4. Release SLEEP button and the current time is once again
displayed. The radio is now on and you can select your station
in the usual way. Play will be for the chosen length of time
(up to 1 hour 59 minutes), and then the radio will turn itself
off. If you decide to turn the radio off sooner, press the
SNOOZE button.
b e f o r e y o u b e g in
f e a t u r e s & u sa g e
o p e r a t in g t h e r a d io
LARGE DISPLAY
AM / FM CLO CK RADIO
1. Plug the power cord into any 120V AC household outlet.
2. Slide the FUNCTION switch to ON to turn on the radio.
3. Slide the AM/FM BAND switch to desired broadcast band.
4. Turn TUNING knob to select a station.
Fo r Yo u r Sa f e t y
AM
Indicator
The AC power plug is polarized (one blade is wider than the
other) and only fits into AC power outlets one way. If the plug
won’t go into the outlet completely, turn the plug over and try
to insert it the other way. If it still won’t fit, contact a qualified
electrician to change the outlet, or use a different one. Do not
attempt to bypass this safety feature.
Volume
Knob
5. Adjust the VOLUME knob to your preferred listening level.
6. To turn the radio off, slide the FUNCTION switch to OFF.
AM/FM
Band
Sw itch
sl e e p t o m u sic a n d w a k e t o m u sic o r a l a r m
You can set your digital clock radio to lull you to sleep, turn itself
off, then awaken you at a preset time - all automatically.
Tuning
Knob
Bu il t -in AFC
Im p o r t a n t Ba t t e r y In f o r m a t io n
1. Set the wake time.
The Built-In Automatic Frequency Control (AFC) works only on
FM. It helps to reduce drift on FM reception and to keep the
radio locked in on the FM station to which it is tuned.
2. Follow the steps under WAKE TO MUSIC or WAKE TO ALARM.
3. Then, proceed with Steps 2 through 4 under SLEEP TO MUSIC.
•
When storing the unit or unplugging it from AC outlet for a
day or more, be sure to remove battery because it can leak
and damage the unit.
WAKE
Indicator
When tuning in FM stations, you may notice that often the
station you desire can be heard on two or three nearby points on
the dial. Always tune carefully to the loudest and clearest point.
•
Batteries may leak electrolyte if inserted incorrectly, if
disposed of in fire, or if an attempt is made to charge a
battery not intended to be recharged.
Sn o o z e Al a r m Op e r a t io n
The Snooze-Alarm button has three functions:
1. It allows extra sleep time after the radio comes on in the
WAKE TO MUSIC mode. Press SNOOZE button to silence the
radio. About 9 minutes later, the radio will play again.
•
•
Discard leaky batteries immediately. Leaking batteries can
cause skin burns or other personal injury.
An t e n n a s
AM Antenna - A built-in ferrite rod antenna eliminates the need
for an outside antenna for AM reception - Rotating the unit
slightly may improve reception of distant AM stations.
Dispose of batteries, according to federal, state, and local
regulations.
FUNCTION Sw itch
On/Off/Music/Alarm
2. It allows extra sleep time in the WAKE TO ALARM mode.
When the alarm sounds, touch the SNOOZE button to silence
the alarm. About 9 minutes later, the alarm will sound again.
You can use the SNOOZE feature repeatedly for up to two
hours, after which the radio or alarm will turn off until the
next day.
TIME SET/
HI•LO Dimmer
Sw itch
FM Antenna - The power cord acts as your FM antenna. The
power cord picks up moderate to strong stations and eliminates
the need for an external antenna in most strong signal areas. Be
sure the power cord is stretched out to its full length. Do not coil
or bunch the cord together. Changing position of the power cord
may improve reception.
Sleep Button
Wake Set/Off
Button
3. It shuts off the sleep cycle. (See SLEEP TO MUSIC).
M in u t e s a n d Se c o n d s Tim e Disp l a y
Se t t in g t h e Tim e
“N o Wo r r y ” Ba t t e r y Ba c k u p
Hour Button
Minute Button
Snooze Button
For a display of time in minutes and seconds:
1. Press and hold the WAKE SET/OFF button.
Your digital clock timer operates on a 12-hour cycle. The AM
indicator on the left side of the display will light up to let you
know if the display is reading AM time.
This clock radio is equipped with a memory holding system that
can be powered with a customer-installed 9-volt alkaline battery
(not included). The power failure protection circuit will not
operate unless battery is installed.
