FULL TWO YEAR WARRANTY
3. Never operate this razor if it has a dam-
aged cord or plug, if it is not working prop-
erly, if it has been dropped or damaged, or
dropped into water. Return the razor to an
Authorized Norelco Service Location for
examination and repair.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any
opening.
6. Do not charge or plug in razor outdoors or
operate where aerosol (spray) products
are being used or where oxygen is being
administered.
7. Do not use this razor with a damaged or
broken comb, as facial injury may occur.
8. Always attach plug to razor first, then to
outlet. Be certain that plug is inserted firm-
ly into razor up to mark indicated on plug.
To disconnect, turn razor off, then remove
plug from outlet.
9. To prevent possible damage to the cord, do
not wrap cord around the razor.
Philips Electronics North America Corporation warrants each new Norelco
Product, Model 4807XL/4805XL (except cutters and combs), against defects
in materials or workmanship for a period of two years from the date of pur-
chase, and agrees to repair or replace any defective product without charge.
IMPORTANT: This warranty does not cover damage resulting from
accident, misuse or abuse, lack of reasonable care, the affixing of any
attachment not provided with the product or loss of parts or subjecting
the product to any but the specified voltage.* Use of unauthorized
replacement parts will void this warranty.
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric razor, basic precautions
should always be followed, including the following:
Read all instructions before using this appliance.
4807XL/4805XL
Rechargeable Razor
With Micro Action
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT
PAY FOR WARRANTY SERVICE PERFORMED BY A NON-AUTHO-
RIZED REPAIR SERVICE AND WILL NOT REIMBURSE THE CON-
SUMER FOR DAMAGE RESULTING FROM WARRANTY SERVICE
PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE.
NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL
OR CONSEQUENTIAL DAMAGES.
In order to obtain warranty service, simply take or ship the product
postage prepaid to any Authorized Norelco Service Location. It is sug-
gested that for your protection you return shipments of product by
insured mail, insurance prepaid. Damage occurring during shipment
is not covered by this warranty.
DANGER
To reduce the risk of electric shock:
1. Do not reach for a razor that has fallen into
water. Unplug immediately.
2. Do not use while bathing or in a shower.
3. Do not place or store razor where it can fall
or be pulled into a tub or sink. Do not place
in or drop into water or other liquid.
4. Always unplug this razor from the electrical
outlet immediately after using, except when
razor is (re)charging.
NOTE : No other warranty, written or oral, is authorized by Philips Electronics
North America Corporation.
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state. Some states do not allow the exclu-
sion or limitation of incidental or consequential damages, so the above
exclusion and limitations may not apply to you.
* Read enclosed instructions carefully.
5. Unplug this razor before cleaning.
Manufactured for:
Norelco Consumer Products Company
A Division of Philips Electronics North America Corporation
1010 Washington Blvd.
Stamford, CT 06912-0015
TM
6. When discarding razor, unplug razor and
remove rechargeable batteries. See
enclosed sheet for instructions.
10. Never put razor in direct sunlight or store in
pouch at a temperature above 140°F.
MADE IN HOLLAND.
This symbol on the product’s nameplate means it is listed
by Underwriters’ Laboratories, Inc.
WARNING
SAVE THESE
To reduce the risk of burns, fire, electric
shock, or injury to persons:
If you need help,
Norelco, Lift and Cut, RAZORMATE and
are Registered
answers or service,
please call us at
1-800-243-3050
Trademarks of Philips Electronics North America Corporation.
INSTRUCTIONS
1. Close supervision is necessary when this
razor is used by, on, or near children or the
disabled.
and Micro Action are Trademarks of Philips Electronics North
America Corporation.
IMPORTANT: Your razor contains NICKEL-
CADMIUM RECHARGEABLE BATTERIES.
See enclosed instruction sheet for battery dis-
posal information.
or visit our website:
PHILIPS and Philips Shield are Registered Trademarks of
Philips Electronics N.V.
2. Use this razor for its intended household
use as described in this manual. Do not
use attachments not recommended by
Philips Electronics North America
Corporation.
© 1998 Philips Electronics North America Corporation.
All Rights Reserved.
R
LIFTANDCUT®
PATENTED SHAVING SYSTEM
INGENIOUS MEN’S GROOMING SOLUTIONS
Download from Www.Somanuals.com. All Manuals Search And Download.
