E
n
7.1ch Home Theater Speaker Package
HTP-980
Front speakers (SKF-980)
Surround speakers (SKR-980)
Surround back speakers (SKB-980)
Center speaker (SKC-980)
Powered subwoofer (SKW-980)
RCA cable 10 ft. (3.0 m)
(Green)
(White)
(Red)
(Blue)
(Gray)
Center speaker*1
Speaker cable 10 ft.
(3.0 m)
Surround speakers*2
Speaker cables 11 ft.
(3.5 m)
Front speakers*1
Subwoofer*2
*2
Non-magnetic shielding.
(Brown)
(Tan)
■ Front
*1
*2
For magnetic shielding.
Non-magnetic shielding.
Speaker cables 26 ft. (8.0 m)
Standby/On indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
Cork spacer (12 pcs.) for front and
center speakers
Surround back speakers*2
With the Auto Standby function, the
SKW-980 automatically turns on when
an input signal is detected in Standby
mode. When there’s no input signal for
a while, the SKW-980 automatically
enters Standby mode.
Speakerterminals
Keyhole slot
Keyhole slot
■ Rear
Speaker
terminals
SKC-980
Speaker
OUTPUT LEVEL control
This control is used to adjust the vol-
terminals
SKR-980/SKB-980
Keyhole slots
SKF-980
ume of the subwoofer.
LINE INPUT
Wall Mounting
This RCA input should be connected to
the subwoofer pre out on your AV
receiver with supplied RCA cable.
To AC outlet
To mount the front/surround/surround back speakers
vertically, use the keyhole slot shown to hang each
speaker on a screw that’s securely screwed into the
wall.
To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two
screws that are securely screwed into the wall.
Caution
• A mounting screw’s ability to support a speaker
depends on how well it’s anchored to the wall. If you
have hollow walls, screw each mounting screw into a
stud. If there are no studs, or the walls are solid, use
suitable wall anchors. Use screws with a head diameter
of 5/16" (9 mm) or less and a shank diameter of 1/8"
(4 mm) or less. With hollow walls, use a cable/pipe
detector to check for any power cables or water pipes
before making any holes.
Wall
Caution
• The front grille is not designed to be removed so does not attempt
to remove it forcibly, as this will damage it.
Keyhole slots for wall mounting
Note
Keyhole slots for
wall mounting
3/16" to 7/16"
(5 to 10 mm)
• The Auto Standby function turns the subwoofer on when the input signal
exceeds a certain level. If the Auto Standby function does not work reli-
ably, try slightly increasing or decreasing the subwoofer output level on
your receiver.
SKC-980
10-1/4" (260 mm)
• Leave a gap of between 3/16" (5 mm) and 7/16" (10 mm) between the
wall and the base of the screw head, as shown. (We recommend that you
consult a home installation professional.)
• If the Standby/On indicator lights (both red and blue LEDs) several sec-
onds or minutes after the sound output stopped, this means that the amp
protection circuit has been activated. In this case, set the OUTPUT LEVEL
control to the center position, and disconnect the power cord from the AC
outlet. Wait at least 10 seconds, and then reconnect the power cord. If that
doesn’t solve the issue, contact your Onkyo dealer.
SKF-980
SKR-980/SKB-980
Using the Cork Spacers for a More Stable Platform
We recommend using the supplied cork spacers to achieve the best possible
sound from your speakers. The cork spacers prevent the speakers from mov-
ing, providing a more stable platform.
Setting the Subwoofer Level
■ Attaching and detaching the speaker grilles
The front, center, surround and
surround back speakers have
detachable grilles.
Make sure the SKW-980 subwoofer’s output
level control is set at the “THX-POSITION”.
You can then adjust the level as needed.
Removal
Replacement
Cork spacers
See the right illustrations to attach
or detach them.
Bottom of the
SKF-980
Bottom of the SKC-980
Cork spacers
Enjoying Home Theater
Specifications
The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in
a movie theater or concert hall.
■ Powered Subwoofer (SKW-980)
■ Center Speaker (SKC-980)
Type
Acoustic suspension
Type
Impedance
2 Way Acoustic suspension
8 Ω
Rated output power
125 watts minimum continuous power,
6 ohms, driven at 100 Hz with a
maximum total harmonic distortion of
1 %
abFront left and right speakers (SKF-980)
f
ab c
Maximum input power
Sensitivity
130 W
They should be positioned facing the listener at about ear level, and equally
spaced from the TV. Angle them inward slightly so as to create a triangle, with
the listener at the apex.
