PLCD34
INSTRUCTION MANUAL
OPEN
FLIP DOWN DETACHABLE CD PLAYER
DSP
BD
FLAT CLASS ROCK POP
TRACK
LOC
LOUD MUTE DISC
RPT
RDM INT
CH
power
LUD
CLK
CDP
SEL
COMPACT
AP
RDM
4
INT
3
RPT
TOP
UP
DN
DIGITAL AUDIO
+
-
2
5
6
1
LO
MU
160WATTS
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM
AUTO-LOADING COMPACT DISC PLAYER
AM/FM STEREO WITH DIGITAL TUNING RADIO
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION
DISC PLAY:
Cleaning discs
Before playing, clean the disc with a clean, lint-free.
Flip the disc in the direction of the arrow.
DASH BOARD
METAL MOUNTING STRAP
HEX NUT
SPRING WASHER
CONSOLE
PLAIN WASHER
PLAIN WASHER
SLIDE BRACKET HOUSING
TAPPING SCREW
HEX BOLT
NOTE:
Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
Insert a disc with the label surface down. Doing so may damage the unit.
Label
surface up
KEY PLATE
PLASTIC TRIM OUT
NOTE:
Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
KEY PLATE
Handle the disc by its edge. And to keep the disc clean, do not touch
the surface.
While installing the front panel,
please mount the left side first,
then push the right side.
Do not stick paper or tape on the disc.
Do not expose the disc to direct sunlight or heat sources such as hot air
ducts. Or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
9
2
Download from Www.Somanuals.com. All Manuals Search And Download.
LOCATION AND FUNCTION OF CONTROLS
SPECIFICATION
GENERAL
1
2
3
8
4
5
6
7
9
Power requirement..............................................................................................DC 13.8V.
Current consumption..............................................................................................7A MAX.
Power output.........................................................................................................40W X 4
OPEN
FM SECTION
FLIP DOWN DETACHABLE CD PLAYER
DSP
BD
FLAT CLASS ROCK POP
TRACK
LOC
LOUD MUTE DISC
RPT
RDM INT
CH
power
LUD
Frequency range.....................................................................87.5MHz -108.0MHz(EUROPE).
Frequency range...........................................................................87.5MHz -107.9MHz(USA).
CLK
CDP
SEL
COMPACT
AP
Usable sensitivity.........................................................................................................3uV.
I.F Frequency........................................................................................................10.7MHz.
RDM
4
INT
3
RPT
TOP
UP
DN
DIGITAL AUDIO
+
-
2
5
6
1
LO
MU
AM(MW) SECTION
Frequency range........................................................................522KHz - 1620KHz(EUROPE).
Frequency range............................................................................. 530KHz - 1710KHz(USA).
10 11
12
13 14 15
LINE - OUT [OPTION]
Output...............................................................................1000mV @ FM 10% THD POWER.
Impedance............................................................................................................600 ohm.
CD PLAYER
1. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTONS
Press SEL button to change the mode in the sequence of
VOL BAS TRE BAL FAD
System........................................................................................compact disc audio system.
Usable disc......................................................................................................compact disc.
Signal format.............................................................................sampling frequency 44.1KHz.
No of quantization bits 1bit.
Frequency characteristics...............................................................................5-40Hz < 5dB
10K-20KHz < 5dB.
1). The volume level can be adjusted at any time by pressing the audio level+ or
- button as select mode has been initially defaulted at volume mode.
2). The volume level is also obtained by stepping through the SEL button until
the character VOL is displayed and then press + or - button to adjust the
sound level.
Signal to noise radio................................................................70dB [1KHz] [IEC - A net work].
Number of channels..............................................................................................2 STEREO.
Chassis dimensions.......................................................................178[W] X 50[H] X 150[D].
3). Press and hold the + or - button to adjust the sound level.
BASS CONTROL
1). Press the SEL button to select the bass mode until BAS appears on the display.
2). Press + or - to adjust the bass effect.
USA
EUROPE
IMPORTANT:
TREBLE CONTROL
This radio is set to USA frequency by factory, if European
frequency is required please flip the frequency step switch on
the side of the unit.
1). Press the SEL button to select the treble mode until TRE appears on the display.
2). Press + or - to adjust the treble effect.
After the switchover of the frequency switch, the frequency convert
function will not be valid until the RESET button has been pressed.
3
8
Download from Www.Somanuals.com. All Manuals Search And Download.
BALANCE CONTROL
TROUBLE SHOOTING
1). Press the SEL button to select the balance mode until BAL appears on LCD.
2). Press the + button or - button to increase or decrease the sound level
of left or right speaker.
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
FADER CONTROL
1). Press the SEL button to select the fader mode until FAD appears on LCD.
2). Press the + button or - button to increase or decrease the sound level
of front or rear speaker.
Symptom
No power
Cause
Solution
The car ignition is not on.
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
2. OPEN BUTTON
The fuse is blown
Replace the fuse
Press it to flip down the front panel when you want to take away.
Press it to flip down the front panel then you can insert a disc into the
slot or eject a disc from the slot by pressing the EJ button which located
the back of the panel.