1. TO CHARGE
2. CORD/CORDLESS
SHAVING
CORD
3. ADJUSTABILITY
BAND
4. SHAVING
5. POP-OUT
TRIMMER
6. TO CLEAN TRIMMER
7. MAINTENANCE/
CLEANING
INSTRUCTIONS
1. Select position best
suited for your skin and
beard type and which
will give you the most
comfortable shave.
4. Lubricate Trimmer teeth
twice a year with Norelco
Razor Lubricant, model
AL80, or one drop of
mineral oil (Fig. 5).
■ Use only the cord provided.
■ (Re)charge at tempera-
tures between 40°F and
95°F. Charging at lower
or higher temperatures
adversely affects life-
time of batteries.
1. Remove Protective Razor
Head Assembly Guard.
Turn razor ON.
2. Shave against the direc-
tion of beard growth
using a quick, circular
motion.
3. Keep the skin taut using
your fingers to stretch
the skin so blades can
lift and cut whiskers off
(Fig. 2).
4. Easy does it. Gently
press the razor to your
skin so the floating
heads can follow the
contours of your face.
5. Turn razor OFF (and
unplug if shaving with
cord).
1. Switch razor ON.
2. Push Trimmer Slide Switch
up to pop out Trimmer.
3 . H o l d T r i m m e r , a s
shown (Fig. 3), to exact
hairline desired. Move
Trimmer downward with
gentle pressure.
4. Close Trimmer by push-
ing Trimmer Slide Switch
down.
5. Turn razor OFF (and unplug
if shaving with cord).
1. Switch razor OFF (and
unplug if shaving with
cord).
IMPORTANT
1. Connect cord provided
■ Always switch razor
OFF and remove plug
from outlet before
cleaning.
to razor.
2. Push Trimmer Slide
Switch up to pop out
Trimmer.
2. Plug into 100V to 240V
AC/DC outlet.
2. Each position is indicat-
ed by a clicking sound.
Move Adjustability Band
(Fig. 1) on razor clock-
wise for a lower setting
and counterclockwise
for a higher setting.
■ Lowest setting for sen-
sitive skin/soft beard
(#1).
■ Highest setting for not
so sensitive skin/tough
beard (#9).
5. Close Trimmer by push-
ing Trimmer Slide Switch
shown.
3. Slide and depress ON/
OFF switch ON. Begin
shaving.
■ Always store razor with
Protective Plastic Head
Guard on Razor Head
Assembly.
■ Never clean, remove or
replace head assembly
while motor is on.
■ Do not apply pressure
to combs. Do not touch
razor heads with hard
objects as this may dent
or damage precision-
made slotted combs.
■ Do not use razor if
combs are damaged or
broken.
3. Brush out Trimmer sec-
tion using long bristles
of brush (Fig. 4).
1. Slide and depress ON
OFF switch to OFF.
4. Turn razor OFF and un-
plug.
2. Connect cord to razor.
Plug into 100V to 240V
AC/DC outlet.
IMPORTANT: It is not
recommended that this
razor be used exclusively as
a corded razor. Continual
use as a corded razor as
well as continuously charg-
ing razor will reduce life of
batteries.
3. Green Charging Indicator
Light will light to indicate
razor is (re)charging.
4. Charging requires a full 8
hours.
■ (Re)charging longer
than required period of
time will not harm razor.
However, continuously
charging razor will
reduce life of batteries.
■ Choose one setting for
“custom” shaving cheeks/
chin, another “comfort”
setting for neck.
NOTE: Razor does not
recharge during corded
shaving.
IMPORTANT: Clean razor
head regularly following
MAINTENANCE instruc-
tions.
CORDLESS
1. Charge according to
directions. Unplug razor
from outlet.
2. Slide and depress ON/
OFF switch ON. Begin
shaving.
1A.TO RECHARGE
1. Recharging requires 8
hours for approximately
2 weeks of 3 minute
shaves per day.
1
2
3
4
5
2. If razor has not been
used for at least
a
month, razor must be
recharged for a full 8
hours (see TO CHARGE).
Download from Www.Somanuals.com. All Manuals Search And Download.
7. CLEANING INSTRUC-
TIONS (CONT.)
7B.ONCE EVERY 4-8 WEEKS
8. HQ4 REPLACE-
MENT HEADS
9. IMPORTANT
BATTERY
R
7A. ONCE A WEEK
1 . Clean Razor Head Assem-
bly as shown (Fig. 6).