83 dB/W/m
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D)
50 Hz to 45 kHz
2 kHz
Input sensitivity/impedance 330 mV / 100 kΩ
c
Center speaker (SKC-980)
Frequency response
Cabinet capacity
20 Hz to 100 Hz
Position it close to your TV (preferably on top) facing forward at about ear
level, or at the same height as the front left and right speakers.
deSurround left and right speakers (SKR-980)
Position them at the sides of the listener, or slightly behind, about 2 to 3 feet
(60 to 100 cm) above ear level. Ideally they should be equally spaced from the
listener.
7.5 L (0.265 cubic feet)
49 L (1.73 cubic feet)
433 mm × 158 mm × 199 mm
(17-1/16" × 6-1/4" × 7-13/16")
(incl. grille and projection)
Dimensions (W × H × D)
380 mm × 444 mm × 429 mm
(14-15/16" × 17-1/2" × 16-7/8")
(incl. grille and projection)
Weight
5.3 kg (11.7 lbs.)
Weight
15.5 kg (34.2 lbs.)
30 cm (12") Cone Woofer
AC 120V, 60 Hz
140 W
Drivers unit
12 cm (5") A-OMF Cone Woofer × 2
2.5 cm (1") Soft Dome Tweeter × 1
Drivers unit
Power supply
Power consumption
Other
f
Subwoofer (SKW-980)
Terminal
Other
Binding post (Banana type supported)
Magnetic shielding
Corner
position
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)
channel. The volume and quality of the bass output from your subwoofer will
depend on its position, the shape of your listening room, and your listening
position. In general, a good bass sound can be obtained by installing the sub-
woofer in a front corner, or at one-third the way along the front wall, as shown.
1/3 of wall
position
Auto Standby function
■ Front Speakers (SKF-980)
■ Surround and Surround Back Speakers
(SKR-980/SKB-980)
ghSurround back left and right speakers (SKB-980)
These speakers further enhance the realism of surround sound and improve
sound localization behind the listener.
de gh
Type
2 Way Acoustic suspension
Impedance
8 Ω
Type
Impedance
2 Way Acoustic suspension
8 Ω
Maximum input power
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D)
130 W
Position them behind the listener about 2 to 3 feet (60 to 100 cm) above ear
level.
83 dB/W/m
50 Hz to 45 kHz
2 kHz
Maximum input power
Sensitivity
130 W
81 dB/W/m
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D)
50 Hz to 45 kHz
2 kHz
7.5 L (0.265 cubic feet)
Connecting the Speakers
158 mm × 433 mm × 199 mm
(6-1/4" × 17-1/16" × 7-13/16")
(incl. grille and projection)
4.6 L (0.163 cubic feet)
200 mm × 275 mm × 169 mm
(7-7/8" × 10-13/16" × 6-5/8")
(incl. grille and projection)
Surround
back left
speaker
Surround
back right
speaker
Surround
left
speaker
Surround
right
speaker
Weight
5.3 kg (11.7 lbs.)
Front left Front right
speaker speaker
Drivers unit
12 cm (5") A-OMF Cone Woofer × 2
2.5 cm (1") Soft Dome Tweeter × 1
Weight
3.5 kg (7.7 lbs.)
Drivers unit
13 cm (5-1/8") A-OMF Cone Woofer × 1
2.5 cm (1") Soft Dome Tweeter × 1
Terminal
Other
Binding post (Banana type supported)
Magnetic shielding
Terminal
Binding post (Banana type supported)
Specifications and appearance are subject to change without
prior notice.
Speaker Connection
Precautions
Brown
Tan
Blue
Gray
THX and the THX logo are trademarks of THX Ltd. which are regis-
tered in some jurisdictions. All rights reserved.
Read the following before connecting your
speakers:
White
Red
• Turn off your receiver before making any
connections.
• Pay close attention to speaker
wiring polarity. Connect posi-
tive (+) terminals to only pos-
itive (+) terminals, and
negative (–) terminals to only negative (–)
terminals. If the speakers are wired incor-
rectly, the sound will be out of phase and
will sound unnatural.
Center speaker
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN
Tel: 072-831-8023 Fax: 072-831-8163
ONKYO U.S.A. CORPORATION
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.
Green
ONKYO EUROPE ELECTRONICS GmbH
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY
Powered
subwoofer
ONKYO EUROPE ELECTRONICS GmbH (UK BRANCH)
The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK
Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700
• Be careful not to short the positive and
negative wires. Doing so may damage
your amp.
ONKYO CHINA LIMITED
Note
Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung,
N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039
• When you connect the front high left and right
speakers, prepare for it separately, or use the
surround back left and right speakers.
Y1005-1
SN 29400481
(C) Copyright 2010 ONKYO CORPORATION Japan. All rights reserved.
* 2 9 4 0 0 4 8 1 *
Download from Www.Somanuals.com. All Manuals Search And Download.
|