2. While holding down WAKE SET/OFF button, momentarily
press the SLEEP button. The hour digits will display minutes;
the minute digits will display seconds and start to increment.
Release the buttons to return to hour and minute display.
1. Slide the TIME SET/HI• LO Dimmer switch to TIME SET position
and use the HOUR and MINUTE buttons to set the correct
time.
When normal household power is interrupted, or AC line cord is
unplugged, the battery will power the clock radio to keep track
of time and alarm settings programmed into memory. When on
battery power, the digital display will not light; however, should
WAKE TIME occur during the power interruption, the radio will
operate or the alarm will sound if remaining battery power is
adequate. Normal operation will resume after AC power is
restored so you will not have to reset time or alarm.
RP-370 1
a m in d ic a t o r
To indicate the AM time.
2. Slide the switch to HI or LO position to finish the time setting.
a m / f m b a n d sw it c h
To select AM or FM band.
Ca n a d ia n Wa r r a n t y
Se t t in g t h e Wa k e Tim e
1. Press and hold WAKE SET/OFF button. Wake time is displayed.
Thomson Consumer Electronics Canada, Inc. warrants to the
purchaser or gift recipient that if any manufacturing defect
becomes apparent in this product within 1 year from the
original date of purchase, it will be replaced free of charge,
including return transportation.
2. While holding the WAKE SET/OFF button, use the HOUR and
MINUTE buttons to change the display to desired wake-up
time.
Ba t t e r y c o m pa r t m e n t
To store a 9V back up battery.
Install battery as follows:
3. Release WAKE SET/OFF button and the current time is
displayed again. Wake time is set.
FCC In f o r m a t io n
1. Remove battery compartment door (located on the bottom of
the unit) by pressing down on the thumb tab and pulling it
out the cabinet.
v o l u m e k n o b
To adjust the volume.
This warranty does not include damage to the product resulting
from accidents, misuse or leaking batteries.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Wa k e To M u sic o r Wa k e To Al a r m
Should your product not perform properly during the warranty
period, either:
2. Connect a 9-volt battery to battery connector plug.
3. Insert the battery and replace compartment door.
t u n in g k n o b
To select different broadcasting station.
Fo r M u sic
1. Select an AM or FM station.
1. Return it to the selling dealer with proof of purchase
for replacement, or
In accordance with FCC requirements, changes or modifications not
expressly approved by Thomson Consumer Electronics could void the
user’s authority to operate this product.
w a k e in d ic a t o r
To indicate the wake function is activated.
2. Set wake time (See SETTING THE WAKE TIME directions).
2. Remove the batteries (where applicable), and pack product
complete with accessories in the original carton (or equiv
alent).
3. Slide the FUNCTION switch to MUSIC position. (The WAKE
indicator in the display will light.)
This device generates and uses radio frequency (RF) energy, and if not
installed and used properly, this equipment may cause interference to
radio and television reception.
m in u t e / h o u r b u t t o n
To adjust the minute and hour.
4. Adjust the volume to your desired sound level.
— Mail prepaid (with proof of purchase) and insured to:
Thomson Consumer Electronics Canada, Inc
Distribution Centre
If this equipment does cause interference to radio or television reception
(which you can determine by unplugging the unit), try to correct the
interference by one or more of the following measures:
Fo r Al a r m (g r a d -u -w a k e a l a r m )
1. Set the wake time (See SETTING THE WAKE TIME directions).
t im e se t / h i•l o d im m e r sw it c h
TIME SET - to set the correct time.
HI• LO - to control the brightness of the LED display.
•
Reorient the receiving antenna (that is, the antenna for the radio or
television that is “receiving” the interference).
7400 A Bramalea Road
2. Slide the FUNCTION switch to ALARM position. (The WAKE
indicator in the display will light.)
Mississauga, Ontario L5S 1X1
•
•
Move the unit away from the equipment that is receiving interference.
The provisions of this written warranty are in addition to and
not a modification of or subtraction from the statutory
warranties and other rights and remedies contained in any
applicable legislation, and to the extent that any such
provisions purport to dis claim, exclude or limit any such
statutory warranties and other rights and remedies, such
provisions shall be deemed to be amended to the extent
necessary to comply therewith.
The built-in GRAD-U-WAKE alarm system works only on ALARM
mode. It gradually increases the alarm loudness during the first
30 seconds on wake up mode.
Plug the unit into a different wall outlet so that the unit and the
equipment receiving interference are on different branch circuits.
f u n c t io n sw it c h
ON position - to turn on the radio.
