 1 to return  
to the main display, press 2 to stay in install  
mode and register additional sensors.  
Please read this user’s guide before  
installing, setting up and using your new product  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Radio Shack Radar Detector 22 1697 User Guide
RCA VCR VG4038 VG4039 User Guide
ResMed Video Gaming Accessories POWER STATION II User Guide
Rotel Stereo Amplifier RB1090 User Guide
RSA Lighting Indoor Furnishings 40 DHWH User Guide
Ryobi Drill D130VR User Guide
Samsung Speaker System HW F355 User Guide
Samsung Tablet Tablet User Guide
Samsung TV Receiver SIR TS160 User Guide
Scientific Atlanta Network Card DPR300 Series User Guide