Installing the
RVL-6 RMP
A
A
Step 1
Step 2
CAUTION! Unit must
be unplugged before
cover is removed
B
A
A
C: Unplug the ribbon
connector, pull away
from the front panel
C
B
D
A: Remove screws from
the RVL-6 chassis
D
D: Remove screws from
the bottom of the
A
D
front panel and
B: Raise the cover off
detach from chassis
A
D
of the unit
Step 3
Step 4
F
E: Slide out the plastic
F: Pull the circuit
board away from the
front panel
retainer
F
E
Step 5
Step 6
G
G: Gently line up and
place circuit board
with the rack-mount
panel
H: Slide the plastic
retainer back into
place
H
G
L
Step 7
Step 8
K
L
L
L
I: Plug in the ribbon
K: Replace the cover
K
connector
onto the unit
I
J
J: Replace the screws
to the bottom of the
rack-mount panel
L: Replace the screws
to the RVL-6 cover
J
L
J
L
J
Niles Audio Corporation 12331 SW 130th Street Miami, Florida 33186 Tel: (305) 238-4373 Fax: (305) 238-0185
© 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the right to
change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in the USA 5/96
Download from Www.Somanuals.com. All Manuals Search And Download.
|