Presence of CD disc inside
the player
Remove the disc in the player
then put a new upward
Disc cannot
be loaded or
ejected
Inserting the disc in upside
down
Insert the compact disc with
the label facing upward
Compact disc is extremely
dirty or defective
Clean the disc or try to play a
new one
3. LOUD( LOUDNESS) BUTTON
Press "LOUD" to enhance the bass sound effect while reduce the volume
half level .
Temperature inside the
car is too high
Cool off until the ambient
temperature returns to normal
Condensation
Leave the player off for an
hour or so, then try again
4. DSP( DISPLAY) BUTTON
Volume is in minimum
Adjust volume to a desired level
Press it to apply these function, and press it continually to switch
between 4 preset equalizer curves: FLAT POP, CLAS, ROCK.
And the sound quality will be accordingly changed. (FLAT IS INITIAL
DEFAULT)
No sound
Wiring is not properly
connected
Check wiring connection
The operation
keys do not
work
The built-in microcomputer
is not operating properly
due to noise
Press the RESET button
front panel is not properly
fix into its place
5. CLOCK ADJUSTMENT BUTTONS
During RADIO or CD state, press this button to change to clock function.
Hold this button for more than 2 seconds until the time flashes on LCD,
then you can adjust Hours and Minutes by pressing UP and DN button.
After adjustment, press this button to resume normal play state and
remain the adjustment.
The installation angle
is more than 30 degrees
Adjust the installation angle
to less than 30 degrees
Sound skips
The disc is extremely
dirty or defective
Clean the compact disc/try to
play a new one
The radio does
not work
the radio
Insert the antenna cable firmly
select a station manually
The antenna cable is not
connected
the signals are too weak
station
6. LCD ( LIQUID CRYSTAL DISPLAY)
automatic
selection does
not work
7
4
Download from Www.Somanuals.com. All Manuals Search And Download.
14. AS/PS BUTTON
Select 6 strong stations and store them in current band.
Select a band( if needed)
7. CD
( CD PLAY, PAUSE) BUTTON
button to switch to CD mode. At CD mode,
At radio mode, press
press it to pause the CD program and press it again to resume CD
playback.
Hold AS/PS button for more than 3 seconds. The news stations will replace the
stations already stored in that band.
Scan stations in current band
Select a band( if needed).
8. BAND BUTTON
Press AS/PS button for less than 3 seconds. Radio pauses for 5 seconds
at each station. Press AS/PS again to stop scanning when desired stations
is reached.
During CD mode, press it to switch to radio mode.
During radio mode, press it to select your desired radio band and word
which band is selected will be displayed on LCD.
15. [TUNE/SEEK UP] BUTTON and TRACK UP BUTTON
9. POWER BUTTON
Press the button to turn on or off the unit.
1). The frequency scans up by one step when pressing UP button once (50k for
Europe,200k for USA).
Hold it for more than 2 seconds to seek for a station of higher frequency.
10. INFRA-RED RECEIVING WINDOW
2). During CD mode, press UP button allow you to track forwards.
Hold the UP button allow you to skip forwards.
11. LOCAL/DISTANCE BUTTON
Press it for distance reception when you are located at weak signal location,
depress it for a stronger signal.
[TUNE/SEEK DOWN] BUTTON and TRACK DOWN BUTTON
1). The frequency scans down by one step when pressing DN button once(50k
for Europe,200k for USA).
12.PRESET STATION [ 1-6 ] / TOP, RPT, INT,RDM.
A]. To memorize the current frequency, press and any one of the six preset
buttons for more than 2 seconds.
Hold it for more than 2 seconds to seek for a station of lower frequency.
2). During CD mode, press DN button allow you to track backwards.
Hold the DN button allow you to skip backwards.
B]. To recall the preset memory, press one of the preset button [1-6].
C]. TOP BUTTON
Speaker Connection
Press the button during playback to return to the first track of CD.
ANTENNA PLUG
D]. REPEAT BUTTON
Press the button to continuously repeat same track. Press again to
stop repeating.
12 P
YELLOW
E]. INT: Preview all tracks
MEMORY B+
FUSED
FILTER
BOX
0.5A &7A
FUSES
RCA LINE OUT
RED R
Press INT to play first ten seconds of each track on current CD. Press
it again to stop scanning to play your desired track.
BLACK(GND)
WHITE L
RED (B+)
F]. Random button: play all tracks
BLUE AUTO ANT
+
Press it to play all tracks on CD in random order. Press again to stop
random play
+
FRONT
GRAY
WHITE
FRONT
RIGHT
SP
WHITE/BLACK
GRAY/BLACK
VIOLET
LEFT
SP
+
+
GREEN
13. MUTE BUTTON
Press this button to eliminate the sound temporarily and press it again
to resume normal play state.
REAR
REAR
GREEN/BLACK
VIOLET/BLACK
NOTE:
Make sure use a 4-ohm impedance speaker in spite of having any kinds of
speaker system to reduce the distortion during high volume level.
5
6
Download from Www.Somanuals.com. All Manuals Search And Download.
|