OFF position - to turn off all Wake functions and radio.
MUSIC position - to activate the Wake to Radio function.
ALARM position - to activate the Wake to Alarm function.
If these measures do not eliminate the interference, please consult your
dealer or an experienced radio/television technician for additional
suggestions.
NOTE: Alkaline (NEDA 1604A) battery are recommended. Carbon-zinc
battery may be used but memory holding time will be substantially
reduced. Memory holding time for a fresh alkaline battery is
approximately 8 hours (if radio or alarm are not operated), which
should take care of short, nuisance-type AC power failures. To preserve
battery life, the radio should remain plugged into an AC outlet. As the
battery gets older, its voltage drops and memory may be lost. Be sure
to replace the battery periodically.
The alarm tone or radio w ill sound at the w ake time you set and
turn itself off after approximately 2 hours. To turn off the alarm
sooner, set FUNCTION sw itch to OFF or press WAKE SET/OFF
button. When FUNCTION sw itch is left in MUSIC or ALARM w ake
mode, it w ill turn itself on again at the same time the follow ing
day.
sl e e p b u t t o n
If you are unable to find a qualified servicer for out of warranty
service, you may write to:
To turn on the radio and turn itself off automatically at your
desired sleep time. (select any sleep time between 1 minute and
1 hour 59 minutes)
Thomson Consumer Electronics Canada, Inc.
P.O. Box 0944
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Battery should be removed if the radio will be stored for more than
one day.
Sl e e p t o M u sic
You can drift off to sleep to music knowing that the radio will
turn itself off automatically.
T H E L I G H T N I N G CAUTION: TO REDUCE THE
FLASH AND ARROW- RISK OF ELECTRIC SHOCK,
THE EXCLAMATION
POINT WITHIN THE
T R I A N G L E I S
WARNING SIGN
ALERTING YOU OF
w a k e se t / o f f b u t t o n
To set wake time.
To turn off the Wake function during alarm active period.
HEAD WITHIN THE
A
Indianapolis, Indiana, U.S.A., 46206-0944
DO NOT REMOVE COVER
TRIANGLE IS
WA R N I N G S I G N
ALERTING YOU OF
A
( O R B A C K ) . N O U S E R -
SERVICEABLE PARTS IN-
SIDE. REFER SERVICING
TO QUALIFIED SERVICE
PERSONNEL.
Leaky battery can badly damage the clock radio.
I
I
A
T
M
P
T
O
R
M
R
T
T
A
N
N
N
T
S
G
Attach your sales receipt to this booklet for future reference.
This information is required if service is needed during the
warranty period.
WARNING:TO PREVENT FIRE
OR ELECTRICAL SHOCK HAZARD,
DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
"
D
A
N
G
E
R
O
U
S
N
S
U
C
I
O
VOLTAGE" INSIDE
THE PRODUCT.
C
H
C
O
PA
R
N
D
Y
U
I
E
P
O
C
T.
1. Slide the FUNCTION switch to OFF position.
SEE MARKING ON BOTTOM BACK OF PRODUCT
/
2. Press and hold the SLEEP button. The time display will exhibit
0:59. The radio will turn on automatically.
sn o o z e b u t t o n
To turn off the radio or alarm for 9 minutes extra sleep. (up to
2 hours)
To turn off the sleep mode.
Po w e r Fa il u r e In d ic a t o r
PURCHASE DATE ________________________________________
NAME OF STORE ________________________________________
3. While holding SLEEP button, press the MINUTE button and
time will start to count down. Select any sleep time between
59 minutes and 1 minute. For sleep time of more than 59
minutes, up to 1 hour and 59 minutes, momentarily press the
HOUR button (while holding down the SLEEP button). The
display will exhibit 1:59. Then, press MINUTE button to select
the desired amount of sleep in excess 1 hour.
When AC power is interrupted (disconnected) for a short period,
both time and alarm settings will change (unless optional battery
is installed). After AC power is restored (reconnected) the Digital
Display will blink to indicate that power was interrupted and you
must readjust the TIME and ALARM settings. To stop display from
blinking, press and hold the TIME SET or WAKE SET/OFF button
together with the HOUR or MINUTE button.
Model RP-3701
550 077 00 Rev.0 (E/F)
98-52
© 1998 Thomson Consumer Electronics, Inc.
Trademark(s) ® Registered
Marque(s) Déposee(s)
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|