Perle Systems Cable Box S 4GPT DSFP User Manual

Perle  
Protocol Transparent  
Standalone  
Media Converters  
Installation Guide  
S-4GPT-DSFP  
S-4GPT-DSFP-XT  
Part # 5500334-10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
The default switch settings (all switches in the UP position) will  
work for most installations. See the Operation section of this guide  
for more details.  
The converter comes equipped with a bank of DIP switches and  
set of jumpers for setting configuration.  
The following steps are used to configure the Media Converter.  
1. Set the DIP switch settings (optional).  
2. Insert the SFP modules (purchased separately) into the  
transceiver ports.  
3. Connect the power cord strain relief clip (optional) and  
connect and apply power.  
DIP Switch Settings  
The DIP switches are accessible through the opening in the side  
of the enclosure.  
Link Mode (Switch 1)  
Switch Position Mode  
Up (default)  
Down  
Smart Link Pass-Through Mode  
Standard Mode  
Smart Link Pass-Through: In this mode, the fiber link state on  
one connection is directly reflected through the Media Converter to  
the other fiber connection. Since this media converter is protocol  
independent, it monitors the Signal Detect indicator from the SFP  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
and reflects this on the TX port of the other SFP by turning off the  
transmitter. When the signal (Link) gets restored and Signal  
Detector becomes active the affected transmitter gets re-enabled.  
Standard Mode: In Standard Mode the media converter will  
monitor the fiber link in the same manner. If Signal Detect goes  
down the media converter will output a 25MHz signal on the TX  
port of the other SFP.  
Fiber Fault Alert (Switch 2)  
Switch Position Mode  
Up (default)  
Down  
Enabled  
Disabled  
Enabled: If the media converter detects a loss of fiber signal on its  
fiber receiver, it will disable its fiber transmitter on the same SFP.  
This, in effect, notifies the fiber link partner that an error condition  
exists on the fiber connection.  
Disabled: The Protocol Transparent Media Converter will not  
monitor for Fiber Fault.  
Rate Select (Switch 3)  
Switch Position Mode  
Up (default)  
Down  
High Speed  
Low Speed  
High Speed – When a multi-rated SFP is inserted, it is enabled for  
its higher speed of operation.  
Slow Speed – When a multi-rated SFP is inserted, it is enabled  
for its slower speed of operation.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Attaching the Power Cord Strain Relief  
Clip  
For extra power cable strain relief, attach the strain clip to the side  
of the unit, then thread the power cable through the clip in either  
one or two loops.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Operation  
Powering up the Perle Media Converter  
1. Connect the Perle supplied power adapter to the media  
converter.  
2. Turn on the power at the source.  
3. Check that the PWR LED light is lit.  
Terminal Block Connector  
1. Ensure the Power Source is off prior to connection.  
2. Strip insulator sheathing from both wires 5mm (3/16th  
inch) to expose the copper conductor wire.  
3. Loosen the terminal block screws and connect Positive (+)  
wire to the left terminal. Connect the Negative (-) wire to  
the right terminal. Tighten Terminal screws (0.22Nm-  
0.25Nm torque).  
4. Turn on power source.  
5. Check that the PWR LED light is lit.  
Status LED  
There are three status LEDs located on the front of the unit.  
PWR  
On – Power is applied to the unit  
Blinking Fast – Hardware Error  
LK1  
On – Signal Detected  
Off – No Signal Detected  
LK2  
On – Signal Detected  
Off – No Signal Detected  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Technical Specifications  
Extended  
Temperature  
Max Power Input  
Commercial  
Consumption  
6-30 VDC 0.625A  
Max  
325mA at 12VDC 325mA at 12VDC  
Operating  
0°C - 50°C  
-40°C - 75°C  
Temperature  
(32°F - 122°F)  
(-40°F - 167°F)  
-25°C - 70°C  
(-13°F - 158°F)  
-40°C - 85°C  
(-40°F - 158°F)  
Storage Temperature  
Operating Humidity  
Storage Humidity  
Operating Altitude  
5% to 90% non-condensing  
5% to 95% non-condensing  
Up to 3,048 m (10,000 ft)  
Note: Please refer the product page on the Perle website for the  
most up to date models and specifications.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Compliance Information  
EMI/EMC  
EN 55022/CISPR22  
EN 55022/CISPR22  
FCC  
This product has been found to comply with the limits for a Class A digital device,  
pursuant to Part 15 of the FCC rules. These limits are designed to provide  
reasonable protection against harmful interference when the equipment is operated  
in a commercial environment. This equipment generates, uses, and can radiate  
radio frequency energy and, if not installed and used in accordance with the  
instructions in this Guide, may cause harmful interference to radio communications.  
Operation of this equipment in a residential area is likely to cause harmful  
interference, in which case the user will be required to correct the interference at  
his/her own expense.  
Safety  
IEC 60950-1 2nd edition  
UL 60950-1 CAN/CSA STD C22.2 No 60950-1  
Warning: If this unit is to be installed in a location where the  
ambient temperature exceeds 50C, the case temperature may  
exceed safe levels. For this reason, this unit should installed in a  
restricted access location.  
Warranty / Registration  
Perle’s standard Lifetime Warranty provides customers with return  
to factory repairs for Perle products that fail under the conditions of  
the warranty coverage. Details can be found at:  
Contacting Technical Support  
Contact information for the Perle Technical Assistance Center  
(PTAC) can be found at the link below. A Technical Support Query  
may be made via this web page.  
www.perle.com/support_services/support_request.shtml  
Copyright© 2013 Perle Systems Limited  
All rights reserved. No part of this document may be reproduced or used in any form  
without written permission from Perle Systems.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  

Philips Digital Camera SPC315NC User Manual
Philips Flat Panel Television WACS7500 37 User Manual
Philips Iron GC4440 User Manual
Philips Power Hammer 32PFL7623 User Manual
Philips Universal Remote REM400 User Manual
Pioneer Indoor Furnishings KRP TS02 User Manual
Planar Car Video System PE1700 User Manual
Planon System Solutions Scanner R705 User Manual
Polk Audio Home Theater System 255C LS User Manual
Porter Cable Computer Hardware P5KPL VM User Manual