32-1222.fm Page 1 Tuesday, July 6, 1999 4:03 PM
Cat. No. 32-1222
OWNER’S MANUAL
Please read before using this equipment.
2-Channel 170-MHz Wireless
FM Microphone System
Download from Www.Somanuals.com. All Manuals Search And Download.
32-1222.fm Page 3 Tuesday, July 6, 1999 4:03 PM
Cautions:
FCC NOTICE
• Use only fresh batteries of the
required size and recommended
type.
This wireless microphone system com-
plies with Part 90 of FCC Rules. There
are two frequencies available for the
system. You must get a license for
each frequency you plan to use before
you use the system (one license can in-
clude both frequencies). Licensability
depends on how you will use the sys-
tem.
• Do not mix old and new batteries,
different types of batteries (stan-
dard, alkaline, or rechargeable), or
rechargeable batteries of different
capacities.
Follow these steps to install each bat-
tery.
Look in your local phone book for the
nearest FCC office and contact them
to get the necessary application.
1. While holding the microphone’s
handle, carefully unscrew the wind-
screen far enough to remove the
battery door.
SETTING UP THE
SYSTEM
Battery Door
Your system has two channels for
transmitting. Each microphone has a
sticker with a letter on it to help you
determine which microphone is which.
Microphone 1 (MIC 1) is marked A, D,
or B. Microphone 2 (MIC 2) is marked
E, G, or H. You can combine up to
three separate systems so you can
use up to six microphones together
(each with a different frequency).
Windscreen
2. Install the battery into the battery
compartment on top of the ribbon,
being sure the + and – terminals
touch the appropriate contacts as
marked inside the compartment.
Be sure to firmly press the battery
in place.
Installing the Transmitter’s
Battery
®
Cat.
No.3
2-1222
FC
C
ID
:
AA
O
3
2
0
1
2
2
2
TWO-C
HANNEL
MICROP
1
7
0
M
H
z
WIRELES
S
FM
HONE
S
S
Y
S
T
E
M
POWER
S
U
P
P
L
Y
:
1
X
"9V"
B
A
T
T
.
CUSTOMMANUFACTURED
IN
CHINA
FOR
RADIOSHACK,
FORTWORTH,
A
DIVISION
OF
T
A
N
D
Y
C
O
R
P
O
R
A
T
I
O
N
,
TEXAS76102
Each microphone transmitter requires
a 9-volt battery (not supplied) for pow-
er. For the best performance and
longest life, we recommend an alka-
line battery, available at your local Ra-
dioShack store.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
32-1222.fm Page 4 Tuesday, July 6, 1999 4:03 PM
3. Replace the battery compartment
cover and tighten the windscreen.
To use the AUDIO jack, connect a
shielded audio cable’s mono /4-inch
1
phone plug to the receiver’s AUDIO
jack. Connect the other end to a mi-
crophone-level input on your amplifier,
mixer, or tape recorder.
If the battery power is low, the red
BATT LOW indicator lights when the
microphone’s switch is set to ON or
STBY (standby). Replace the battery.
A
Connecting the Power
Adapter
The receiver operates from standard
AC power, using the supplied 12-volt
DC power adapter.
Warning: Dispose of old batteries
promptly and properly. Never burn or
bury them.
Cautions:
• Use only the supplied adapter. If
you lose or damage this adapter,
order a replacement from your
local RadioShack store. Using
other adapters could damage the
receiver.
Caution: If you do not plan to use the
microphone for a week or more, re-
move the battery. Batteries can leak
chemicals that can damage electronic
parts.
• Always plug the adapter into the
receiver before you plug it into the
AC outlet. Always unplug the
adapter from the outlet before you
unplug it from the receiver.
Connecting the Receiver to
an Amplifier, Mixer, or Tape
Recorder
1. Turn off the receiver by pressing
POWER until the button is in the
outmost (off) position.
Connect the receiver to an amplifier,
mixer, or tape recorder using either
the receiver’s LINE or AUDIO output
jack.
2. Plug the adapter’s barrel plug into
the receiver’s DC 12V jack, then
route the cord through the strain
relief.
To use the LINE jack, connect a
shielded audio cable’s phono plug to
the receiver’s LINE jack. Connect the
other end to a line-level input on your
amplifier, mixer, or tape recorder.
A
UDIO
DC
12V
100mA
(MAX)
Strain Relief
4
Download from Www.Somanuals.com. All Manuals Search And Download.
32-1222.fm Page 5 Tuesday, July 6, 1999 4:03 PM
3. Plug the adapter into a standard
AC outlet.
MIC 1 indicator lights. If your
microphone is marked E, G, or H,
the MIC 2 indicator lights.
6. If you are using a separate audio
source (such as a tape deck or
CD player) with your audio sys-
tem, turn on the audio source and
adjust the receiver’s MIC VOLUME
controls for the best volume and
balance.
OPERATION
Note: Leave the microphone’s slide
switch set to STBY or ON whenever
the receiver is on. This keeps the sys-
tem from producing a loud hiss.
Note: For the best results, experiment
with the receiver’s MIC VOLUME set-
tings and the volume settings of other
components in your audio system. If
you are using a source that has a vari-
able output control, such as a musical
instrument, be sure you adjust the vol-
ume with the instrument at the highest
level you intend to use.