2. Press Razor Head Re-
lease Button and lift
Razor Head Assembly
using thumb and index
finger to remove from
razor housing (Fig. 7).
3. Clean inside of Razor
Head Assembly and
Hair Chamber with long
bristles of brush.
AND RAZOR
DISPOSAL
lease frame and lift out.
Set frame aside (Fig. 8).
a degreasing liquid (e.g.
Norelco Razor Cleaner,
RAZORMATE Electrosonic
Cleaner or alcohol).
IMPORTANT: Do NOT
60-Day Money-Back Guarantee
ACCESSORIES
Replacement Heads:
INFORMATION
interchange the cutters and
To enjoy the closest and most comfortable shave from your new
Norelco Men’s Razor, the razor should be used exclusively for 3
weeks. This allows your hair and skin enough time to adapt to the
Norelco Shaving System. If, after that period of time, you are not
fully satisfied with your Norelco Men’s Razor, send the product back
and we’ll refund you the full purchase price.
3. Remove one cutter/
comb, at a time, out of
frame as shown (Fig. 9).
4. Cutter should be held as
shown and brushed in an
upward motion (Fig. 10).
Clean inside of comb with
long bristles of brush in a
circular motion.
5. For consistently close and
comfortable shaves, razor
heads should be cleaned
and lubricated every 4-8
weeks. Clean heads in
combs. They are a matched
set and if interchanged may
adversely affect shaving
performance until cutters
reseat themselves. Therefore,
remove, clean, and replace
each set individually.
When discarding your razor:
The self-sharpening rotary
blades in your Norelco
razor are precision-made to
give closer shaves. When
they finally do need replac-
ing, specify only Norelco
brand replacement cutters
and combs, model HQ4.
DO NOT USE shaver
sharpeners as this will
damage your blades and
lifters and will adversely
affect the shaving perfor-
mance.
6. While holding Razor
Head Assembly in one
hand, gently place one
cutter/comb back into
Assembly (Fig. 11).
7. Repeat procedure for
other two cutting heads.
8. Replace frame, with
cutting heads in place,
back into Razor Head
Assembly. While press-
ing down, turn wheel
clockwise to lock frame
into place (Fig. 12).
9 . P r e s s R a z o r H e a d
Assembly back on razor
housing.
10. Spread Norelco Razor
Lubricant, model AL80,
or one drop of mineral
oil over floating heads
with your finger.
THIS NORELCO RAZOR
CONTAINS NICKEL-CAD-
The razor must be shipped prepaid by insured mail, insurance
prepaid, and have the sales slip, indicating purchase price and
the date of purchase, enclosed. The razor must be postmarked
no later than 60 days after the date of purchase. Norelco reserves
the right to verify the purchase price of the razor and limit refunds
not to exceed suggested retail price.
MIUM
RECHARGEABLE
BATTERIES WHICH MUST
BE RECYCLED OR DIS-
POSED OF PROPERLY.
1. Remove Razor Head
Assembly (Fig. 7).
2 . While holding Razor
Head Assembly in one
hand, press center wheel
down while turning
counterclockwise to re-
Refer to enclosed instruc-
tion sheet for directions on
removing rechargeable bat-
teries.
Send dated sales slip, your complete name and address as indicated
below, and the razor, prepaid to:
4. Press Razor Head Assem-
bly back on razor hous-
ing.
Norelco Consumer Products Company
A Division of Philips Electronics North America
Corporation
CAUTION:
10
6
8
■ Batteries should be re-
moved by consumer
only when razor is to
be discarded.
■ Make sure razor is un-
plugged before disman-
tling for battery re-
moval.
■ All servicing or battery
replacement should be per-
formed by an Authorized
Norelco Service Location
only.
P.O. Box 1116
Skokie, IL 60076
NOTE: It is recommended
that you replace your razor
heads once a year.
Please allow 4-6 weeks for delivery of check.
Razor Cleaners:
Please Print!
NAME:
Norelco RAZORMATE Electro-
sonic Heads Cleaner, model
ERC100.
Norelco Razor Cleaner,
model RC1776.
Norelco Razor Lubricant,
model AL80.
Norelco Razor Accessories
may be purchased at a store
near you, at an Authorized
Norelco Service Location, or
by using the handy order
form enclosed.
ADDRESS:
CITY:
STATE:
ZIP:
7
9
11
12
TELEPHONE NO.:
(
)
Area Code
REASON FOR RETURNING:
Download from Www.Somanuals.com. All Manuals Search And Download.
|