2
E
M
U
L
VO
IC
M
1
ER
IV
E
C
E
MAX
R
2
SS
E
IC
L
E
R
1
M
WI
C
L
I
M
OFF
A
N
O
ESSI
F
O
MAX
R
L
E
P
N
N
A
H
C
OFF
2
ER
W
PO
1. Fullyextendthereceiver’santenna.
2. Turn on your tape recorder, ampli-
fier, mixing board, and other nec-
essary audio components. Set
their volume controls (or input level
controls) to moderate settings.
Using the Standby Setting
The microphone transmitter’s STBY
setting lets you turn off the micro-
phone without turning off its transmit-
ter. If you move the switch from OFF to
STBY or ON, you will hear a loud pop.
Use the STBY setting to avoid this
sound. There should be virtually no
sound when you slide the switch from
STBY to ON.
3. If you plan to use both wireless
microphones, turn both the
receiver’s MIC VOLUME controls
clockwise until they click on. (If
you plan to use only one micro-
phone, turn on only the appropri-
ate control.) Position each control
at its lowest setting.
4. Press POWER to turn on the
receiver. Thepowerindicatorlights.
If you set the switch to OFF while your
audio system is on, there may be a
loud hiss. There is no hiss when you
set the switch to STBY.
5. Set the microphone transmitter’s
slide switch to STBY or ON. The
receiver’s MIC 1 or MIC 2 indicator
lights, depending on which micro-
phone you turn on. If your micro-
phone is marked A, D, or C, the
To conserve battery power, be sure to
set the switch to OFF when you finish
using the microphone transmitter.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
32-1222.fm Page 6 Tuesday, July 6, 1999 4:03 PM
CARE AND MAINTENANCE
Your Optimus 2-Channel 170 MHz Wireless FM Microphone System is an example
of superior design and craftsmanship. The following suggestions will help you care
for your system so you can enjoy it for years.
Keep the system dry. If it gets wet, wipe it dry immediately. Liquids
might contain minerals that can corrode the electronic circuits.
Use and store the system only in normal temperature environments.
Temperature extremes can shorten the life of electronic devices, dam-
age batteries, and distort or melt plastic parts.
Keep the system away from dust and dirt, which can cause premature
wear of parts.
Handle the system gently and carefully. Dropping it can damage circuit
boards and cases and can cause the system to work improperly.
Use only fresh batteries of the required size and recommended type.
Batteries can leak chemicals that damage your system’s electronic
parts.
Wipe the system with a damp cloth occasionally to keep it looking new.
Do not use harsh chemicals, cleaning solvents, or strong detergents to
clean the system.
Modifying or tampering with the system’s internal components can cause a mal-
function and might invalidate its warranty and void your FCC authorization to oper-
ate it. If your system is not performing as it should, take it to your local RadioShack
store for assistance.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
32-1222.fm Page 7 Tuesday, July 6, 1999 4:03 PM
SPECIFICATIONS
Transmitter
Sensitivity:
Microphone Input ................................................................. 100 dB SPL ±5 dB
Frequency Response ......................................................................... 100–8,000 Hz
RF Output Power .......................................................................................... 18 mW
(Terminated at 50 Ohm Load)
Current Consumption ................................................................... 38 mA (Average)
Battery Life (Alkaline) ................................................................. 8 Hours (Average)
Operating Frequencies:
Groups
Microphone 1
Microphone 2
1
2
3
A — 169.445 MHz
D — 170.305 MHz
B — 169.505 MHz
E — 171.045 MHz
G — 171.845 MHz
H — 171.905 MHz
Receiver
Sensitivity ......................................................................... 2 µV (with S/N @ 20 dB)
S/N Ratio (@ 1mV Input) ........................................................... 82 dB, A-Weighted
Output Power:
LINE ...................................................................................................... 250 mV
AUDIO ..................................................................................................... 16 mV
Total Harmonic Distortion .................................................................. 1.0% (Typical)
Power Requirements .............................................................. 12 Volts DC, 100 mA
Operating Frequencies:
Groups
Microphone 1
Microphone 2
1
2
3
A — 169.445 MHz
D — 170.305 MHz
B — 169.505 MHz
E — 171.045 MHz
G — 171.845 MHz
H — 171.905 MHz
Specifications are typical; individual units might vary. Specifications are subject to
change and improvement without notice.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
32-1222.fm Page 8 Tuesday, July 6, 1999 4:03 PM
Limited One-Year Warranty
This product is warranted by RadioShack against manufacturing defects in material and workman-
ship under normal use for one (1) year from the date of purchase from RadioShack company-owned
stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, Ra-
dioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED
IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED
HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RE-
SPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY
LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFOR-
MANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, IN-
CLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS
OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDEN-
TAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of in-
cidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack
sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un-
less otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase
price. All replaced parts and products, and products on which a refund is made, become the prop-
erty of RadioShack. New or reconditioned parts and products may be used in the performance of
warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the
expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,
accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs
of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/99
We Service What We Sell
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
811081800A
Printed in China
07A99
Download from Www.Somanuals.com. All Manuals Search And Download.
|